
词语导航
基本信息
词语:扭转角
繁体:扭轉角
拼音:niǔ zhuǎn jiǎo
英语翻译
【化】 angle of torque; angle of torsion; angle of twist; torsion angle【医】 angle of torsion
相关词条
1.angleoftorsion 2.twistangle 3.torsionalangle 4.angleoftwist分词翻译
扭的英语翻译:
gnarl; turn around; tweak; twist; wrench; wrest; wrestler; wring【化】 twist
【医】 stropho-
转角的英语翻译:
corner翻译例句
1. 胫骨扭转角是人体胫骨生理解剖的固有角度。
The Angle of tibial torsion is an inherent Angle in human bodies.
2. 通过间接测量转轴的扭转角,从而得到转轴的扭矩值。
The rotation shaft torque can be obtained by indirectly measuring the torsion Angle of shaft.
3. 它适合于安装在地块边角进行任意确定扭转角度和速度的喷灌。
The utility model is suitable for being arranged at the rim angle of a land block to carry out the sprinkling irrigation in any determined angle and speed of torsion.
4. 目的:探讨股骨偏心距测量数据及其与股骨颈干角、股骨颈扭转角相关性。
Objective: to study the femoral offset and its relationship with femoral collo-diaphyseal Angle and torsion Angle.
5. 推导了钢轨扭转角的计算公式,并计算了几组不同荷载作用下的轨顶水平位移。
The formula of twist Angle of rail is derived and lateral displacements on the top of rail subjected to the several different loads are calculated by using the formula.
6. 方法:对国人胫骨81副(男41副,女40副)进行下段扭转角及外翻角测量。
Methods: The twist Angle and eversion Angle were measured on 81 sets (male 41 and female 40) of tibiae.
7. 肱骨远端不同位置内外上髁轴线对多层螺旋CT容积再现测量肱骨头扭转角没有影响;
The transepicondylar axis of different position has no effect on volume rendering technique measuring the humeral head retroversion angle with multi slice spiral CT.
8. 为了获得高谐振频率、大扭转角的驱动元件,设计了一种新型的压电圆盘扭转致动器。
In order to obtain an actuator with high resonant frequency and large torsional Angle, a new piezoelectric disk torsional actuator has been developed.
9. 本文提出了两种较精确的晶须扭转角度的测量方法,且所测的都是单晶晶须的局部扭变。WWW.WEntIyi.com
In this paper, two precise methods are posed to measure the turning angles here. The local twist of the single crystal whiskers can be measured accurately in those methods.
10. MTMD最优参数的设计准则定义为:结构最大扭转角位移动力放大系数的最小值的最小化。
The design criterion of the MTMD optimum parameters is defined as the minimization of the minimum values of the maximum torsional displacement dynamic magnification factors.
11. 本文讨论了一种扭转角实时监测系统,用以实时动态监测不同高度配置的设备基坐之间的扭转角。
This paper mainly discusses a real-time monitor system for metering the twist angle between foundations of deferent heights.
12. 为了提高用莫尔条纹法测量扭转角的测量精度,分析了光栅周期不一致对扭转角测量误差的影响。
With the aim to improve the measuring precision of a roll angle based on Moiré fringe method, the influence of inconsistent periods of two gratings on the measurement precision is analyzed.
13. 与中性态相比,带电态下其分子结构表现在C - C键的键长及环与环间的扭转角发生显著的改变。
Comaring with the neutral states, the bond lengths and the inter ring twist angles of the charged states are changed obviously.
14. 基于导出的设置MTMD时非对称结构扭转角位移传递函数,建立了扭转角位移动力放大系数解析式。
Based on the torsional displacement transfer function of the asymmetric structure with MTMD, the analytical expression is developed for the torsional displacement dynamic magnification factor.
15. 随着心肌缺血的改善,局部和整体左室收缩功能逐渐恢复,表现为圆周应变、径向应变及扭转角度的增高。
Then radial strain, circumferential strain and rotation increased. Regional systolic function damaged because of myocardial ischemia in patients with acute myocardial infarction.
16. 方法分别采用CT法及裸骨法测量80个股骨标本股骨扭转角,对测定值进行统计学分析,并作左右两侧比较。
Methods Torsion angles were measured with CT method and a new photogrammery of digital camera respectively in 80 femoral specimens. Compared of the values in both left and right sides.
17. 目的通过CT法及裸骨投照测量法(以下简称“裸骨法”)测量股骨扭转角的比较,探讨CT测量扭转角的可靠性。
Objective Compared with ct scan method and "bare-bone method" of measuring femoral torsion Angle, to study the reliability of measuring torsion Angle by means of ct method.
18. 文末数值算例给出了动力柔度系数和扭转角幅值随无量纲频率的变化曲线,并与单相弹性介质情况进行了对比分析。
The dynamic compliance coefficient curves and the torsional Angle amplitude of a rigid disc versus the dimensionless frequency are presented.
19. 在一次测量过程中,两组测量单元可以测出各自所在位置的井斜角和相对扭转角,由此可计算出两个单元之间的方位角变化。
The azimuth Angle change between the two units can be calculated by once operation according to the deviation angles and relative torsion angles measured with the units at each point.
20. 本文基于一种常用的扭转试验机,采用了技术较为成熟的扭矩传感器,通过平衡力法测量扭矩,并采用光电编码器测量扭转角;
Torque is measured by equilibrant method in virtue of torque transducer and torsional angle is measured in virtue of photoelectric coder on conventional experimental machine.
21. 所得到的刚度矩阵表明,只有当忽略翘曲变形对截面转角的影响时,轴向拉压才只与水平弯曲及竖向弯曲相耦合,而与约束扭转不再耦合。
It is shown that, when the effect of warping on rotation Angle is neglected, tension (or compression) is only coupled with horizontal bending and vertical bending instead of constrained torsion.
22. 实际上,当两个“约束扭转”的单元以一个尖锐的角度组合在一起的时候,你需要耦合他们的唯一合转角,但是它们平面外的自由度解藕。
In practice, when two elements with "restrained warping" come together at a sharp Angle, you need to couple the displacements and rotations, but leave the out-of-plane warping decoupled.
23. 本试验机用于对弹簧作扭转试验,测定弹簧的扭矩和转角。
This machine is applied to test torsion of springs, and measure torque and rotor Angle of springs.
24. 本试验机用于对弹簧作扭转试验,测定弹簧的扭矩和转角。
This machine is applied to test torsion of springs, and measure torque and rotor Angle of springs.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
