故障电阻用英语怎么说,故障电阻的英文翻译


词语导航

基本信息

词语:故障电阻

繁体:故障電阻

拼音:gù zhàng diàn zǔ

英语翻译

【电】 fault resstance

分词翻译

故障的英语翻译:

breakdown; fault; hitch; malfunction; stoppage; trouble
【计】 booboo; F; failure; fault; malfunction
【化】 malfunction
【经】 breakdown; trouble

电阻的英语翻译:

resistance
【计】 ohmic resistance; R
【化】 resistance
【医】 resistance

翻译例句

1. 算法不受故障类型、故障电阻、系统阻抗、负荷电流的影响。

The algorithm does not need fault type identification, and is not affected by the fault resistance and pre-fault load.

2. 而且该保护判据不受故障位置、故障电阻、故障类型和故障时刻的影响。

And this criterion cannot be affected by faults position, faults resistance, faults type and faults occurring time.

3. 算法无需故障类型判别,不受系统阻抗、故障电阻、负荷电流以及分布电容的影响。

The algorithm does not need fault type identification, and its accuracy is not affected by fault resistance, system impedance, pre-fault load current and shunt capacitance.

4. 利用线模电流的小波变换系数进行测距,不仅不受故障电阻的影响,也不受故障起始角的影响。

The location result is not influenced by fault resistance and inception Angle when wavelet transform coefficient of aerial mode current is used in fault location.

5. 行波测距法具有较高的可靠性和精度,抗干扰能力强,且不受故障电阻及系统运行方式的影响。

The traveling wave fault location has high reliability accuracy and anti-disturbance capability , and it also immunes from the fault resistance and the neutral grounding modes.

6. 利用功率平衡理论进行故障测距能够在原理上克服传统阻抗法普遍存在的受故障电阻影响的缺陷。

The location results are always affected by fault resistance in almost all conventional impedance methods in fault location, but the application of power balance theory can overcome the shortcoming.

7. 该算法利用序网络分解法对故障网络进行分析,得到基于单端电气量故障距离一般表达式,该算法消除了故障电阻的影响。

Using one-terminal data, the algorithm analyzes fault network by sequence networks method and get the formula of fault location, eliminating the effect of fault resistance.

8. 分析了采用小电阻接地系统的必要性及该系统的故障特性。

The necessity of low resistance ground system and its fault characteristic were analyzed.

9. 这会导致接触电阻故障。关于该问题将会在本章随后讨论。

This causes contact resistance failures, which will be discussed later in this section.

10. 随动电桥断路或高电阻出现,故障是汇电环、电刷、或放大器。

The follow bridge circuit has cut off or high resistanced. The trouble is convergence coil, brush or amplifier.

11. 对故障点的过渡电阻还列出一些国外的经验计算式及其典型数据,这对校验保护装置灵敏度是十分必要的。

In addition to pointing out some experienced formulas abroad for taking count of the resistance of the fault itself and its typical data.

12. 现场总线在应用中主要考虑其通信电缆、通信电源故障,“T”型分支或终端电阻故障也会引起总线故障。

The main facts we should consider are the trouble caused by the communication cable, communication power, t type branch or the terminal resistor problem in the application of site bus technology.

13. 深入细致地分析了谐波、间歇电弧、电流互感器、负荷、过渡电阻等多个因素对故障选线结果的影响,为方案的实用化奠定了基础。

The influences of several factors such as harmonics, intermittent arc grounding, ct, load and fault resistance have been thoroughly analyzed, therefore, it is fundamental work for its application.

14. 传统的阻抗法进行故障定位,难以克服过渡电阻等因素的影响。

The traditional fault location method based on impedance can not overcome the effects of transition resistance, etc.

15. 结果表明,阻性短路产生了时序故障,小电阻缺陷甚至产生了布尔故障。

The results show that these defects result in timing failures and even Boolean faults for small defect resistance values.

