聚胶用英语怎么说,聚胶的英文翻译


词语导航

基本信息

词语:聚胶

繁体:聚膠

拼音:jù jiāo

英语翻译

【建】 coagel

分词翻译

聚的英语翻译:

assemble; gather
【建】 poly-

胶的英语翻译:

glue; gluey; mucus; pastern; sticky
【医】 gloea; glue

翻译例句

1. 人造板工业使用的三大胶是脲醛树脂胶、酚醛树脂胶和三聚氰胺-甲醛树脂胶。

The three main adhesives for artificial plate are urea-formaldehyde resin adhesive, phenolic-formaldehyde resin adhesive and melamine-formaldehyde resin adhensive.

2. 结果表明,在聚苯颗粒保温浆料中胶粉料材料组成不同、采用的聚苯颗粒不同,对聚苯颗粒保温浆料的性能有很大的影响。

The result shows that different mineral binder composition and different EPS grain have great influence on performance of EPS thermal insulation mortar.

3. 环氧树脂是聚硫密封胶常用的增粘剂,在聚硫密封胶中加入环氧树脂可以起到明显的增粘作用。

Epoxy resin is the common tackifier for polysulfide sealant. Adding epoxy resin into polysulfide sealant can exert an auxiliary effect on viscosity increasing.

4. 烷基烯酮二聚体(akd)的中(碱)性施胶系统中,腐浆及沉积物的产生和积累是产生纸张脏点、破洞,甚至引起断头等质量问题的主要原因。

Formation and accumulation of slimes and deposits are the major reasons inducing paper quality problems such as dirty spots, broken holes, and even cause the broken of paper in AKD sizing system.

5. 任一种白色的晶体酸,化学式为COOH (CH2)8cooh,用于生产某些合成胶、纤维多种增塑剂和聚脂橡胶。

A white crystalline acid, COOH (CH2) 8cooh, used in the manufacture of certain synthetic resins and fibers, various plasticizers, and polyester rubbers.

6. 探讨炭黑种类及用量对天然橡胶(NR)和溶聚丁苯橡胶(s -SBR)硫化胶的耐屈挠破坏性及动态力学性能的影响。

The effects of kinds and dosage of carbon black on bending destroyed durability and dynamic properties of NR and S-SBR vulcanizates were discussed.

7. 以聚偏氟乙烯(PVDF)为第二组分聚合物与三醋酸纤维素(CTA)共混,通过冻胶法纺丝工艺制备成中空纤维纳滤膜。

Hollow fiber NF membrane was prepared with blending of PVDF as the second component polymer and CTA, and by spinning process with gelation method.

8. 探讨了烷氧基硅烷封端率及端羟基聚丁二烯的含量对单组分密封胶的力学性能、硬度及表干时间的影响。WWW.WeNtIYI.Com

The effects of different silane end-capped ratios and HTPB content on mechanical properties, hardness and surface dry time of the sealant were discussed.

9. 液态聚硫橡胶增韧的环氧树脂胶表现出良好的抗冲击性能和抗弯曲性能;

Epoxy resin toughened by liquid polysulfide rubber exhibits good anti-impact performance and anti-bend performance.

10. 研究不同门尼粘度的集成橡胶(SIBR)混炼胶和硫化胶的各项性能,并与溶聚丁苯橡胶(SSBR1204)进行对比。

The effect of raw SIBR Mooney viscosity on the properties of mix and vulcanizate was investigated and compared to that of SSBR1204.

11. 本工作研究了1,2-聚丁二烯(PB)与天然橡胶(NR)等量并用的共混胶的性能。

The properties of the blends of 1,2-polybutadiene ( PB ) and natural rubber ( NR ) at equal loading were studied.

12. 用热机械分析(TMA)方法研究了三聚氰胺-尿素-甲醛树脂固化初期胶层粘度的变化。

Viscosity change of melamine urea formaldehyde glue line was investigated with a thermo mechanical analyzer (TMA) used as a parallel plates rheometer.

13. 本文是在实验室条件下,探索三聚氰胺树脂胶胶结此种复合板工艺的工艺技术。

This essay explore the making processing of this composite board with melamine resin under lab conditions.

