加入量用英语怎么说,加入量的英文翻译


词语导航

基本信息

词语:加入量

繁体:加入量

拼音:jiā rù liáng

英语翻译

【化】 addition; quantity added to

分词翻译

加的英语翻译:

add; append; increase; plus; tot; tote
【医】 add; adde; addition; admov.

入的英语翻译:

agree with; enter; income; join

量的英语翻译:

capacity; estimate; measure; mete; quantity; quantum
【医】 amount; dose; dosis; measure; quanta; quantity; quantum
【经】 volume

翻译例句

1. 在热水中加入为每加仑水一茶杯的小苏打。

To the hot water, add about one cup of baking soda for each gallon of water.

2. 初粘性随醋酸乙烯酯加入的增大而减小。

Initial stickness decreases with the addition of vinyl acetate.

3. 正辛醇的加入是水玻璃质的0.30%。

The quantity addition of octanol is 0.30% quantity of water-glass.

4. 另外,还对混合稀土的适宜加入进行了试验。

Furthermore, the suitable dosage of mischmetal addition has also been tested.

5. 控制添加剂加入是制得合乎要求的材料关键。

The required material should be prepared by controlling the quantities of added sulfur.

6. 结果表明:乳酸发酵速度与牛乳的加入有关;

The results show that the lactic fermentation relate to the quantity of milk added.

7. 阐述了添加剂的性质和加入对铝粉性能的影响。

The effect of addition on performance of aluminium powder and additives "nature are elaborated.

8. 研究表明各种添加剂的加入都有一个适宜的范围。

The research indicates that the adding quantity of each additive has a fitting range.

9. 研究表明各种添加剂的加入都有一个适宜的范围。

The research indicate that the adding quantity of each additive has a fitting range.

10. 本文并对溴酸钾的加入等对产率的影响进行了探讨。

In this paper, as well as potassium bromate in the right quantity of the yield effects are discussed.

11. 考察了电熔氧化镁加入对镁铬耐火材料致密化的影响。

The effect of the amount of fused magnesia addition on the densification of magnesia chrome refractory was investigated.

12. 为了消除应力,研究了添加剂的作用以及加入量的控制。

In order to remove stress, the effects of some additives are studied.

13. 合金的力学性能和耐腐蚀性能也随b加入的增加而降低。

It is also found that mechanical properties and corrosion resistance decrease with increase of B addition.

14. 考察了复合变质剂的加入顺序、加入量以及变质的长效性。

The addition sequence, addition and long effectiveness of the compound modifier were investigated.

15. 稀土对合金的作用与加入有直接关系,过多与不及都不好。

The influences of rare earth on beryllium copper alloy are in close relationship with its addition quantity.

16. 但稀土加入的合适范围很窄,并且视钢的成份不同而不同。

The adding amount range of rare earths is narrow and different with different steels.

17. 在制作保护渣时,碳粉的种类和加入是应注意的重要因素。

The kind and content of carbon in CCmold flux should be carefully selected before preparation.

18. 当稀土金属盐加入量为2%时镀层密度最大、显微硬度最高。

When the RE metal salt was 2%, the coating had the best density and hardness.

19. 研究了泡沫加入量、粉煤灰和石灰石膏对泡沫混凝土性能的影响。

The effects of the contents of foam, fly ash, lime and plaster on the properties of foam concrete block were investigated.

20. 其次,研究了蓝晶石的粒度和加入对莫来石-刚玉材料性能的影响。

Secondly, the effect of particle size and additions of kyanite on properties of mullite-corundum was studied.wWW.weNTiyI.COm

21. 首先,研究了红柱石的粒度和加入对莫来石-刚玉材料性能的影响。

At first, the effect of particle size and additions of andalusite on mullite-corundum materials were studied.

22. 含氟粘接剂的氟释放特性受到氟化物的种类、加入、释放介质的影响。

The fluoride release was affected by fluoride type, fluoride content and medium that fluoride released into.

23. 当尖晶石加入量为15%时,浇注料具有最佳的高温强度和综合抗渣性能。

When the ma spinel addition is 15%, the castable has optimal high temperature strength and slag resistance.

24. 粉煤灰加入增加,泡沫混凝土砌块的干密度递增,抗折和抗压强度增大。

The dry density, bending strength and compressive strength of foam concrete block increased with the increasing of the amount of fly ash.

25. 通过试验分析了混凝剂加入、原水浊度、运行流速对装置运行情况的影响。

The effect of coagulants dosages, concentration of water and flux of water on the equipment operation is analyzed.

26. 通过分析,得出了一些有益的结论,为合理的确定絮凝剂的加入提出了科学依据。

Based upon analysis, some beneficial conclusions are obtained, which can be used as references for ascertaining the dosage consumption.

27. 管路压降随着流、颗粒密度、颗粒初始加入及液相介质密度和粘度增大而增大。

The pressure drop of pipe increases with increasing of flux, liquid density, liquid viscosity, particle density and particle volume density.

28. 并确定了山葡萄醋饮料最佳配方,即山葡萄醋加入20%,绵白糖加入量10%。

The optimum formulation was determined too, known as the volume of grape juice and sugar is 20% and 10% respectively.

29. 本文讨论不同的淀粉加入量加入点对纸张的灰分含、物理强度和印刷性能的影响。

The influences of different starch dosage and addition point on the ash content, physical strength and printability of paper were discussed in this paper.

30. 本文讨论不同的淀粉加入量加入点对纸张的灰分含、物理强度和印刷性能的影响。

The influences of different starch dosage and addition point on the ash content, physical strength and printability of paper were discussed in this paper.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!