轨迹角用英语怎么说,轨迹角的英文翻译


词语导航

基本信息

词语:轨迹角

繁体:軌跡角

拼音:guǐ jì jiǎo

英语翻译

【机】 track angle

分词翻译

轨迹的英语翻译:

contrail; locus; orbit; track

角的英语翻译:

corner; angle; cape; contend; horn; wrestle; role
【医】 angle; anguli; angulus; Broca"s angle; cornu; cornua; gonio-; horn

翻译例句

1. 当然用装在三角架上的照相机固定摄影,长时间曝光能拍到星星因地球自转而形成的同心圆轨迹。

Of course, with the camera fixed to a tripod, the stars themselves produce concentric trails in long exposures, a reflection of the Earth"s rotation around its axis.

2. 车辆碰撞护栏的运动轨迹应能圆滑过渡,以较小的驶离角和较小的回弹量停留在不影响车辆正常行驶的地方。

The trajectory of vehicle barrier crash should be able to stay in the smooth transition, does not affect the normal running of the vehicle to leave the springback Angle and the smaller the.

3. 讨论几何轨迹命题的推广,得列一些结论,从另一角度体现了高等几何与初等几何的联系。

The discussion on the popularization of locus proposition leads to some results, which shows the connection between higher geometry and lower geometry.

4. 本文最后设计了直升机模糊pd轨迹跟踪控制器,与姿态角控制器相结合,完成对整个飞行控制系统的设计。

Finally, the dissertation designed the fuzzy PD controller of trajectory tracking, which is combined with attitude Angle controller, so that the whole flight controller is completed.

5. 为提高灭茬刀辊设计的可靠性和效率,基于UG-NX 3软件,根据运动方程绘制刀刃运动轨迹,形象直观的获取动态隙角。

For improving the design reliability and efficiency of the stubble roller, visualized dynamic gap Angle was obtained though drawing blade moving track according to movement equation using ug - NX3.

6. 根据飞剪剪切机构的工作特点,综合考虑连杆运动轨迹、速度和位置角,建立多目标优化模型。

Based on the working feature of flying shear mechanisms and considering the motion track, velocity and position Angle of connecting rod, a multi-objective optimization model is built.

7. 本文用微分几何理论推导出纤维缠绕复合材料压力容器的非测地线缠绕轨迹、包角方程及绕丝头运动方程。

Non geodesic trajectory mandrel rotation and payout eye motion equations for fiber reinforced composite pressure vessels are derivated by theory of differential geometry.

8. 采用微分方程高精度数值解法得到了随时间变化的摆角、摆长、摆长变化率以及运动轨迹的数值精确解。

The accurate numerical solutions of the angular displacement, the length and its rate, and the path are given with the numerical method.

9. 介绍了合缝机三角钩针的组合运动,描述了三角钩针针尖运动的轨迹。

This paper introduces the motion of CAM hook needle of the linking machine, and describes the motion locus of.

10. 在一定的入水角与速度范围内,球形弹丸入水初期弹道的空泡特性、弹道轨迹以及速度衰减规律具有一定的相似性。

The initial cavity, ballistic trajectory and velocity attenuation of the sphere pellets are similar at different water-entry angles and initial velocities.

11. 仿真实验结果表明,利用该算法可以通过控制机器人两个驱动轮的驱动力矩来实现控制机器人按给定的轨迹运动,同时也能实现机器人方向角的改变。

The result of simulation indicate the algorithm can actualize track movement of robot through controlling driving torques of two wheels and change the direction corner of robot simultaneously.

12. 目前的井眼轨迹方位角测量技术主要靠磁通门传感器,这种技术受地磁场及测量体周围金属管体的制约。

At present, hole trajectory azimuth Angle is measured mainly with magnetism sensor, but which is restricted by magnetic field and the metal tube around the surveying equipment.

13. 黑线在地板上布置成迷宫状,整条轨迹线包含90度角的转弯,其它角度的转弯或是曲线,但不会出现线条交错现象。

The black line traces a maze on the floor. It may have 90 degree turns in it, turns of other angles, or curves. The line will never cross itself.

14. 轮廓数控系统能将刀具或工件向任一角度,也可沿曲线轨迹移动。

Contouring NC systems can direct the tool or workpiece to move at any Angle, and also along curved paths.

