
词语导航
基本信息
词语:栅电流
繁体:柵電流
拼音:zhà diàn liú
英语翻译
【电】 grid current
分词翻译
栅的英语翻译:
bar
电流的英语翻译:
electric current; electrical current; electricity
【计】 I
【化】 current; electric current; electric current (strength)
【医】 current; electric current; rheo-
翻译例句
1. 减少静态功耗的主要技术是降低衬底电流和栅电流等。
The main techniques used to decrease static power are:reduce current from substrate and mosfet gate.
2. 在数据处理中,考虑了部份沟道电阻贡献与栅电流有关。
In the data processing, it is considered that the contribution of the partial channel resistance is related to the gate cur-rent.
3. 发现器件的栅电流不是由单一的隧穿引起,同时还有电子的翻越和渗透。
The gate current is produced by the tunneling, the electron surmounting and percolation.
4. 电路运用带隙温度补偿技术,采用共源共栅电流镜,两级运放输出用于自身偏置电路。
The technology of temperature compensation and cascade current mirror was used, and the output of two stage amplifier was used for the bias of itself.
5. 本文论述了IGBT的栅驱动电压和栅电流的设计,指出了对IGBT施加保护时要注意的问题。
This paper deals with the designing of driving voltage and current for IGBT, points out the problems that should be paid attention to in the protection of IGBT.
6. 因此介绍了一种采用自偏置低压共源共栅电流源的带隙基准电路结构,用两个电阻代替了偏置电路。
This paper introduces a low supply voltage band -gap reference circuit which used a self-bias cascode current mirror.
7. 深入研究了热载流子退化过程中栅电流和衬底电流的退化规律,并建立了一个准确的栅电流退化解析模型。
Degradation characteristics of gate current and substrate current during stress are studied, and an accurate analytic degradation model of gate current is presented.
8. 通过直接栅电流测量方法研究了热载流子退化和高栅压退火过程中PMOSFET " s热载流子损伤的生长规律。
The growth laws of hot carrier damage of PMOSFET"s during the hot carrier degradation and the high field annealing are studied by direct gate current measurement.
9. 其设计特点是采用了共源共栅电流镜,运放的输出作为驱动的同时还作为自身的偏置电路;其次是采用了带隙温度补偿技术。
The cascade current mirror was used in the circuit, and the output of the OPAMP was used for the bias of itself and to drive the next stage.
10. 设计并研制出了工作频率为2.5千赫,输出电流从60到250安连续可调的可控硅斩波器及其栅控装置。
A 2.5 KHZ SCR chopper, with the output current controlled continuously from 60a to 250a, and its grid-control device has been designed and built.
11. 过流保护电路将检测电流转化为栅压控制开关管;
Over-current protection circuits convert the detecting current into the gate voltage which controls the switch FET.
12. 但当厚度在特定值及特定电场下时,单个氧空位引起的栅漏电流增加可以忽略。
However, when oxide thickness increased to a fixed value at a specific oxide field, the increase in gate leakage current caused by a single oxygen vacancy could be neglected.
13. 针对栅氧化层击穿otp存储单元提出了可行的阵列结构和电流敏感放大器。
For gate oxide breakdown OTP memory, we present a viable NOR array structure and current sense amplifiers.
14. 不锈钢毛虽然用作阴极氧还原产电生物反应栅(CORE-PRB)的电极材料虽然有很多优点,但是反应电流较小。wWW.WENtIYI.cOM
The current of stainless steel cathodic oxygen reduction electricigenic permeable reactive barrier (CORE-PRB) is limited though stainless steel fiber has many advantages to act as the electrodes.
15. 电流源采用共源共栅结构,提高了电源抑制比。
The current source adopts cascade structure to improve power supply rejection ration (PSRR).
16. 为了更直观地描述低压大电流VDMOS器件特性,对器件栅电荷特性进行了测量和提取。
In order to describe the characteristics of VDMOS device more intuitively, this paper mainly focuses on the gate charge test.
17. 结果表明,与常规板栅相比,三维网络碳化硅板栅与极板内电流分布比较均匀。
Calculated results showed that the current distribution over three-dimensional networks is more uniform than that over general grid and plate of lead-acid battery.
18. 采用平面选择注入隔离工艺制作MESFET及旁栅电极,通过改变半导体特性测试仪的延迟时间参数,深入研究了不同沟道电流的数据采集时间对旁栅效应迟滞现象的影响。
The influence of different data collection time of channel current on the side gating hysteresis effect is studied by changing the delay time of semiconductor characteristic testing set.
19. 电路设计采用电流镜、折叠式共源共栅等结构,实现了在峰值电流控制模式中的电流比较功能。
By using the structures such as current mirror, folded-cascode and so on, the function of comparison in peak-value-current-mode-control is realized.
20. 电路设计采用电流镜、折叠式共源共栅等结构,实现了在峰值电流控制模式中的电流比较功能。
By using the structures such as current mirror, folded-cascode and so on, the function of comparison in peak-value-current-mode-control is realized.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
