
词语导航
基本信息
词语:热载荷
繁体:熱載荷
拼音:rè zǎi héwWW.WeNTIyi.CoM
英语翻译
【化】 thermal force
分词翻译
热的英语翻译:
ardent; caloric; craze; eager; fever; heat; hot; warm
【化】 heat
【医】 calor; cauma; febris; fever; fievre; heat; hyperthermia; hyperthermy
phlegmasia; phlegmonosis; pyreto-; pyro-; therm-; thermo-
载荷的英语翻译:
load
【化】 load
翻译例句
1. 对热载荷加载研究了材料的应力与温度之间的关系。
The relation of thermal and temperature of material is studied through thermal loading.
2. 这些方法已成功地应用于飞机座舱热载荷和热特性试验中。
These methods have been used in the actual airplane cabin thermal process and heat load tests successfully.
3. 独创性的加湿系统即便在有热载荷时,也能提供高的相对湿度。
An innovative humidification system allows a high relative humidity even with a heat load.
4. 根据高空高速飞行特点及瞬态热载荷值,确定仪器设备舱调温系统方案。
According to flight feature and transitional thermal load value, scheme of temperature adjusting system of electronic equipment cabin was presented.
5. 然后把热载荷和电场力同时作用在模型上,分析两者对导电聚合物的共同作用效应。
Then the deformations of the conductive polymers are simulated under thermal and electric joint load.
6. 目前,封装行业对器件热载荷可靠性做了大量研究工作,而对功率载荷的研究很有限。
At present, the packaging industry has done plenty of works to the reliability in thermal load while the study of power load is very less.
7. 研究了功能梯度材料截顶圆锥壳在横向机械载荷与非均匀热载荷同时作用下的变形问题。
The deformation of functionally graded truncated conical shell subjected to transverse mechanical load as well as non-uniformly thermal load is studied.
8. 把所得极值与静水载荷、热载荷和兴波载荷相加,即得在给定的波浪遭遇次数中期望出现的总载荷极值。
Adding the stillwater load, thermal load and wave-making load to the above extreme response, the extreme total load expected to occur in a certain number of wave encounters is evaluated.
9. 对风挡防冰热载荷的计算方法及计算结果进行了较为详细的讨论,提出了一种风挡防冰热载荷的计算方法。
A detail discussion and a method about the heat load calculating for anti-icing on aircraft windshield are presented. The results of this calculation method agree well with the available foreign data.
10. 给出一种解析方法求解在两种热载荷冲击作用下,正交各向异性圆柱体的动应力和磁场矢量扰动的集中效应。
The analytical expressions for the dynamic stresses and perturbation of magnetic field vector are obtained by means of a finite integral transform and Laplace transform.
11. 广泛应用于高温部件的热障涂层,在热载荷作用下各层间所集聚的残余应力是导致其层裂和失效的重要原因。
Thermal barrier coating (TBC) has been used widely in heat components, the residual stress concentrated by thermal load can lead to spalling or failure for the entire coating system.
12. 分析了在热载荷作用下双金属复合钢管结合强度的变化,研究了经历温度循环后内外层管之间出现松脱的可能性;
The change of glued strength of bimetal composite pipe under the action of heat load was analyzed in this article.
13. 对大型直立设备安装过程中的现场焊接热处理过程中在轴向载荷和局部热载荷共同作用下的屈曲问题进行数值研究。
The buckling of large vertical cylindrical shells with welds subjected to local thermal action and axial loads was studied with numerical method by using ANSYS code.
14. 本文运用ANSYS分析软件,利用物理环境分析法建立了三层套组合式扁挤压筒内压-预紧-热载荷耦合有限元模型。
With the FEA software ANSYS, the coupling model of coupling the pressure-prestress-heat stress flat container of three-layer is built using the physical environment approach.
15. 它抗蠕变性和载荷下的热稳定系统扩展其在高温下保持性能。
It resists creep under load and the heat stabilizer system extends its retention of properties at elevated temperatures.
16. 除了控制的机械轴和轴承载荷,耦合进一步保护通过提供电力和热轴之间的耦合隔离高度编码器。
In addition to controlling mechanical shaft and bearing loads, the coupling further protects the encoder by providing a high degree of electrical and thermal isolation between coupled shafts.
17. 大功率、高热流密度微波功率放大器是环境监测有效载荷中的关键设备,对整星的热设计影响很大。
Microwave power amplifier with large power and high heat flux is a key equipment of satellite which has a great influence on satellite thermal design.
18. 本文提出一种简便的解析方法求解实心球体在热冲击载荷作用下的动应力响应。
This paper presents a simple analytical method solving the dynamic stress response in a solid sphere under thermal shock.
19. 对有裂纹的装甲钢板和铝热焊修补后的装甲钢板在受同样正向分布载荷下进行了抗击强度分析。
Under similarly distributed load the anti-shock strength is analyzed with regard to cracking armor plate and the thermit welding armor plate.
20. 在应用边界元方法计算直齿圆柱齿轮的本体温度场的基础上,进一步研究了直齿轮在齿厚方向和沿其轴向由其本体温度的改变和传动载荷而引起的热弹性变形。
On the basis of this result further study is made on thermal elastic deformation resulted from bulk temperatures changing and transmission load of the spurs gear in the direction of tooth and axle.
21. 其次,在喷管轴对称模型瞬态热分析的基础上研究了轴对称载荷下热—结构耦合场的应力分析。
Next, on the basis of the transient-state thermal analysis, the thermal elastic-plastic analysis of the thermal-structure couple is obtained in the axial symmetry loads.
22. 纳卫星的被动热控系统对卫星舱内的温度控制及其有效载荷的可靠工作具有重要意义。
The calculations of radiator surface area and heat insulation layer thickness are necessary for the design of passive thermal control system.
23. 阐明了热瞬态密封问题求解的关键是给出螺栓载荷的热态增量;
It expounds that the key of solving thermal transient sealing problem is to obtain the thermal increment of stud-bolt loading.
24. 研究了热超弹性圆柱壳在内表面突加载荷及不同温度场作用下的运动与破坏问题。
The finite oscillation and destruction of thermo-hyperelastic cylindrical shells subjected to a suddenly applied dead-load on the inner surface under different temperature fields were studied.
25. 对超高音速火箭的飞行载荷和气动热进行了分析计算。
The flight loads and dynamic heating of the rocket during flight in a high supersonic velocity are also analyzed and calculated.
26. 该文研究了由两个不可压热超弹性球体组合而成的物体在突加表面均布拉伸载荷作用下空穴的动态生成问题。
Dynamical cavitation in a spheroid composed of two incompressible thermal-hyperelastic Gent-Thomas materials under boundary dead-loading is examined.
27. 该文研究了由两个不可压热超弹性球体组合而成的物体在突加表面均布拉伸载荷作用下空穴的动态生成问题。
Dynamical cavitation in a spheroid composed of two incompressible thermal-hyperelastic Gent-Thomas materials under boundary dead-loading is examined.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
