传热面积用英语怎么说，传热面积的英文翻译

词语导航

基本信息

词语：传热面积

繁体：傳熱面積

拼音：chuán rè miàn jī

英语翻译

【化】 heat transfer area

分词翻译

传热的英语翻译：

【化】 heat transfer; heat transference; heat transmission
thermal transmission

面积的英语翻译：

acreage; area; proportion
【计】 A

翻译例句

1. 换热器蒸汽入口和出口温差小，压差小，管程传热面积大。

There are small temperature and pressure difference in steam inlet and outlet of heat exchanger, and big heat transfer surface.

2. 本文以总传热面积为目标函数，对不可逆卡诺制冷机进行优化分析。

The total heat-transfer area is taken, as an objective function to analyse the optimal performance of an irreversible Carnot refrigerator.

3. 埋弧焊传热面积可以改造现有的流化床干燥机，以增加蒸发量。 。

Submerged heat transfer area can be retrofitted to existing Fluid Bed Dryers to increase evaporative capacity.

4. 进行优化设计、变工况计算、热泵机组各部件传热面积和各部件热负荷计算。

We try to optimize the design variable condition calculation, heat pump unit heat transfer area of the parts and the parts heat load calculation.

5. 通过优化两个换热器和回热器之间的热导率分配或传热面积分配可得循环最优性能。

The optimal performance can be obtained by optimizing the distribution of heat conductances or heat transfer surface areas among the two heat exchangers and the regenerator.

6. 考虑换热器异径布管方式，该结构比相同体积下传统换热器传热面积增加30%左右。

The layout method of tubes with different diameters is considered in heat exchangers. The heat transfer area is increased 30 percent than the traditional heat exchangers".

7. 该软件能有效地计算火焰前锋面积、已燃区体积和传热面积随火焰传播距离的变化情况。

It can calculate effectively the variation of flame front area, burned volume, and heat transfer area with the process of flame propagation and can be applied to an arbitrary combustion chamber.

8. 进行了发生器、冷凝器、蒸发器、吸收器、溶液热交换器等换热设备所需的传热面积计算。

The heat-transfer area demand of the heat-exchange equipments, such as generator, condenser, evaporator, absorber and solution heat exchanger, are computed.

9. 进一步研究了在结霜过程中空气冷却器的传热面积、传热系数以及空气侧压降与霜层生长的变化关系。

Through expounding the calculation process of the external wall, roofing, floor and door and window heat transmission coefficient, the article investigates the energy-savingc alculation.

10. 进一步研究了在结霜过程中空气冷却器的传热面积、传热系数以及空气侧压降与霜层生长的变化关系。

Theoretical analysis using the method of energy equilibrium in covering layer and validation of the overall heat transfer coefficient of greenhouse covering materials;

11. 实例优化计算结果表明，优化设计可使多股流板翅式换热器在满足给定的约束条件下，节约大量的传热面积。

The results obtained from the optimum calculation show that the heat transfer area is reduced obviously under the given constraint conditions.

12. 在一定的进气状态下，为达到要求的出气干度，对给定的空气流量进行了设计计算，以得到合适的传热面积与制冷系统的匹配。

At a given air inlet condition and airflow rate, meanwhile, dryness of air outlet was required, proper heat-transfer area and matching refrigeration system are obtained through calculating.

13. 在考虑了内翅片使管内传热面积增大 ，传热性能提高这一特点 ，经过反复实验 ，回归出了内翅片管传热的准则方程式。

A dimensionless equation of the inner finned heat transfer was regressed based on the characteristics of enlarging of heat transfer surface and improving of heat transfer property.

14. 结合实际算例，分析了换热器总传热面积对系统特性的影响以及不同设计工况下的优化结果，同时讨论了换热器种类对最小总传热面积的影响。

With an example, analyses the effect of total heat exchanger area on system performance and the optimizing results under different conditions and discusses the impact …

15. 传热效率高。变径后的冷凝端增加了散热面积，散热效率更快，传热效果更好。

High heat conducting efficiency: the diameter-altered cooling end is able to increase the heat loss area and heat conducting efficiency.

16. 流化床的一大优点在于能产生一个充分混合的具有很大表面积的流体与固体的接触系统，这对高效反应和传热都很有用。

A major advantage of fluidised beds is that they provide a well mixed, high surface area, fluid-solid system which is useful for efficient reactions and heat transfer.

17. 直接交换面积是区域法计算辐射传热的基础数据。

The direct exchanging area is essential for zone method to calculate radiative heat transfer.

18. 在热流通过两相互接触材料尤其是金属材料的界面时，真实接触面积是界面传热的一个主要影响因素。

The real contact area is the main factor effecting the heat transfer when the heat is crossing the interface between two contacted materials, especially the metal materials.

19. 管内湍流强化传热方法一般是增加壁面换热面积，但这会显著提高管内流动阻力。

The conventional method of heat transfer enhancement for turbulent flow in tube is to increase the heat transfer area, but it will increase the pressure drop across the tube significantly.

20. 并测量了气缸盖鼻梁区和活塞燃烧室表面的瞬态热流，结果表明燃烧室受热表面积炭层的存在对工质与燃烧室各零件间的瞬态传热表现出强的闭塞作用。WWw.WenTiYI.com

The results shoW that the carbon deposit layer on the combustion chamber has strong isolative effect on the transient heat transfer between working medium and the parts of combustion chamber.

21. 高流速下的生产薄膜有很大的表面积，使得快速的传热和高效的操作得以实现。

Production of thin films at high flow velocity, along with large surface area, allow rapid heat transfer and efficient operation.

22. 从段法基本概念出发，推得了柴油机缸内火焰段对整个缸壁段的辐射全交换面积计算式，并以此为基础给出了缸内辐射传热的单区段法模型。

Based on the conception of zonal method, the total radiant exchange area for flame zone to surface zone of the diesel in-cylinder was derived.

23. 本实用新型可增加空气的流通面积和空气流量，均匀配水，提高传热传质效果。

The utility model has the advantages of air flow area and air flow rate increasing, uniform water distributing and heat transfer and mass transfer effect promoting.

24. 流化床操作具有固体颗粒混合好，气固两相传热传质表面积大等优点。

Fluidized bed drier enjoys advantages of even solid particle mixing and large heat and mass transfer area of gas and solid phase.

25. 烟管（5）中的水管（4）减小了烟道流动截面积、加大了烟气流速，使得烟气传热性能增强、热效率高。

The water pipe (4) of the smoke pipe (5) reduces the flowing section of the smoke channel, speeds up the smoke flow, improving the heat transmission performance and efficiency.

26. 把按二维温度分布计算出的墙体平均传热系数与按标准的一维面积加权方法计算出的平均传热系数作比较，两者差别很大。

The difference between the wall mean heat transfer coefficient calculated from the simulated results and that from one dimension weighted method is evident.

27. 从传热学中的特征式关联式出发，给出一种电流引线冷却面积的计算方法，并以黄铜为例计算了电流引线的结构尺寸。

The section area can be worked out according to relational formula of characteristic formula in the heat transfer. As an example, the structural dimension of…

28. 从传热学中的特征式关联式出发，给出一种电流引线冷却面积的计算方法，并以黄铜为例计算了电流引线的结构尺寸。

The section area can be worked out according to relational formula of characteristic formula in the heat transfer. As an example, the structural dimension of…