局部应变用英语怎么说,局部应变的英文翻译


词语导航

基本信息

词语:局部应变

繁体:局部應變

拼音:jú bù yīng biàn

英语翻译

【机】 local strain

分词翻译

局部的英语翻译:

part
【计】 L; LOC
【医】 mero-; topo-

应变的英语翻译:

meet an emergency
【化】 strain
【医】 strain; straining

翻译例句

1. 该局部应变速率继续升高时,将发生机械断裂。

Further more, mechanical facture will take place if the local strain rate is high enough.

2. 根据随机振动试验的有关理论,确定产品局部应变载荷的概率密度函数。

The probability density function of partial strain loading of product is defined in accordance with the relevant theory of random vibration test.

3. 焊缝收缩诱发的局部应变时常达到屈服点应变的数倍,比荷载引起的应变大得多;

Weld shrinkage-induced local strain to yield point strain often several times, than the strain due to the load is much larger;

4. 结果表明,在该体系中局部应变速率是联系各种不同断裂过程的纽带,决定着断裂的模式。

It was revealed that local strain rate is a key factor that builds a bridge between different tests, different samples and different cracking processes, and dominates fracture mode.

5. 基于梯度塑性理论,研究了应变软化阶段的刚度劣化对剪切带内部的局部应变及相对剪切位移的影响。

Distributed shear strain and displacement in localized shear band were investigated considering degraded stiffness in the strain-softening process based on gradient-dependent plasticity.

6. 当弯曲试板上的最大应变等于波纹管的最大局部应变时,板的弯曲疲劳试验寿命即可代替波纹管的试验寿命。

The fatigue test of the bellows expansion joints is replaced by the bent fatigue test of plates when the maximum strain of bent test plates equals to the local strain of bellows expansion joints.

7. 利用改进的剪切滞后法,研究了组成纤维缠绕压力容器中的环向层的横向开裂而在纵向层中引起的局部应变集中。

Local strain concentration in angle-ply lay caused by transverse crack of circular lay in composite pressure vessel was studied by means of advanced shear-lag method.

8. 提出了基于固有应变理论的模型,对焊后局部热处理各个阶段的特征进行了阐述。

A model based on inherent strain theory has been proposed to explain the mechanism at different stage of local PWHT.

9. 根据非局部连续介质模型,提出了一维二阶剪切应变率梯度格式。

One dimensional shear strain rate gradient formation of the second order is proposed based on the non-local continuum model.

10. 通过分析局部的应变集中或应力集中再加上金属变型能力模型,裂纹的发生和地点可以预见。

Through the analysis of the local strain concentration or stress concentration, together with the forming ability model, the occurrence and location of the crake can be predicted.

11. 本文采用小参数扰动法,首先研究了地壳弹性局部变化对潮汐倾斜、应变的调制作用。

The modulation action of the local variation of crustal elasticity on tide tilt and strain is investigated by means of minor parameter method.

12. 在剪胀条件下,分析了剪切带内部的局部体积应变增量及由于剪胀而引起的剪切带的法向变形。

For dilative material in shear, the increment of local volumetric strain in shear band and the normal deformation of shear band due to shear dilatancy were derived.

13. 有限元分析采用了随动强化模型,并考虑材料瞬态局部应力应变的响应特性。

Kinematic hardening model was used in FEM analysis and the response behaviors of transient local stress strain for material was also considered.

14. 推导了交变载荷下弹塑性随机有限元的迭代格式,计算了局部多轴应力应变的随机响应。WwW.wENTIYi.com

The iterative formulas of elastoplastic stochastic finite element method (SFEM) under cyclic loading are deduced and the random responses of local multiaxial stress and strain are calculated.

15. 岩样的塑性变形假设根源于塑性应变局部化。

It is assumed that plastic deformation stems from the localization of shear strain.

16. 剪切应变率(或应变)局部化区域与体积应变率(或应变)的位置重合,局部化区域就是岩样最终的破坏位置。

The location of shear strain rate localization coincides in position with the location of volumetric strain rate, which is the actual failure zone of rock.

17. 原状粘性土在平面应变条件下量测侧向局部变形的试验研究国内外鲜见报导。

Study of tests for measuring lateral strain localization of undisturbed clay in the condition of plane strain compression was rarely reported at home and abroad.

18. 基于梯度塑性理论,考虑了应变局部化,提出单轴拉伸条件下岩样全程应力—应变曲线解析解。

Analytical solution of complete stress-strain curve of rock specimen in uniaxial tension is proposed based on gradient-dependent plasticity considering strain localization initiated at peak strength.

19. 建立了局部(塑性)剪切变形梯度与局部(塑性)剪切应变分布之间的关系及速度梯度与应变率分布之间的关系。

The relation between the gradient of local (plastic) shear deformation and the local (plastic) shear strain and that between the gradient of velocity and the strain rate were established.

20. 提出了“局部激励应变补偿”和把通常的微分负反馈改为低截止频率的惯性环节正反馈的控制新方案。

A new control approach is presented with a "local strain compensation" and a low cutoff frequency inertial link feedback in place of the differential one.

21. 考虑零构件的随机因素,将随机有限元方法引入到交变载荷下弹塑性有限元的迭代格式中,得到局部应力应变的随机响应,为低周疲劳可靠性分析提供了更精确的依据。

The component randomness is considered. The SFEM is introduced in the iterative formulas of EFEM under cyclic loading to obtain the random response of local stress and strain.

22. 根据汽轮机低压叶片所受载荷的特点,建立了一种基于三维有限元法和改进局部应力应变法的叶片疲劳寿命预测模型。

According to the characteristics of loads on blades, a model for estimating fatigue life of blades is presented based on three-dimensional finite element method and improved local strain method.

23. 由于压力容器构件的不确定因素,造成了构件局部应力应变响应和疲劳寿命具有随机性。

The uncertainties of pressure vessel result in the randomness of local stress, local strain and fatigue life.

24. 采用无裂纹缺陷试件进行疲劳试验得到试件的疲劳寿命,同时利用考虑了记忆特性的局部应力应变法对试件的疲劳寿命进行定量分析。

The fatigue life is obtained by using specimens without crack and by a special analysis based on local stress-strain method in which remembrance characteristics are considered.

25. 在平面应变压缩条件下,采用拉格朗日元法研究了材料缺陷对岩样应变局部化及宏观力学行为的影响。

Strain localization and macroscopically mechanical behaviors of rock specimen with and without material imperfection in plane strain compression were modeled numerically by FLAC.

26. 这些不确定因素导致构件的局部应力应变响应和疲劳寿命响应具有随机性。

The uncertainties result in the randomness of local stress, local strain and fatigue life.

27. 为了从含噪声的位移场中计算得到可靠的应变场,提出一种基于位移场局部最小二乘拟合的全场应变求解方法。

In order to obtain reliable strain field, full-field strain measurement based on least-square fitting of local displacement for digital image correlation method is proposed.

28. 锯齿形切屑产生的原因是第一变形区内因热软化超过应变和应变率强化而发生了绝热剪切局部化。

The reason for the sawtooth chips is that the adiabatic shear localization occurs in the primary deformation zones when thermal softening exceeds strain and strain rate hardening.

29. 锯齿形切屑产生的原因是第一变形区内因热软化超过应变和应变率强化而发生了绝热剪切局部化。

The reason for the sawtooth chips is that the adiabatic shear localization occurs in the primary deformation zones when thermal softening exceeds strain and strain rate hardening.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!