
词语导航
基本信息
词语:板束
繁体:板束
拼音:bǎn shù
英语翻译
【化】 lathed bundle
分词翻译
板的英语翻译:
bat; board; plank
【计】 board
【医】 assula; bar; board; disc; disci; discus; disk; lamella; lamellae
lamina; laminae; plasue; plate; table; tabula; tile
束的英语翻译:
bind; bundle; colligate; faggot; fagot; restrain; sheaf; tie; truss
【计】 beam
【医】 beam; bundle; Fasc.; fasciculi; fasciculus; fasicle; tract; tractus
【经】 bundle
翻译例句
1. 理论分析和实验结果表明,椭圆腔板束有利于降膜蒸发,能有效地提高蒸发速度和传热效率。
The theoretical analysis and experimental results show that the elliptic cavity is good for falling film evaporation and can effectively enhance the speed of evaporation and heat transfer efficiency.
2. 笔者通过对产品开发的生产实践,参照有关资料,提出解决板束封板设计计算的近似计算方法。
Based on the practical experience and relevant reference, one approximate method for calculating the seal plate of plate bundle was presented as well.
3. 本文介绍了M 27和M24两种直径高强度螺栓不同板束组成时扭矩系数的全部试验结果,可供实际使用时参考。
In this paper all experimental results of the torsion moment coefficients of high strength bolts with two kinds diameters, M27 and M24, and different plate combinations are presented.
4. 当壳体与板束温差较大时,笔者通过对产品开发的生产实践,提出解决板壳式换热器要否设置膨胀节的类似判定方法。
Through the practice of developing the products, some experience is available which can be used to determine in which case the expansion joint is necessary in plate-shell exchangers.
5. 因此目前电子束光刻设备主要的用途是用于刻制掩膜板,许多人甚至认为电子束光刻技术的产出量永远也无法满足芯片量产的需求。
E-beam tools are used in photomask writing, but many believe the technology will never be fast enough for high-volume semiconductor lithography.
6. 这些电梯由地面发射的激光束驱动,接收装置则是位于机械上的光伏单位——正如太阳能电池板中使用的一样——而这个过程被称做“能量束驱动”(power beaming)。
They are powered by laser beams on the ground firing at photovoltaic cells on the vehicles – like those used in solar panels – in a process called “power beaming”.
7. 所以O"Brien先生一直研究一套基于天花板的系统,用于跟踪接收装置所在位置,利用来自定向传送器的几束激光向该装置发出信号。
So Mr O"Brien has been working on a ceiling-based system that tracks where a receiving device is, and then sends it a signal using several laser beams from a directional transmitter.
8. 坚固的用螺丝固定的长方框,每隔25毫米有一个嵌孔,用来固定槽沟、板、缆束及线路图插袋等。
Strong rectangular frame fixed by screws, an inset hole every25 cm to fix the slotting auger, guard board, bunches of cables and circuit diagram sidekicks, etc.
9. 一束束电线被盖在壁脚板下面,天花板上面的线路被木包装覆盖。
The wire harnesses are covered with skirtings and the ceiling trunking is finished with a timber cover.
10. 从装饰板拉电动视镜开关足够远,找到线束接头。
Pull the power mirror switch away from the trim panel far enough to access the wire harness connector.
11. 在与各种探测器比较的基础上,我们设计了微通道板探测器,它是目前用于电子束曝光机的最先进的探测器。
On basis of comparison with other types of detectors, we designed microchannel plate detector which is the most advanced detector for EBM up to now.
12. 采用将有限声束分解为一系列平面波的方法,对有限声束在液体-固体板-液体结构中的声反射问题进行了分析和计算。
Analysis and numerical computation have been performed for the reflection of acoustic beam on the solid plate surface of layered structure: liquid solid plate liquid.
13. 引入冗余照明的概念,以实现波带板的空间相干照明以及降低束线对光源不稳定性及元件振动的要求。
The concept of redundant illumination is introduced to ensure the coherent illumination of zone plate and reduce the effect of source instability and element vibration.
