轴比用英语怎么说,轴比的英文翻译


词语导航

基本信息

词语:轴比

繁体:軸比

拼音:zhóu bǐ

英语翻译

【医】 axial ratio

分词翻译

轴的英语翻译:

axes; axis; shaft; spindle
【医】 ax-; ax.; axes; axio-; axis; core

比的英语翻译:

compare; compete; ratio; than
【医】 proportion; ratio
【经】 Benelux; benelux customs union; benelux economic union

翻译例句

1. 总体上它们是圆的,但沿一根轴比另一根轴延伸得要更长一些。

They are generally round but stretch longer along one axis than along the other.

2. 实测数据处理结果表明,该方法能有效估计出目标长短轴比值。

The result using real data shows that this method is feasible to estimate the effective axial ratio of space object.

3. 基本设置:选择板子类型,温度传感器类型,轴比率,及限位开关设置。

BASIC SETTINGS: select your board type, temperature sensor type, axis scaling, and endstop configuration.www.wENtIyI.cOM

4. 提出了一种新的损伤塑性本构模型,强调了应力三轴比对塑性屈服的影响。

A plastic constitutive damage model was proposed with special concerns being put on simulating the stress triaxiality-dependent hardening phenomena.

5. 目的:探讨用离轴比曲线分析电子束照射野笔形束模型能量展宽函数的方法。

Objective:To derive the energy spread function of the electron pencil beam model from the measured beam profiles.

6. 由于去二级链接轴比接近原点,所有的元素,它坐在优于到了二级轴线的成员。

Because that axis goes nearer the origin than the L2 link axis, all the elements that sit on it are superior to the members of the L2 axis.

7. 本文针对多轴比例恒幅加载情况下的缺口件进行了应力应变分析和寿命预测研究。

In this paper, the stress-strain analysis and life prediction for the notched shafts were studied under multiaxial constant amplitude proportional loading.

8. 在一定轴比带宽条件下,优化后的十字振子天线正交方向上圆极化轴比可以达到1。

Under certain axis ratio bandwidth, the circular polarization axis ratio of the optimized cross dipole antenna can reach 1.

9. 得到了复合材料传动轴比钢、铝合金传动轴运动稳定性好、主共振的振幅小等结论。

Conclusions of that the motion stability of a fiber composite drive shaft is better and the main resonance amplitude is smaller than that of a drive shaft of steel or aluminum are produced.

10. 讨论了堆积结构、方位因子、形状因子、取向因子、轴比和粒度均匀性对堆积系数的影响。

The effects of packing structure, azimuth factor, shape factor, orientating factor, axis ratio and size uniformity on the packing fraction have been also evaluated.

11. y轴比例因子是在第104行计算的,方法和上面的柱状图使用的方法一样(请参阅清单2)。

The Y-axis scaling factor is calculated on line 104 in the exact same way as in the bar chart example (see Listing 2).

12. 利用扫描电镜对多轴比例和非比例加载下的薄壁管多轴疲劳试样的断口表面进行扫描观测分析。

The fatigue fracture surfaces of multiaxial fatigue specimens subjected to proportional and non-proportional multiaxial loadings were observed and analyzed by using the scan electron microscope.

13. 介绍了一种六角晶系铁氧体轴比及晶粒均匀性的控制方法,并对烧结磁体取向度的提高作了讨论。

In this paper, a control method of axis ratio and grain distribution of hexagonal ferrite is introduced, and improvement of sintered magnet orientation is discussed.

14. 结果表明,本文所提出的多轴疲劳损伤参量既可用于多轴比例循环加载,也可用在非比例加载条件下。

The results show that multiaxial fatigue damage parameter presented in this paper may be used under either proportional or non proportional loading.

15. Y 轴比例因子是在第 104行计算的,方法和上面的柱状图使用的方法一样(请参阅清单2)。

The Y-axis scaling factor is calculated on line 104 in the exact same way as in the bar chart example (see Listing 2).

16. 给出理论和实验结果,证明了这种四层曲折圆极化器可以在倍频程范围内得到良好的低轴比、低损耗特性。

The theoretical and experimental results are presented, which show the low axial ratio and low loss characteristics over octave frequency band of the polarizer.

17. 结果表明,开裂点、开裂角、最大切向拉应力和临界载荷随椭圆的纵横轴比和倾角的不同而变化,由此可得到最危险的倾角。

The results show that opening point, opening angle, maximal tangential stress and critical load vary with aspect ratio and inclined angle. The most dangerous inclined angle is obtained accordingly.

18. 这些方法分别采用单点馈电,多点馈电或多元组合实现圆极化,均有效拓展了圆极化天线的阻抗匹配带宽和圆极化轴比带宽。

In the methods, single feed, more feed and several patches consisting circular polarization are used to feed the antenna and improve the impendent or ar bands.

19. 与正常窦性心律时的额面平均心电轴比较,RVIS起搏时接近正常,RVOT起搏时电轴呈右偏趋势,RVA起搏时呈左偏趋势。

The QRS axis was of no significant difference between RVIS pacing and sinus rhythm. However, there were tendency toward right deviation at RVOT pacing and toward left deviation at RVA pacing.

20. 设计的组合天线具有良好的电磁兼容性,仿真结果表明该天线对于接收“北斗”和GPS信号都具有较好的圆极化轴比和增益方向图。

The simulation indicated that the polarization axial ratio and antenna gain pattern of this antenna are good for "BD-1" signal and GPS signal.

21. 脱层区域假定为椭圆形状,本文研究了在双轴载荷作用下对称正交铺设层板脱层屈曲的临界载荷,脱层厚度、半轴比、子层角以及载荷比对临界载荷的影响均进行了研究。

The delamination is assumed to be elliptical in shape. In this paper the critical load of delamination buckling for a symmetric cross-ply laminate acted on by biaxial load is investigated.

22. 脱层区域假定为椭圆形状,本文研究了在双轴载荷作用下对称正交铺设层板脱层屈曲的临界载荷,脱层厚度、半轴比、子层角以及载荷比对临界载荷的影响均进行了研究。

The delamination is assumed to be elliptical in shape. In this paper the critical load of delamination buckling for a symmetric cross-ply laminate acted on by biaxial load is investigated.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!