15. 本文计算了在CT-6托卡马克上进行电子回旋共振加热实验时对应不同窗口、不同入射角的反常波轨迹。

The traces of the geometrical optics rays in the electron cyclotron frequency range in CT-6 have been obtained numerically.

16. 航迹角修正法的采用,进一步修正了规划出的飞行轨迹,从而获得了理想的飞行参考轨迹。

After adopting the correcting method of flight path Angle, flight path planned is further modified and ideal reference flight path is obtained.

17. 星期二,五角大楼说了“不能解释那道蒸汽轨迹的来源”之后,那段胶片引起了媒体的广泛兴趣。

The footage sparked wide media interest on Tuesday after the Pentagon said it was unable to explain the source of the vapour.

18. 提出了一种基于参数曲面三角化的复杂曲面刀具轨迹生成方法。

Based on the triangulation of parametric surface, a new method of tool path generation for complicated multi surfaces is presented.

19. 本文分析了铣削轨迹及合理后角对顺铣与逆铣中刀齿耐用度的影响。

An analysis of the effect of tooth path and optimum clearance Angle on tool life in the up milling and down milling processes is presented.

20. 采用比例控制算法研究行波超声波电机对三角波、正弦波曲线的快速位置轨迹控制。

Besides, the position tracking control of USM for triangle and sinusoid is studied by means of P-control.

21. 基于单轨迹地平仪研究了地平仪测量姿态角的过程,得到了解析形式的姿态角误差补偿公式。

The measurement process of the attitude Angle based on single trailing earth horizon sensor is investigated, and an analytical formula of attitude compensating error is obtained.

22. 基于大气传输模型,采用光线传输的实际轨迹对天顶角进行修正处理,得出天顶角随发射角和传输高度的变化复杂函数。

Based on the atmospheric transmission model, through the actual ray track, the zenith Angle is revised, which is a complicated function with launch Angle and altitude.

23. 全能束紧器及特别轨迹的扫刀,保证结帮后,鞋面均匀贴紧楦头,绝对不发角,增进美观,提高质量。

Second-ranking all-around constrictive traps and special track after Saul knife, ensure lasting, vamp uniform tiejin XuanTou, absolutely not hair Angle, improve the beautiful, improves the quality.

24. 每条轨迹起点上的数字是震源方位角与震源深度。

The number above the beginning of each trace is the source azimuth and below is the epicentral distance.

25. 根据光线在晶体中的轨迹公式,计算了任意方向入射光所对应的尼科尔棱镜的临界角,得到了尼科尔棱镜的偏振区的限制曲线。

According to ray-tracing formulas of crystal, calculated the critical angles of Nicol prism for incident ray in any direction. Achieves the polarization critical curves of Nicol prism.

26. 金星每八年在空中的运行轨迹正是一个正五角形。

The planet Venus traced a perfect pentacle across the ecliptic sky every eight years.

27. 解决一追二问题的方法共讨论了三种:初始角的平分线航向法、瞬时角的平分线航向法、中点轨迹法。

Three methods are discussed to solve the one pursue two problem, they are course method of the initial angular bisector, course method of the instantaneous angular bisector and mid-point path method.

28. 然后,针对能够整周转动的齿轮—五杆机构,研究了其上的一点在齿轮机构的传动比、初始相位角、杆长以及两杆之间的夹角变化时的轨迹曲线以及速度和加速度曲线的情况。

Then the locus curves of one point in the geared five-bar were studied with the change of the gear ratio, the phase Angle, the bar length and the Angle between two bars.

29. 数字摄像机安放在经纬仪上,经纬仪布置在飞机飞行轨迹的两侧,构成了一个能够在俯仰角和方位角下拍摄图像的光测机构。

The cameras are placed on the theodolites which are laid on the sides of flight path, and it can take airplane′s photos at azimuth and pitching angle.wwW.wEntiyI.COM

30. 分析了当产生直线运动轨迹的激振电机和产生圆运动轨迹的激振电机存在一个相位差角的情况下运动情况及实现平动的条件。

Analyzed the conditions of realization of balance when the production line trajectory vibrating motor and the producing circular vibrating trajectory motors there is a phase angle.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!