14. 用电子束扫描加热的方法对具有毛细管板接头的不锈钢结构件进行钎焊是非常有效的。
It is very effective to use the scanning electron beam (EB) heating to braze the stainless steel structural part with capillary-to-plate joints.
15. 拆去固定仪表板线束槽到安全气囊后固定托架的螺丝。
Remove the screws that secure the instrument panel wire harness trough to the airbag rear mounting bracket.
16. 从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
17. 利用加速器治疗肿瘤时,通常要在射线束的路径上加入楔形板以改变平野的剂量分布。
When an accelerator is used to treat tumour of illness, the distribution of doses is changed by commonly inserting a wedge into the path of radial beam.
18. 目的:探讨后交叉韧带分束情况及板股韧带的作用,为临床重建后交叉韧带提供解剖学基础。
Objective To provide an anatomic evidence for the posterior cruciate ligament(PCL) reconstruction, the role of its sub-bundles and the function of the meniscofemoral ligaments were studied.
19. 结论家兔肱二头肌内有一腱板,肌束排列成环羽状。
Conclusions There was a tendon plate in Biceps brachii of rabbit, muscle fibers arranged into ring-pennate shape.
20. 利用这种特性可以产生制作高分辨率X射线波带板所需的两束非球面波。
The characteristic of aplanatic system shows that non-aplanatic point imaging can produce aspherical holographic interference for high resolution zone plate fabrication used for X-ray imaging.
21. 以SDS - 3电子束曝光机为基础,用折板结构静电偏转替代直板结构静电偏转,探讨了电子束曝光机折板静电偏转场的电子轨迹与电位分布应满足的要求。
Based on the SDS-3 E-beam lithography machine, the electrostatic deflection of the folded plate structure was used instead of the electrostatic deflection of the plate.
22. 应用自制柔性化电子束钎焊系统对毛细管板接头的钎焊工艺进行了研究,探讨了钎焊工艺参数对钎料扩散深度以及钎脚高度的影响。
The brazing technology for capillary tube-sheet joints has been studied using a self-made flexible controlling equipment of vacuum electron beam brazing.
23. 介绍了一种以微通道板和电阻阳极所构成的位置灵敏探测器为基础、用于兰州重离子加速器束流诊断的新型剩余气体电离束流剖面探测系统。
The detecting system is based on the residual gas ionization principle and consisted of electrostatic collecting plates, micro-channel plates and a resistive anode.
24. 销毁你的精神垃圾,重塑你的精神天花板,让一束圣洁的阳关,从天窗洒入。
You destroyed the spirit of garbage, ceiling remodeling your spirit, the sanctity of the bidding for Guan Yang, from the skylight aways.
25. 文中讨论了高能X线束滤过板的最佳厚度。
In this paper, the optimal thickness of the filter for high energy Xray beam is discussed.
26. 以电子束熔炼的纯钽锭为原料,研究了冷压开坯然后进行轧制的工艺,以及加工变形量、退火工艺对钽板的组织与性能的影响。
Study is made of the influence of the process of cold pressing and roughing followed by rolling, of deformation degree and annealing on the structure and properties of Ta slabs.
27. 灯具安装在吊顶上方,通过不透明的丙烯塑胶板聚束照射。
Lights are installed above the suspended ceiling beaming through the opaque acrylic panels.Www.WENTIyI.CoM
28. 该滤板可用于悬挂纤维束滤元、支撑纤维滤层。
The filter plate can be used for hanging a fiber bundle filtering element and supporting a fiber filtering layer.
29. 所有大鼠首先行蛛网膜下腔置管,然后在相当于T8椎板水平用做好标记的显微剪刀剪断脊髓的背侧2/3,建立大鼠皮质脊髓束横断损伤模型。
All rats first line of subarachnoid catheter, then the equivalent of T8 vertebral level and marked with micro scissors cut the spinal cord dorsal 2/3 rat corticospinal tract transection injury model.
30. 用来屏蔽带电粒子束的设备。射束屏蔽单元(1)包括固定到支撑板(15)的第一和第二屏蔽板(2,3)。
Apparatus for blanking a charged particle beam a beam blanking unit (1) comprises first and second blanking plates (2, 3) mounted to a support plate (15).
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
