轴下的用英语怎么说,轴下的的英文翻译


词语导航

基本信息

词语:轴下的

繁体:軸下的

拼音:zhóu xià de

英语翻译

【医】 subaxial

分词翻译

轴的英语翻译:

axes; axis; shaft; spindle
【医】 ax-; ax.; axes; axio-; axis; core

下的英语翻译:WWW.WENtIYI.cOm

below; descend; down; give birth to; give in; go to; leave off; lower; next
take
【医】 cata-; hyp-; infra-; kat-; sub-

翻译例句

1. 介绍了SZT-1 型单轴转台的设计及低温环境下正常工作的实现。

The design of SZT-1 gyrometer test table and the realization for its working at the low temperature are introduced.

2. 这样想一下:如果你旋转什么东西,这个轴的方向将会变化。

Imagine it like this: If you spin something, the direction of the axis tends to wobble.

3. 在这种情况下,我假设该圆柱是以柱轴跟地面平行的方式下落的(这样才能使人背部着地)。

In this case I will assume the cylinder is falling with the axis of the cylinder parallel to the ground (so the person would land on the back).

4. 在这个情况下,架构可以被认为是静态的,因为整个系统状态在时间轴上的任意一点都是确定的。

In this case, the architecture can be considered static because the entire system state can be determined at any point in time.

5. 第二根轴上的线表示各运行时模式下的总体性能改善。

The line on the secondary axis represents the overall performance improvement for each of the run time modes.

6. 这种方式下,x坐标轴和y坐标轴的标签将会使用本地化的业务名称来表示,而不是用面向开发人员的对象名称来表示。

In this way, label of X-axis and Y-axis will be represented using localized business name, instead of developer-oriented object name.

7. 默认情况下,时间(x轴上的单位)的显示单位为秒。

By default, time (the units on the X-axis) is shown in seconds.

8. 可以做练习来检验一下的,实际上很简单,假定有围绕x轴一起旋转的流体。

An exercise that you can do, which is actually pretty easy to check, is say that we have a fluid that is just rotating about the X-axis uniformly.

9. 我告诉他把鼠标底部的小球取出来,然后擦一下里面的两个轴就可以了。

I told him at the bottom of the mouse out of the ball, and then wipe the two-axis inside it.

10. 在这种情况下,对计算力矩所环绕的轴的最佳选择是梯子的底部。

In this case, the best choice for the axis around which to calculate torques is the base of the ladder.

11. 发现在旁轴近似下,匹配函数的最大值随泵浦光发散角的增大而增大,在考虑到像散的影响后,得到泵浦光发散角的参考值。

At paraxial approximation the maximum of the matching function is increasing with increased divergence Angle. For different brightness of pumping light, the optimum value of the Angle is obtained.

12. 在时间轴中的任何地方按一下,分析器窗口的底部区域会显示选定的帧的详细信息。

By clicking anywhere in the timeline, the bottom section of the Profiler window will display detailed information for the selected frame.

13. 该法可以对在弯矩、剪力和轴力共同作用下的钢筋混凝土梁截面进行较为准确的荷载-变形反应全过程分析。

This method can be used to analyze accurately the complete load-deformation response of RC beams loaded in combined shear, moment, and axial load.

14. 在冷热两种状念下进行了轴系合理校中计算,并确定中间轴临时支承的位置、法兰间偏移与曲折值各安装工艺参数。

Rational aligning calculation of propulsion shafting in cold and warm conditions, and confirm several fitting technics parameters include of temporary supports, sags and gaps between flanges.

15. 本文在总结前人工作的基础上,对结合梁斜拉桥中在轴力和弯矩共同作用下的钢—混凝土组合梁截面受力状态和混凝土桥面板有效宽度进行研究。

This paper deals with the mechanical behaviors of steel-concrete composite beam and effective width of concrete slab on the axial force and the bending moment together function, based on the past job.

16. 图7:轴位CT脑池造影显示硬膜下造影剂沿着中隔渗漏到扩张的右侧蝶窦腔内。

Figure 7: Axial image from CT cisternogram demonstrates intrathecal contrast leaking into the expanded right sphenoid sinus along the septum (orange arrow).

17. 与下轴浮动式圆盘飞剪相比,该新型剪机的结构简单,受力合理,刚度及剪刃寿命提高,且维修方便。

This new shear has simple structure, reasonable stress, high rigidity, long service life and convenient maintenance compared with low shaft floatation disc fly shear.

18. 本文运用电磁场的梯度矢势分析了一般情况下傍轴光束的衍射传输问题。

In this paper the transmission of paraxial light beams was analyzed based on the gradient vector potential of electromagnetic field.

19. 此外,按摩轮支架装配有具有上铰接点和下铰接点的凸缘,其中上铰接点连接至所述颈臂,下铰接点连接至上述轴。

Moreover, the wheel support is fitted with a flange with an upper articulation point connected to the cervical arm and a lower articulation point that is connected to aforementioned shaft.

20. 整个旋转总装都应该具有足够的硬度,即使在极端的泵运行环境下,所产生的轴偏差也是最小的。

The entire rotating assembly shall be designed with sufficient rigidity for minimal shaft deflection at extreme pump operating conditions.

21. 在阶跃轴压载荷情况下,动力载荷可能激发比静力载荷更高阶的屈曲模态。

Under the axial step load case, dynamic load tends to inspire a higher order buckling mode .

22. 在近距离空中支援的势态下,飞行员能够确定敌人的位置并进行离轴瞄准,然后转身接近并投放武器,这样就可以使暴露给地面的威胁最小化。

In a close air support situation, the pilot can locate and off-boresight target the enemy, come around and release weapons, and thus minimize exposure to ground threats.

23. 此外,我们也在(110)方向的矽基板上作了相同的实验,并且讨论其在双轴的伸展应力下金氧半电容的平带电压的移动情况。

Moreover, we done the same experiment on the (110) orientation Si and discuss flat-band voltage shift of MOS capacitor under biaxial strain.

24. 有限元计算表明,网格墙在轴力和水平力作用下的正应力分布与实体墙总体上一致;

The finite element analysis showed that the normal stress distribution of the grillage wall was about the same as that of the solid wall.

25. 选用具有典型细观结构特征的球墨铸铁材料进行试验,探讨这种金属材料在各种三轴应力状态下的细观损伤破坏。

Nodular cast iron specimens with typical mesostructure are tested to study the meso damage evolution and failure mechanism at different triaxial stress states.

26. 通常情况下,气井井轴周围的高速流动为非达西流动,产生附加压降。

Generally, flow at high velocity around well bore in gas well is belong to non-Darcian flow which arising adding pressure drop.

27. 为了解决油管偏磨问题,对内压和轴力作用下的无偏磨、单面偏磨和双面偏磨油管分别进行了有限元(AN - SYS软件)模拟研究。

In order to solve the eccentric worn problem of tubing, deformation finite element simulation of the eccentric worn tubing was carried out with ANSYS software under internal pressure and axial load.

28. 如不成立,那么,玻璃材料在双轴应力状态下的裂纹扩展由什么参数决定?

If not existing any more, then what is the parameter of crack extending when glass in biaxial stress state?

29. 如不成立,那么,玻璃材料在双轴应力状态下的裂纹扩展由什么参数决定?

If not existing any more, then what is the parameter of crack extending when glass in biaxial stress state?

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!