
词语导航
基本信息
词语:壁出口
繁体:壁出口
拼音:bì chū kǒu
英语翻译
【电】 wall outlet
分词翻译
壁的英语翻译:
wall
【医】 paries; parietes; wall
出口的英语翻译:
exit; escape; export; issue; outcome; outlet; speak out; vent
【医】 exitus; outlet; portal of exit
【经】 export; exports
翻译例句
1. 分析了超临界锅炉水动力特性对下辐射区水冷壁出口温度的影响。
The influence of supercritical boiler"s hydrodynamic characteristics to the outlet temperature of water wall"s lower radiation zone is analyzed.
2. 在燃磷量不变情况下,最高燃烧温度、壁面最大热流和平均热流均随过剩空气系数的增大而减小,但烟气出口温度缓慢增加。
Under the condition of constant phosphorus mass flow rate, the smog exit temperature would increase slowly while other parameters would decrease with increasing excess air coefficient.
3. 详细测量了平行进口端壁附面层与设前导叶两种进口条件下某涡轮叶栅的出口流场。
The exit flow fields of a turbine cascade with or without the front guide vanes were investigated.
4. 计算得到的壁面压力分布、出口处液膜内轴向速度分布以及雾角大小都与实验结果吻合的很好。
The predicted results of the wall pressure distribution, axial velocity profiles at the outlet and the spray Angle agreed well with the experimental datum.
5. 壁滑移发生在口型出口附近。这种压力波动现象主要归因于试样的壁滑移行为。
This phenomenon of pressure oscillation can be attributed to the wall slip behaviour of the sample.
6. 壁面温度仅对出口平均温度的影响较大,对火焰最高温度的影响较小。
The wall temperature has remarkable effect on the averaged exit temperature, whereas, it has small effect on the maximum combustion temperature.
7. 研究还发现,水泵出口断面轴向流速分布均匀度和速度加权平均偏流角也随壁面粗糙度改变而改变。
It is also discovered that the axial velocity distribution and velocity-weighted average swirl Angle at the outlet section of axial-flow pump vary with the changing of wall roughness.
8. 计算结果表明:增加通道深宽比对推力室壁面能够起到强化传热的作用,但同时也增加了冷却通道的进出口压差。
The simulation results show that the heat transfer of rocket chamber will be enhanced when increasing the aspect ratio, but the pressure drop will increase simultaneously.
9. 二次冷喷流对喷管扩散段出口附近壁面有非常明显的冷却作用。
The numerical simulation also indicated that secondary cold gas injection had very obvious effects on the surface wall about the exit of the nozzle diffuse.
10. 壁面温度对最高燃烧温度、壁面最大热流和平均热流影响不明显,但烟气出口温度随壁面温度的升高而增加较大。
Wall temperature had a remarkable effect on smog exit temperature, whereas its effect on other parameters was not obvious.
11. 主流通道内侧压力差主要产生在激励器与主流出口之间的上下壁面上。
The pressure difference on the wall between actuator and the exit of primary jet is great.
12. 另外,通过在壳体的流出口设置扩口的引导壁,形成更稳定的流 动。
Flow is made more stable by providing outwardly flaring guide walls on the outlet of the casing.
13. 当射流速度比较大时,喷管的缺陷如进口出口的毛刺和流道壁的粗糙度是诱发湍流使射流破断的主要原因。
The turbulence induced by the defects of nozzle, such as the burr at the inlet and outlet, and the roughness of the wall, is the main cause to decrease the length of intact jet.
14. 存在最佳的反应物组分比,从而获得较低的壁面温度和较高的出口氢气含量。
There is an optimal inlet concentration, which corresponds to the lowest wall temperature and the highest hydrogen fraction at the outlet.
15. 研究了埋管出口流体温度、钻孔瞬时平均壁温、单位长度吸热量以及距钻孔一定距离处土壤温度分布随运行时间的变化规律。
Obtains the variety patterns of outlet water temperature, transient borehole wall temperature, heat exchange capacity per length and temperature distribution in certain distances from the pipe.
16. 实验结果表明,燃烧器区射流一出口就出现了贴壁,燃烧区及燃尽区壁面附近涡量强度和湍动度都很高。WWw.wENTIYi.COM
The results of an experimental investigation indicate that there emerges a wall attachment phenomenon as soon as the jet flow at the burner zone reaches its outlet. Furt...
17. 实验结果表明,燃烧器区射流一出口就出现了贴壁,燃烧区及燃尽区壁面附近涡量强度和湍动度都很高。
The results of an experimental investigation indicate that there emerges a wall attachment phenomenon as soon as the jet flow at the burner zone reaches its outlet. Furt...
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
