酯胶用英语怎么说，酯胶的英文翻译

词语导航

基本信息

词语：酯胶

繁体：酯膠

拼音：zhǐ jiāo

英语翻译

【化】 ester gum

相关词条

1.rosinglycerinester  

分词翻译

酯的英语翻译：

ester
【化】 ester
【医】 compound ether; ester; lactam; lactan

胶的英语翻译：

glue; gluey; mucus; pastern; sticky
【医】 gloea; glue

翻译例句

1. 通过溶液聚合法制得了阻燃性丙烯酸酯胶。

Fire retardant acrylic ester was prepared by the radical copolymerizations.

2. 由于异氰酸酯胶的价格比较贵，影响了麦草刨花板的成本和市场竞争力。

Because the diisocyanate price quite, Has affected the wheat straw shaving board cost and the market competitive power.

3. 不同的改性剂对复合材料的性能产生不同的影响，异氰酸酯胶改性效果比较好。

Different modifiers had different effects on the properties of wood-polymer composites, and comparatively the modifier of iso-cyanate produced a better result.

4. 介绍了需氧胶的特性、用途及制备方法，并与二代丙烯酸酯胶、厌氧胶作了对比。

Performances, applications and preparation of aerobic acrylic adhesives were introduced in comparison with 2nd generation and anaerobic acrylic.

5. 本文研究了固化时间与粘接强度的关系，而且应用红外光谱研究了第二代丙烯酸酯胶的固化机理。WwW.WentIYI.coM

In this paper, the relationship between the solidification time of SGA and its shear strength has been studied. On the other hand, solidification mechanism of SGA also has been studied by the IR.

6. 介绍了由磷酸酯胶凝剂、交联剂、表面活性剂、激活剂和破胶剂组成的具有特殊性能的油基冻胶压裂液体系。

A special oil-based gelled fracturing fluid, Which combines gellant, crossing-linking agent, surfactant, exciting agent and breaker is presented and tested.

7. 讨论了聚乙烯醇缩甲醛胶、聚醋酸乙烯酯胶、脲醛胶、淀粉胶的改性途径，介绍了各改性产品的配方及其性能比较。

Ways to modify the gels of polyvinyl formal, polyvinyl acetate, urea-formaldehyde and amylum are plesented and formulae and alternate properties of various modified products introduced.

8. 方法采用1%晔康杀蟑胶饵和0.5%氯菊酯的烟雾剂，密度监测采用粘捕法。

Methods 1%yekang cockroach gel bait and 0.5% Permanone smoke fog were used for chemical control. Adhesive killing method was applied in density investigation.

9. 本研究采用丙烯酸酯单体聚合制成一种全新的合成冷封胶。介绍了制备方法和有关性能。

The preparation process and the related properties of the cold-seal adhesive polymerized from acrylate monomers were included in the paper.

10. 以甲基丙烯酸甲酯为硬单体，丙烯酸丁酯为软单体，丙烯酸为功能单体，环氧树脂为改性剂制备了密封胶用环氧改性丙烯酸树脂。

The epoxy modified acrylate resin for sealant is prepared with methyl acrylate as hard monomer, butyl acrylate as soft monomers, acrylate acid as functional monomers and epoxy resin as modifier.

11. 探讨了松香酯结构与施胶性能的关系，研究了施胶条件对松香酯施胶效能的影响。

Relationship between structures of rosin esters and sizabilities was illustrated and effects of sizing conditions on the sizability were investigated.

12. 探讨了油基压裂液胶凝剂磷酸酯的合成条件，进而对配制的压裂液性能进行了评价。

The synthesis condition of gelling agent phosphate ester in oil base fracturing fluid is studied on this paper.

13. 通过实验发现催化剂、脱水剂、增塑剂以及游离的异氰酸酯含量对密封胶的表干时间有很大的影响。

Through the experiment, it is found that the tack free time is affected greatly by the content of catalyst, dehydrating agent, plasticizer and the free NCO.

14. 本产品由四部分组成：树酯，亚克力胶，聚酯膜，BOPP膜。

This product is made of Polyacrylate Emulgion, Pet Film and BOPP Film.

15. 褐藻糖胶是存在于褐藻中的硫酸酯多糖，具有多种生物活性。本文综述了褐藻糖胶的提取、纯化和分级等方面的研究工作。

Fucoidan is a sulfated polysaccharide from brown seaweed, which has a variety of biological activities. the studies on the extraction, purification and fraction of fucoidan are summarized.

