破断用英语怎么说,破断的英文翻译


词语导航

基本信息

词语:破断

繁体:破斷

拼音:pò duàn

英语翻译

【机】 break

分词翻译

破的英语翻译:

break; breakable; broken; cleave; damaged; defeat; destroy; torn; worn-outwww.wENTiyi.Com

断的英语翻译:

break; break off; give up; sever; snap; stop
【医】 break

翻译例句

1. 在静水和汹涛中单腿破断试验。

The single leg rupture test in slam water and calm wave.

2. 结果表明,该中间拉杆的破断属腐蚀疲劳失效。

The results showed that the intermediate tie rod was fractured by corrosion fatigue.

3. 证明了新型粗尾锚杆可以解决顶板锚杆破断问题。

It is verified that roof bolt broken problem may be solved with new type"s thick tail bolt.

4. 主题包含:弹性、黏弹性、塑性、潜变、破断及疲劳。

Topics include: elasticity, viscoelasticity, plasticity, creep, fracture, and fatigue.

5. 线接触结构,金属面积比较高,具有较高的破断载荷。

Parallel laid, with a large metallic cross-section, high breaking load relative to the rope diameter.

6. 当钢丝拉力值的离散度较小时,钢丝绳的整绳破断拉力值大。

When tensile force value dispersed degree of steel wire is low, broken pulling force of wire rope is high.

7. 并进一步分析了基岩厚度、采高、推进速度对顶板破断的影响。

The effect of basic rock thickness, mining height and advancing speed on roof breaking is analyzed.

8. 研究了添加膳食纤维对白鲢鱼糜凝胶破断强度和凹陷度的影响。

Effect of adding dietary fiber on the breaking strength and breaking strain of fresh water fish surimi gel was investigated .

9. 由这些参数生成了一个破断评估图来量化裂纹对材料强度的影响程度。

Using these parameters, a failure assessment diagram was generated to quantify the effects of the presence of cracks on material strength.

10. 利用上述规律,可以对顶板破断的过程及其强度进行有效的评价和预测。

With above rules, the process and intensity of roof fracture and pressurization can be evaluated and predicted effectively.

11. 这对减少集束过程中纤维的毛丝、纠结和单丝破断,亦具有积极的作用。

It has positive roles to decrease tow"s lousiness, tangled and breaking of single fibre in the process.

12. 结果表明:果实的压缩或压入强度及破断能均随贮藏时间的增加而减少;

The results showed that the compression or compressive strength and rupture energy of fruit decreased with an increase in storage time;

13. 深部软岩巷道中大面积锚杆、锚索破断现象是巷道支护面临的一个难题。

Many breakings in anchor bolts and cables in tunnel of deep soft rock were one of problems faced by roadway supporting.

14. 裂纹扩展在焊缝区和半熔化区之间交替进行,并非严格按W/F界面破断。

Crack propagation conducts alternatively between the weld zone and the partially molten zone, and is not strictly to rupture at W/F boundary surface.

15. 观察了单腿破断时张力腿平台的平面运动、稳性、张力的重新分配和动力系数。

The TLP plane motion, stability, redistribution of tether force and dynamical factor has been viewed, during the rupture of one leg.

16. 具体破断原因建议检查卷筒或导向滑轮是否存在缺陷,港方对该事故不负责任。

Therefore, there is no possibility of the Hongkong side to be responsible for the incident and we suggest that the cable drum and the cable fairlead should be inspected to find out the true reason.

17. 扭剪型螺栓破断沟槽的加工采用数控技术、提高沟槽加工精度,确保配套质量;

Adopting the computerized Numerical Control Technique to machine the breakage groove of torshear type bolts can improve the machining precision of groove, guarantee the assembled quality.

18. 依据典型浅埋煤层工作面的实测和模拟,发现了采场老顶初次破断的非对称现象。

By field observation and simulating test of shallow seam longwall mining, the phenomenon of main roof asymmetry breaking is discovered during the first weighting.

19. 断口扫描观察表明,试样破断是由于腐蚀隧洞沿滑移面生长并受到拉伸撕裂所致。

Fractured surface scanning observation showed that the breakage in specimen resulted from the corrosion tunnels generating along slip planes and being torn by tensile stress.

20. 在相互挤压的破断板块系统中,2 ~3个关键板块对工作面矿压显现有决定影响。

The 2 ~ 3 key plates have important influence on the ground behaviour of face in system of reciprocal extrusion fracture plates.

21. 在此基础上,提出将控制覆岩主关键层不破断失稳作为建筑物下采煤设计原则的观点。

Based on the key stratum theory in ground control, the basic principle in the design of mining under buildings should ensure that the primary key stratum would not break.

22. 提出主关键层来压的新概念,指出回采工作面矿压显现程度主要受主关键层破断的影响。

The idea of key stratum pressure is put forward, and the ground pressure is mainly influenced by the breakage of key stratum.

23. 提出主关键层来压的新概念,指出回采工作面矿压显现程度主要受主关键层破断的影响。

The idea of key stratum pressure is put forward, and the ground pressure is mainly influenced by the breakage of key.

24. 应用材料力学理论,阐明了锚杆支护时锚尾一定受到偏心载荷作用和顶板锚杆破断的机理。

With material mechanics theory, expounded bolt tail subjected to no center load action and roof bolt broken mechanism while roadway was supported with bolts.

25. 运用相似模拟和理论分析相结合的方法,揭示了采场顶板初次破断机理,确定了有关参数。

Based on simulating model test and theoretical analysis, the mechanism of main roof first breaking is revealed, and the asymmetry breaking parameter is determined.

26. 而定位格架的表面颜色、钎焊缝质量、外形尺寸、破断力和结合层厚度均达到钎焊技术要求。

The grids completely meet with the requirements for soldering on surface color , welds quality, overall dimension, rupture stress and joint thickness.

27. 得出了煤层倾角、水平分段高度对顶板变形的影响关系曲线,同时,给出了顶板破断的判据。

Relationship curves between seam dip Angle, horizontal section height and roof deformation are derived, at the seam time, the criterion of failure is given in this paper.

28. 通过岩矿的抗压强度和自然矿块破断力力学试验研究,找到了降低粗磨机钢球尺寸的理论依据。

Theoretical reason of reducing ball size of coarse grinding has been found through tests on compressive strength of rock and rupture stress of natural ore lump.

29. 通过岩矿的抗压强度和自然矿块破断力力学试验研究,找到了降低粗磨机钢球尺寸的理论依据。

Theoretical reason of reducing ball size of coarse grinding has been found through tests on compressive strength of rock and rupture stress of natural ore lump.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!