水力泵用英语怎么说,水力泵的英文翻译


词语导航

基本信息

词语:水力泵

繁体:水力泵

拼音:shuǐ lì bèng

英语翻译

【化】 hydraulic pump

分词翻译

水力的英语翻译:

hydraulic power; waterpower
【电】 hydraulic power; water power

泵的英语翻译:

pump
【化】 pump
【医】 pump

翻译例句

1. 水力泵排液工艺技术适用于深浅层试油排液的工艺要求。

Oil testing application of hydraulic pump on fluid unloading in Hailaer Basin;

2. 水力泵排液工艺技术适用于深浅层试油排液的工艺要求。

Research and application of the multi-layer fracturing and flowing back without pulling string technology;

3. 针对海拉尔探区中深井排液难的问题,探讨了利用长钢丝绳抽汲排液及水力泵排液求产方法。

According to flowing back problem at Hailaer exploration district, a method of unflowing to acquire production by using long steel line and hydraulic pump is discussed.

4. 石膏浆液从吸收塔反应箱中排放出来,然后通过一台石膏排放泵的运行,被传送到水力旋流站。

The gypsum slurry exits the absorber reaction tank and it is conveyed to the hydro cyclone by using one of the gypsum bleeding pumps.

5. 从结构型式、水力设计、密封型式等方面论述了磷复肥料浆泵设计的有关问题。

Introduced are some problems concerning the design of compound phosphate fertilizer thick liquid pump in the light of its structure, hydraulic design, and sealing.

6. 泥泵是水力输送式挖泥船的关键设备。

The slurry pump is one of the key facilities of a dredger.

7. 本文论述了HD型石油化工流程泵在开发研制过程中结构、水力设计以及密封问题上的思考,与化工行业的同行进行交流。

This paper discussed thoughts of structure design, hydraulic design and seal design of HD type petrol - chemical process pump, in order to communicate with experts in petrol - chemical industry.

8. 介绍了主要用于吸泥的双流道无堵塞泵的水力、结构设计。

This paper introduces the hydraulic and structure design of double channel non-jamed pump for sucking sludge .

9. 在合理确定吸入系统的装置方面,提出了减少吸入管路的水力损失和在吸入系统安装低速前置泵的改进措施。

And also puts forward improving measures for reducing hydraulic loss in suction piping and installing low speed prime pump in suction system.

10. 分析总结了多功能水力(泵)控制阀的工作原理和功能,详细阐述了其在江西新余钢铁有限责任公司第一动力厂高炉循环水系统中的使用情况和应用效果。

This paper analyzed the principle and function of the multi-purpose hydraulic control valve in the circulating-water system of BF and its application and effect was introduced.

11. 文章介绍一种用于从河底吸取泥砂并且有自吸排气的离心式多相流泵的结构及水力设计。

This paper introduces the structure and hydraulic design of the multiphase flow centrifugal pump, which draught sands from the riverbed and discharge the air of the suction pipe.

12. 论述了双吸离心泵增大高效点流量、提高水力性能的原理、方法、实施过程及改造结果。

The principle, method, design process and change result to enlarge capacity of maximum efficiency running point and improve hydraulic performance of double suction pump were presented.

13. 本文主要研究混流泵出口环量对泵出水管道水力特性的影响。

The influence of outlet circulation of mixed-flow pump on the hydraulic performance of the outlet pipe was studied in this dissertation.

14. 测试仪器安装在水力活塞泵泵芯尾部取样器内,随泵芯投入井下进行测试,可实时检测地层液的含水率情况,利用数据存储器实时保存历史曲线,提供了全天候观测生产过程的手段。

Testing instrument was installed in sampler at heel of hydraulic pump, put into down-hole with pump, and it can examine water cut of formation fluid, save history curves in real time by data memory.

15. 通过水力计算,校核了离心泵的实际工作点。

The actual operating point of pump is checked out by means of hydraulic calculation.

16. 对低比转速离心泵叶轮的水力设计具有一定的指导意义。

Results of this thesis provide guiding significance to waterpower design of impeller of the low specific speed centrifugal pump.

17. 建立了下开式水锤消除器在泵系统水力过渡过程计算中的数学模型。

A mathematical model of water hammer arrester with the lower open type in calculating the hydraulic transient in the pump systems is established.

18. 坚固的GIW泥浆泵具有持续水力效率,长抗磨损寿命,降低成本。

Rugged GIW slurry pumps provide high sustainable hydraulic efficiency, and long wear life at the lowest total cost of ownership.

19. 离心泵是一种通用水力机械,其内部流动情况一直是泵设计人员十分关注的问题,因为泵内流动的优劣直接影响泵的性能。

Centrifugal pump is a commonly hydraulic machine, whose inner flow has direct influence on pump"s performance and is a considered problem by the pump designers.

20. 该方法对于水力定向时的水力参数设计及钻井泵工况选择具有指导意义。

The method noted above has significance for guiding hydraulics and pump working condition design in hydraulic orientation.

21. 但有人对此提出了不同意见,认为该地区的机械采油应首选水力活塞泵。

However, someone thinks that the optimum oil recovery mode of Lunnan oilfield should be hydraulic piston pump.

22. 本文分析了泵及泵装置的水力损失和水力效率的关系,推求出了泵装置的最高效率工况点。

The most efficient work point of of the pump device was deduced after the analysis of the relationships between hydropower loss and hydropower efficiency in pump and pump device.

23. 实验证明通过改变叶片型线参数方程中的速度系数的取值,可以控制边界层的分离,进而改善泵的性能,提高其水力效率。

The experiment shows that by changing the velocity coefficient , the separation of boundary layer on pump vane can be controlled, and the performance of pump is improved and its hydraulic efficiency.

24. 提供定制制造的感应电机,成为各种应用的理想选择:泵,风扇,水力学,机械,传动系统,医疗,航空和工业。

ARC Systems, Inc. offers custom fabricated Induction motors ideal for various applications such as: Pump, Fans, Hydraulics, Machinery, Actuation Systems, Medical, Aerospace and Industrial.

25. 开发初期,主导开采方式主要以“水力活塞泵、闭式热水循环”等采油工艺为主。wwW.WENTIYi.COM

At the initial stage of development, the main oil production methods give priority to hydraulic piston pump and closed hot water circulation.

26. 通过阐述浆泵叶轮的若干原理,提出对浆泵叶轮水力特性的认识,并应用于解决实际问题。

The hydraulic principles of a pulp pump were discussed and a new understanding for the hydraulic characteristic of pump impeller was proposed.

27. 为了提高泵的水力效率,泵壳体采用流线型设计,同时加大了壳体的通流面积。

In order to improve the water power efficiency of pump, casing applies streamline design, the circulation area is increased.

28. 叶片水力矩的变化与泵性能参数的变化密切相关,应引起泵设计人员的充分重视。

The change of hydraulic moment on blades is closely related with pump characteristics, which should arouse the attention of pump designers.

29. 当混合比例超过20%以上时,消防泵则选择该泵时,试压泵需要对水力特性进行更新。

When when mixed proportion exceeds more than 20%, choose this pump, need entering even more to the water conservancy characteristic.

30. 当混合比例超过20%以上时,消防泵则选择该泵时,试压泵需要对水力特性进行更新。

When when mixed proportion exceeds more than 20%, choose this pump, need entering even more to the water conservancy characteristic.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!