最后校验用英语怎么说，最后校验的英文翻译

词语导航

基本信息

词语：最后校验

繁体：最後校驗

拼音：zuì hòu xiào yàn

英语翻译

【化】 terminal check

分词翻译

最后的英语翻译：

finally; last; at length; eventually; in conclusion; in the end
【医】 ultimum

校验的英语翻译：

【计】 verify

翻译例句

1. 《看这个人》，校验，尼采在都灵，最后读的。

Let"s consult the proofs of Ecce Homo, one of the last documents Nietzsche read in Turin.

2. 2块或更多的设备配置成RAID0，第三块或最后一块设备是校验设备。Www.WeNtIYi.CoM

Two or more devices are configured in a RAID 0 setup, while the third (or last) device is a parity device.

3. 校验位是附在字节最后的一个额外的位，其目的是为了检验其精确性。

A check bit is an extra bit attached to the end of a byte for purposes of checking for accuracy.

4. 最后，给出在83 %FP以下的功率运行下进行主蒸汽安全阀定值校验试验的窗口安排与注意事项。

Finally, scheduling and precautions for verification tests of the calibration pressure of main steam safety valve under 83 % FP power level are given.

5. 最后会加进如请求验证、安全GateKeepers与数据校验等约束。

Finally, constraints are applied such as request throttles, security GateKeepers and data validation.

6. 最后，给出了一个并行自动校验系统实例，包括系统硬件构成、软件设计，提高了物资编码校验的速度和准确性。

Finally, it offers an example on parallel auto-checkout system, including hardware structure, software design of the system, which increases speed and veracity of material coding checkout.

7. 最后，在知识与规则的基础上，设计了城市管线数据校验的模型，并以应用实例对此模型进行了验证。

Finally, on the basis of the knowledge and rule, the paper designs checking model for urban pipe-line data, moreover, it introduces the realization of this checking by using many successful instances.

8. 最后讨论了工程实践中常遇到的通讯方式方法的选择、初始化、校验和数据的保存方法。

Problems about the selection of the communication mode, data save, the initialization and the verification, were also discussed.

9. 最后，我们提出了基于邻域颜色距的校验，以提高整个检测算法的稳健性。

Finally, we present a scratch verification method based on neighborhood color distance to improve the robustness of the system.

10. 最后通过计算分析，校验说明该车体结构设计合理，满足了机车总体布置和国家相关标准对机车静强度的要求。

The computation analysis shows that the car body structure design is reasonable and meets the locomotive general (arrangement) and relevant national standards for (locomotive) static strength.

11. 最后，提出了三种方法对模型进行校验，分别是指标对比法、参数对比法、曲线拟合法。

Finally, three methods have been proposed for model calibration, namely, index comparison, parameter comparison and curve fitting.

12. 最后一条配置命令下发15分钟后，如果没有校验配置，就上报配置没有校验的警告。

Not-verifying warn should be submitted if there are no verification of configuration 15 minutes after last configured command is delivered downwards.

13. 最后对校验方法的实现过程进行了仿真与实测，验证了方法的性能及效率。为便携式智能化校验装置的研制提供了强有力的理论支持。

It shows that the performance and efficiency of new calibration method is satisfied. It will provide the powerful theory support for the development of portable intelligent calibration equipment.

14. 同时建立该沼气池的传热数字模型，获得了模型的数值解，实验结果和计算结果相互校验，最后整理得出了池温的分布规律。

The heat transfer mathematic model for solar marsh gas pit was set up based on the test results. It is shown that the good agreement between the numerical solutions and experiment data.

15. 同时建立该沼气池的传热数字模型，获得了模型的数值解，实验结果和计算结果相互校验，最后整理得出了池温的分布规律。

The heat transfer mathematic model for solar marsh gas pit was set up based on the test results. It is shown that the good agreement between the numerical solutions and experiment data.