16. 海水富含多种矿物质成分，与生育酚乙酸酯一起配合富含自然多糖的黄原胶，令肌肤有光泽细腻。

Rich in various minerals, sea water works well with tocopheryl acetate and Xanthan, the latter with abundant natural polysaccharides, making the skin illuminating and smooth.

17. 异氟酸酯、多元醇、硅烷等原材料的选择以及异氰酸酯基与羟基的配比是影响S PU密封胶性能的主要因素。

The selection of raw materials such as iso- cyanate, polyol and silicone etc, and the ratio of isocyanate and hydroxy are the main factors affecting the properties of SPU sealant.

18. 论文最后对异氰酸酯热压胶接木材的强度与反应程度之间的关系作了初步研究。

Finally, the bonding strength of IC resin and wood under hot pressing was tested. The relationship between bonding strength and reaction degree was analyzed.

19. 氯丁橡胶（CR）、甲基丙烯酸甲酯（MMA）和丙烯酸（AA）在低毒溶剂中接枝成胶。

The chloroprene rubber(CR) combined with methyl methylallate(MMA) and allenoic acid(AA) to obtain graft adhesive in low poisonous solvent.

20. 选用聚合物H和改性异氰酸酯K为主要原料合成聚氨酯灌封胶。

Polyurethane (PU) pouring sealant was synthesized with polymer H and modified isocyanate K as basic materials.

21. 通过硫化曲线评定，选用苯甲酸铵作硫化剂对环氧型丙烯酸酯橡胶低温胶进行硫化。

Through vulcanization curves evaluation ammonium benzoate was selected as the vulcanizing agent of epoxy acrylate rubber (EACM).

22. 考察了扩链剂种类、活性稀释剂及异氰酸酯对聚氨酯灌封胶力学性能的影响。

The effect of kinds of chain extender, active diluents and the structure of isocyanate on mechanical properties of the elastomer is discussed.

23. 探讨了正硅酸乙酯的溶胶-凝胶过程中，氢氟酸，盐酸，氨水，硫酸和醋酸等催化剂对水解、聚合和胶凝时间的影响。

In the sol_gel process of TEOS (tetraethoxysilane), the effects of catalysts on hydrolysis reaction, condensation reaction and gelling properties were discussed.

24. 本文针对涤纶帘子布和ep、EE帆布的二浴浸胶工艺，对封闭异氰酸酯的性能及应用进行了研究。

The performance and application of blocked diisocyanate as dipping adhesive activated agent for polyester tire cord and EP, EE conveyor fabric double dipping process are studied in this paper.

25. 通过采用预乳化和半连续法乳液聚合工艺，合成了一种水乳型丙烯酸酯复合胶。

A type of acrylic emulsion adhesive was prepared by pre-emulsion and half-continued polymerization.

26. 为了开发微生物油脂生产微生物柴油，以胶红酵母油脂为材料，以脂肪酸不饱和指数（UIFA）为指标，探讨了微生物油脂生成脂肪酸甲酯工艺的影响因素。

To produce micro-biodiesel from microbial oil, transesterification conditions were studied using oil from Rhodotorula glutinis as raw material using unsaturation index of fatty acid (UIFA)as index.

27. 本研究制备了多种烃基松香酯松香施胶剂及松香甘油酯松香施胶剂，并对其在中、碱性造纸施胶中的应用进行了探讨。

Several alkyl rosin ester rosin sizes and glycerin rosin ester rosin size were prepared and used for paper sizing under neutral alkaline conditions.

28. 本文以差热扫描量热法（DSC）分别研究了脲醛（UF）胶、聚异氰酸酯（PMDI）胶以及它们的混合液的加热固化过程。

The curing processes of urea-formaldehyde(UF) resin, polydiphenylmethane diisocyanate (PMDI) and their mixtures were examined respectively by differential scanning calorimetry (DSC).

29. 以瓜尔豆胶、卡拉胶、分子蒸馏单甘酯、乙醇、水、杀菌剂和防腐剂配制的涂膜保鲜剂，处理毛叶枣果实可延长其货架寿命。

The results indicated that the compound coating agents are better than the single coating agents for the shelf life of ber.

30. 以瓜尔豆胶、卡拉胶、分子蒸馏单甘酯、乙醇、水、杀菌剂和防腐剂配制的涂膜保鲜剂，处理毛叶枣果实可延长其货架寿命。

The results indicated that the compound coating agents are better than the single coating agents for the shelf life of ber.