主阀用英语怎么说,主阀的英文翻译


词语导航

基本信息

词语:主阀

繁体:主閥

拼音:zhǔ fá

英语翻译

【化】 master valve

分词翻译

主的英语翻译:

advocate; direct; host; indicate; main; owner; person or party concerned
【机】 master

阀的英语翻译:

clique; valve
【化】 valve
【医】 limen; limina; valve

翻译例句

1. 要控制室升压,关闭。

The main control room boost, the main valve is closed.

2. 进口压力使开启。

Open the main valve inlet pressure.

3. 将盖上的配管接头螺丝松开,释放内压力。

The main valve fittings with screw lid release, pressure release valve.

4. 导可在以外单独调定开启压力和关闭压力。

Pilot valve can adjust lift and close pressure solely out if main valve.WWW.wENtiYI.cOm

5. 如果你能在邻居家打电话,叫煤气公司关掉外面的煤气盘。

Turn off the gas at the outside main valve if you can and call the gas company from a neighbor"s home.

6. 要由座、主阀盘、活塞、弹簧等零件组成。

Mainly by the main valve seat, the main valve plate, piston, springs and other parts.

7. ,截止或角结构,采用隔膜驱动,液压操作。

The main valve, globe or angle pattern, is diaphragm actuated, hydraulically operated.

8. 不需要从管线上拆卸门,就可以对和引导系统进行维修。

The main valve and pilot system can be serviced without removing the valve from the line.

9. 由于导系统排水量大于针的进水量,控制室压力下降。

As guided needle valve system is greater than the amount of water displacement, the main valve pressure drop in the control room.

10. 软密封的瓣能在95%以上的开启压力范围内获得高密封度。

Soft airproof main valve can obtain high airproof in the scope of over 95% lift pressure.

11. 轴配置一个内轴,适用于双重调节止动记忆和门位置设置。

The main valve spindle incorporates an inner spindle for double regulation memory stop and valve position setting.

12. 水力控制是由一只及其外装之针形和先导等组合而成。

Hydraulic control valve is a main valve and the exterior of the needle valve and a combination of the pilot valve.

13. 结果表明,具有环形槽的芯结构能有效抑制气穴和气穴噪声。

The results show that the main element with circumferential undercut groove can suppress the cavitations and cavitating noise.

14. 在稳定状态下,控制室进水、排水相同,开度不变,出口压力稳定。

In the steady state, the control room water, drainage same, the main valve opening constant outlet pressure stability.

15. 通电后,电磁力直接把先导小封闭件依次向上提起,门打开。

Power, the electromagnetic force directly to the pilot valve and main valve closed small pieces followed by upward, open the valve.

16. 当水位下降后,由浮球开关控制打开进水口向水池汪水,实现自动补水。

When the water level drops, the main valve is composed of a floating ball switch control to open the water inlet to the water tank, automatic replenishment.

17. 水力控制由一个及其附设的导管﹑导﹑针﹑球和压力表等组成。

Hydraulic control valve consists of a main valve and attached to the catheter, guided valves, needle valves, ball valves and pressure gauges and other components.

18. 控制室停止排水,此时控制室内压力升高并关闭主阀,出口压力不再升高。

Control room to stop the drainage, when the main valve control room pressure rise and close the main valve outlet pressure will not rise.

19. 通过对精密加工件分配孔的加工工艺试验及研究,总结了一套行之有效的加工工艺。

A complete processing technology is summed up for the main valve opening of the dividing control valve in the fine machining pieces based on the study and test.

20. 从JZ 7型空气制动机本身的结构出发,提出了客运机车分配的方案,研制了新的分配

Based on the inhouse structure of JZ-7 air brakes, the design scheme of distribution valves for passenger locomotives was proposed and the main valve of new distribution valves was developed.

21. 当水池水面下降后,浮球重新开启,控制室水压下降,再次开启继续供水,保持液面的设定高度。

When the water tank after falling, floating ball valve to open, the control room pressure drops, the main valve to open again to water, keep the level set height.

22. 进口持压泄压、泄压/持压导、 、球、微形过滤器和压力表组成水力控制接管系统。

A pressure relief valve from the main valve, pressure relief / holding pressure pilot valve needle valve, ball valve, micro shaped filter and pressure gauge hydraulic control over the system.

23. 最后,给出在83 %FP以下的功率运行下进行蒸汽安全定值校验试验的窗口安排与注意事项。

Finally, scheduling and precautions for verification tests of the calibration pressure of main steam safety valve under 83 % FP power level are given.

24. 液压系统采用了先进的二通插装系统、进口高性能的电子泵技术,实现了缸压力与流量的双闭环控制;

The press takes use of advanced two-way cartridge valve system and imported electric pump technology which can realize double closed loop control of pressure and flow rate.

25. 分析故障重点在安全和液压水泵。

Analysis of the focus in the main safety valve failure and hydraulic pump.

26. 气压缩机的充气试验、全和自动装置的调整。

Charging test and safety valve and automatic device adjusting for main compressor (auxiliary compressor).

27. 该分层扫气系统由曲轴箱、扫气道、副扫气道、分层管、笛簧和化油器等组成。

The scavenging system is composed of crankcase, main scavenging passage, sub passage stratifying pipe, reed valve and carburettor.

28. 空气压缩机的充气试验,安全和自动装置的调整。

Charging test and safety valve and automatic device adjusting for main compressor.

29. 空气压缩机的充气试验,安全和自动装置的调整。

Charging test and safety valve and automatic device adjusting for main compressor.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!