节距用英语怎么说,节距的英文翻译


词语导航

基本信息

词语:节距

繁体:節距

拼音:jié jù

英语翻译

【化】 pitch; step

分词翻译

节的英语翻译:

period; node; abridge; burl; chastity; knar; part; section
【化】 node
【医】 article; mere; metamere; sectio; section; segment; segmentum

距的英语翻译:

be apart from; distance
【医】 calcar; calcaria

翻译例句

1. 盘旋经常改变回转方向和节距。

Convolutions frequently alternate in direction of rotation and vary in pitch.

2. 具有可选风扇节距控制的翼式轴流风扇。

Vane axial fan with optional fan pitch control.

3. 说明应该是你的切削截面和节距不符合。

It shows your cut section didn"t meet the requirement of pitch.

4. 据此提出了窄节距低割茬切割器的设计依据。

The paper gives the design of the narrow pitch and lower stubble cutting apparatus.

5. 确定节距的方案,基本与确定节长的方案一致。

The scheme of the slubby space is consistent with that to the slubby length.

6. 给出了链条节距精度和链长精度的随机函数关系。

A stochastic function for the relationship between the chain length and the chain pitch is given.

7. 试验了不同节距的螺旋扭状钢筋的粘结锚固性能。

The bond anchorage properties of the rolled and twisted bars with different pitch of twist were studied.

8. 数值研究了蒸汽透平静叶节距变化对级性能影响。

Numerical investigations about the influence of changing stator solidity on the steam turbine stage performance are presented.

9. 而横向节距和纵向节距对换热的影响程度基本相同。

Both transversal pitch and longitudinal pitch influence the heat transfer of longitudinally finned tube Banks to the same degree.

10. 两者之间的关系基本上由被切削螺纹所需的节距决定。

The relationship between both is determined primarily by the desired pitch of the thread to be cut.

11. 其原因是链条节距因磨损增长,传动时打折卡住抻断。

The reason is that pitch chain growth due to wear and tear, transmission stuck at a discount off stretch.

12. 该履带的节距、履带板数、履带板宽与普通的履带相同。

The pitch, Numbers and width of track shoes are the same with the general track.

13. 丝杆旋转一圈,大拖板就行进等于丝杆节距的一段距离。

When the lead screw rotates a single revolution, the carriage travels a distance equal to the pitch of the lead screw.www.WENtIYi.COM

14. 用调整网带的节距的方法,就可把各种型式的链条装上去。

Various types of chain can be applied by adjusting belt pitch.

15. 而编织工艺参数众多,其中花节距和编织角是最基本的参数。

Among all the parameters, the pitch length and the braiding Angle are the basic parameters.

16. 结果表明,错齿翅片的节距和长度对其热工性能影响最为显著。

The results show that fin length and flow length have more obvious effect on the thermal hydraulic characteristics of offset strip fins.

17. 求解变位系数和最小齿数的方法可适用于所有节距的齿形链机构。

The approach presented to achieve the modification coefficient and the minimum tooth number is applicable to the silent chain mechanism with all kinds of pitches.

18. 最后讨论了链节的受力分析,链传动结构容纳节距伸长能力问题。

Finally, the analysis of the Force attached to chain tooth and the capability for permitting pith to get longer are discussed.

19. 要降低噪音,最简单的方法是增大旋翼桨叶的夹角,也叫“节距”,或是降低转速。

The simplest way to dampen a helicopter"s noise is to increase the Angle of the rotor"s blades, also called the pitch, and slow them down.

20. 本文叙述了填充因子与电缆参数(股数、股径、节距和截面尺寸)之间的关系。

An account is given of the relationship between the packing factor and the cable parameters, which include the number of strands, strand diameters, twist pitch and dimensions of the cable.

21. 因此,在实际工程应用中,可以用双节距滚子链与相应的单节距链轮配套使用。

Therefore, in practical engineering applications, we can use double-pitch precision roller chain instead of single-pitch roller chain.

22. 输送链条:采用杭州链条厂出产的C212一寸双节距单则耳高强度双孔链条。

Transport chain:Adopt chain in Hangzhou the factory produce of C212 a stanza is apart from a list then an ear a high strength double a bore chain.

23. 讨论远心投影物镜像差和CCD节距的关系,给出远心投影物镜校正像差的依据。

The relation between aberrations of the telecentric projection objective and the pitch CCD is discussed. The criterion of correcting aberrations in the telecentric projection objective is also given.

24. 为了获得最佳磨损寿命,2个链轮间的中心距通常应是链条节距的30至50倍。

For optimum wear life, centre distance between two sprockets should normally be within the range 30 to 50 times the chain pitch.

25. 结果表明:不同的氮用量和密度对伊兹密尔的株高、茎围、节距和叶片大小影响较大。

The results showed that there were greater effects of nitrogen rates and density on plant height, stalk width and leaf size.

26. 冷轧扭钢筋在应用中除应保证其强度、延性外,还应满足标准规定的厚度和节距要求。

During the application of cold-rolled and twisted bars, not only should it pledge bars strength and ductility, but also it should fulfill requirements of bars standard thickness and panel length.

27. 绝缘线对:把单根绝缘线按不同的节距扭绞成对,采用规定的色谱组合,以便识别线对。

Twisted pairs: Individual conductors twisted into pairs with varying lay length and with specified color combinations to provide pair identification.

28. 检查钢丝绳,若发现钢丝绳在一个搓绕节距长度内折断根数超过6根时,需更换新的钢丝绳。

Check the steel rope. If the broken number exceeds 6 within a lay length, a new steel rope will be needed.

29. 从气动声学理论出发,探讨了贯流式风机气动噪声机理及不等节距叶片频率调制降噪的机理。

Based on the theory of airacoutics, the mechanism of denoising of cross_flow fan and the modulation of unequal spaced blades is discussed.

30. 从气动声学理论出发,探讨了贯流式风机气动噪声机理及不等节距叶片频率调制降噪的机理。

Based on the theory of airacoutics, the mechanism of denoising of cross_flow fan and the modulation of unequal spaced blades is discussed.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!