16. 对电缆接头故障进行了一些有益的分析,提出了一种间接在线评估接头电阻和绝缘老化的算法,从理论上验证了接头温度与接头质量的相关性。

Instructive analysis on power cable junction faults is carried out and an algorithm for indirect on line measuring of cable junction resistance and insulation aging is proposed.

17. 该电阻器的阻值要保证被测装置发生故障时的短路电流不会超过开关卡上任一组继电器的最大电流指标。

The value of this resistor is chosen such that, in the event of device failure, the short circuit current will not exceed the maximum current specification of the relays on either set of switch cards.

18. 摘要:对电缆接头故障进行了一些有益的分析,提出了一种间接在线评估接头电阻和绝缘老化的算法,从理论上验证了接头温度与接头质量的相关性。

Abstract: Instructive analysis on power cable junction faults is carried out and an algorithm for indirect on-line measuring of cable junction resistance and insulation aging is proposed.

19. 对电缆接头故障进行了一些有益的分析,提出了一种间接在线评估接头电阻和绝缘老化的算法,从理论上验证了接头温度与接头质量的相关性。

Instructive analysis on power cable junction faults is carried out and an algorithm for indirect on-line measuring of cable junction resistance and insulation aging is proposed.

20. 该方法不受电网平衡情况和接地电阻大小的影响,对复杂的间歇性电弧接地故障同样有效。

It is immune from the unbalanced status of network and the values of earthed resistance. To the complicated intermittent arc-earth fault, the proposed method also works well.

21. 微小电阻智能测试研究属于电力设备状态监测及故障诊断技术研究领域。

Research on intelligent measurement of small electric resistance belong to the field of condition monitoring and fault diagnosis on electric power equipment.

22. 若在调节电阻值的过程中,表针有跳动现象,则说明该电位器存在接触不良的故障。

If in the regulation of the resistance value of the process, hand beating phenomenon, the existence of the fault of bad contact potentiometer.

23. 该保护方案的灵敏度不受过渡电阻、雷击、故障类型、负荷电流、系统运行方式等因素的影响。

The sensitivity of the proposed protection scheme is not impacted by the factors such as transition resistance, lightning stroke, fault type, load current and operating mode of power system.

24. 引起电接点热故障原因多种多样,最终都导致接触电阻增加。

The heat fault of electrical contact, which results in the increase of contact resistance , can be caused by various origins.

25. 故障后,系统电流值远大于等效交流电流源值,限流电阻立刻自动投入限流。Www.wenTiyI.Com

But under fault condition, the system current is greater than the current of equivalent AC current source and the limiting resistance take effect immediately.

26. 此类继电器能够增加系统安全性,并对三相交流接地电阻或接地配电系统进行可靠的低级接地故障检测。

They provide system security and immediate reliable low level ground fault detection on three-phase AC resistance grounded or grounded electrical distribution systems.

27. 注3:如有必要刻意串联一个电阻,以防杂波引起故障。

Note 3: Connect a resistor, if necessary, to prevent malfunction due to noise.

28. 给出了超导限流器的数学模型,着重分析了超导限流器限流电阻和故障检测时间对短路电流峰值、非故障线电压、超导限流器上的电压的影响。

The limiting resistance in SFCL and the fault detection time impact on peak value of fault current, line voltage of feeders without fault and voltage across SFCL are analysed.

29. 实现了槽信号的实时曲线和历史显示,历史报表查询,槽电阻频谱分析和神经网络故障诊断功能。

The program realized displaying real time curve and history curve of cell signals, querying history report, spectrum analysis of cell resistance and fault diagnosis for the cell state.

30. 实现了槽信号的实时曲线和历史显示,历史报表查询,槽电阻频谱分析和神经网络故障诊断功能。

The program realized displaying real time curve and history curve of cell signals, querying history report, spectrum analysis of cell resistance and fault diagnosis for the cell state.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!