14. 主要阐述了聚硫密封胶的构成、生产工艺、固化机理、性能特点及应用情况。

This article introduced mainly the composition, the production process, the curing mechanism, the characteristics and the application situation of the polysulfide sealant.

15. 聚苯颗粒保温料浆是由聚苯颗粒和保温胶粉料分别按配比包装组成。

Polystyrene particles insulation pulp by polystyrene particles and heat preservation is powder materials separately according to ratio of packing.

16. 有关等位基因的相关信息从PAGE胶上获得,聚类图构建的数据则来源于琼脂糖凝胶电泳。

The dendrogram was constructed from the agarose gel data, while the information of alleles was from PAGE gel.

17. 结果表明,预先将聚脂短纤维和EPDM混炼制成母炼胶,然后再与PP共混进行动态硫化制备的复合材料的性能最佳。

The results showed that the blending method of premixing masterbatch of short polyester fiber and EPDM, and then blending with PP was the best method.

18. 以聚氧化乙烯为胶凝剂,20%盐酸为溶剂,以及其他助剂,制得胶凝酸体系。

A gelled acid system was prepared with polyethylene oxide as gelling agent, 20% HCl as solvent, and other additives.

19. 三聚氰胺、尿素与甲醛经羟甲基化、醚化反应,生成甲醚化六羟甲基三聚氰胺和甲醚化羟甲基脲复合树脂胶。

Melamine, urea and formaldehyde underwent hydroxymethylation and etherification to yield a composed resin glue of methyl-etherified hexahydroxy methylmelamine and methyl-etherified hydroxymethylurea.

20. 介绍了泥浆泵护套用聚氨酯胶的配方和制作工艺,并对预聚物中—NCO含量和MOCA用量进行了考察。

The formulation and preparation process of polyurethane for underlayer of slush pump were introduced. The effects of -NCO content of prepolymer and MOCA rate were studied.

21. 共混胶性能非常类似于中乙烯基聚丁二烯橡胶。

The properties of the blends are very similar to that of middle vinyl polybutadiene rubber.

22. 研究环氧化反式1,4 聚异戊二烯(ETPI)在轮胎锦纶帘布层胶和钢丝带束层胶中的应用。

The application of epoxidized trans-1,4-polyisoprene(ETPI) in the nylon carcass ply compound and steel belt compound of radial tire was investigated.

23. 在中试装置上合成出高乙烯基溶聚丁苯橡胶新牌号y 837v基础胶,并填充芳烃油。

The basic solution polymer on new brand (Y837V) of solution polymerized butadiene -styrene rubber was synthesized in the pilot plant, and filled aromatic oil.

24. 对高乙烯基聚丁二烯(HVBR)与顺丁橡胶(BR)共混胶进行了透射电镜观察。

The microstructural morphology of high vinyl polybutadiene (HVBR) and cis- polybutadiene rubber (BR) blends was observed by transmission electron microscope .

25. 试验对比中乙烯基聚丁二烯橡胶(MVBR)和BR基本物理性能和在胎冠胶中的应用效果。

The physical properties of medium-vinyl butadiene rubber (MVBR) and its application in crown compound of bias truck tire were experimentally compared to those of BR.

26. 以改性聚硫橡胶为基胶,并与增塑剂、增稠剂、填充剂等配合制成双组分改性聚硫中空玻璃密封剂。

Modified polysulfide sealants for insulating- gl ass are mainly made from modified polysulfide rubber, plasticizer, thickener and fi ller and it is a two-component sealant.

27. 并以苯并恶嗪预聚体为胶液、无碱玻璃布为基材,经浸胶、烘焙、压制制得一种玻璃布层压板。

A new glass cloth laminate was prepared by using benzoxazine as liquid cement, alkali-free glass cloth as backing material, and treating with cement dipping, baking and pressing.

28. 本文提出了不饱和聚脂树脂胶凝速率温度系数的方法,并测定不同温度下的贮存期。

In this paper was discussed the temperature coefficient method for calculating the gelation rate of unsaturated polyester resin. which is used for expecting the storage life of the resin.

29. 本文提出了不饱和聚脂树脂胶凝速率温度系数的方法,并测定不同温度下的贮存期。

In this paper was discussed the temperature coefficient method for calculating the gelation rate of unsaturated polyester resin. which is used for expecting the storage life of the resin.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!