冷试验用英语怎么说,冷试验的英文翻译


词语导航

基本信息

词语:冷试验

繁体:冷試驗

拼音:lěng shì yàn

英语翻译

【化】 cold run; cold test

分词翻译

冷的英语翻译:

cold; cold in manner; shot from hiding
【医】 algor; cry-; crymo-; cryo-; krymo-; kryo-; psychro-

试验的英语翻译:

experiment; test; try; try on; try out; examination; experimentation; trial
trial run
【计】 breadboarding
【医】 probation; test; tria
【经】 test; trial

翻译例句

1. 冷藏机组保护装置试验及打冷试验。

Ref. Plant to be done protection device test and cooling-down test.

2. 冷藏机组保护装置试验及打冷试验。

Ref. Plant to be done protection device test and cooling down test.

3. 并在工程冷试验装置上进行了玻璃固化工艺试验。

The process test was performed by the non-radioactive pilot plant.

4. 本文介绍了装置的设计参数和工艺冷试验对设备的考验结果。

Its design parameters and verification results are given in this paper.

5. 同时对步冷试验温度曲线进行修正,提出了修正步冷试验温度曲线。

In the mean time, temperature curve for step cooling was modified and a modified temperature curve for step cooling was first proposed in this paper.

6. 对熔模铸件孤立热节热型壳进行了浇注前及浇注后局部水淬激冷试验。

Experiments for hot mold shell with isolated hot spot by local water quenching in investment casting before and after pouring were conducted.

7. 本文通过对Q 3 4 5d钢加入微量合金元素V并进行控轧控冷试验。

This paper carries out controlled rolling and controlled cooling test by means of adding microalloy element V to Q345D steel.

8. 本试验选用聚苯乙烯泡沫塑料和GR6作为隔热材料进行粮面压盖隔热保冷试验。

Polystyrene foamed plastics and GR6 used to cover the surface of grain bulk for insulation heat were tested.

9. 主要讨论了大瓷套冷炸、温度循环试验中炸裂及瓷套经磨削入库后开裂的原因。Www.wENTiYI.COm

The factors of cold cracking of large porcelain sheel, cracking in temperature circulating test and cracking before warehousing are discussed.

10. 本文针对空冷支架结构体系中典型的空间钢桁架节点进行了抗震性能试验研究。

In this paper, the seismic behavior of a typical joint in the air-cooled condenser structure system is researched.

11. 本文简要叙述钢筋冷压连接的工艺、设备及冷压接头性能试验的结果。

This article depicted briefly about cold-swaged joining technique for rebars, equipment and test data.

12. 采用激冷斜槽法和低过热法进行浇注料坯的试验,在试验中研究了不同浇注温度和冷却板倾斜角度对所浇注料坯的微观组织的影响。

The experience was conducted using cooling slope and low superheat processes, effects of pouring temperature and the degree of slope on the billet"s structure were researched.

13. 试验表明:冷固结球团矿直接还原新工艺具有工艺流程短、基建投资省、生产效率高、能源消耗少等特点。

The experiment showed that the new direct reduction technology had such advantages as short flow, small investment, high efficiency and low power consumption.

14. 铁矿石。低温碎解试验。利用静态收缩后的冷滚方法。

Iron ores. Low temperature disintegration test. Method using cold tumbling after static reduction.

15. 进行了强冷磨削和干磨削试验。

The compulsive-cold grinding and dry grinding tests were made.

16. 本文介绍了用于立式自然循环蒸汽发生器的同心立式波形板汽水分离器的冷、热态试验结果。

This paper presents the test results of cold and hot state for concentric ver-tical shutter steam separator used in vertical natural circulation steam generators.

17. 通过大型电站锅炉的冷态模拟试验获得了炉内和炉膛出口水平烟道流场的分布规律。

Through the cold-state model test of a high-capacity boiler obtained is the flow field distribution within the boiler and at the furnace outlet horizontal gas pass.

18. 目的探讨通过冷激发(冷加压)试验前后描记末梢动脉血流图这一无创性检测来评估血管内皮细胞的功能。

Objective To evaluate the function of the vas endothelium cell by the peripheral artery blood stream drawing before and after the cold pressor test.

19. 冷弯试验是钛容器制造中对铁板和焊接接头的必保检验项目。

The bending test is the necessary inspection item of titanium plate and welding joint for the manufacture of titanium vessel.

20. 依据某型涡轴发动机冷运转试验数据,给出了发动机阻力矩和净力矩的计算方法。

Based on a turboshaft engine test data gathered during cold run, a method of calculating engine resistant torque and torque for acceleration was introduced.

21. 对电弧炉炼钢用集束射流氧枪的射流特性进行了冷态和热态试验。

The cold test and thermal test for the jet characteristics of coherent jet oxygen lance have been carried out.

22. 在大型冷态试验台上相同的运行工况下,测试了它们的分离器效率及阻力。

Their separation efficiencies and flow resistances were all measured, under the same operating conditions, in a large scale cold state test rig.

23. 本文介绍了该烘烤器的结构和冷、热罐的烘烤试验情况。

The structure and cold and hot tests of the ladle drying system have been introduced in this paper.

24. 冷弯试验标准也有较大影响;

The criterion of cold bending test has clearly effect also.

25. 试验取驱动线系统中的一组,对组成驱动线的各部件采用1:1全尺寸模拟,在冷态下进行功能性试验,测定驱动线的综合性能。

One drive line system is used to obtain the synthetical function, every components of this system are simulated at the scale 1:1.

26. 主要介绍了小压差弹簧喷嘴的冷态试验和结果分析。

This article has mainly introduced the cold mode test and the result analysts of the spring nozzle with small pressure difference.

27. 通过大量冷态试验,在大范围变化工况、变化喉部面积及变化背压条件下,利用水对低温流量控制系统进行研究,得到了流量系数、压力恢复系数的变化规律。

And water is used in cold test. Through changing operating conditions, throat area and back pressure, the change rule of discharge coefficient and pressure recovery factor were found.

28. 通过大量冷态试验,在大范围变化工况、变化喉部面积及变化背压条件下,利用水对低温流量控制系统进行研究,得到了流量系数、压力恢复系数的变化规律。

And water is used in cold test. Through changing operating conditions, throat area and back pressure, the change rule of discharge coefficient and pressure recovery factor were found.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!