轴向变形用英语怎么说,轴向变形的英文翻译


词语导航

基本信息

词语:轴向变形

繁体:軸向變形

拼音:zhóu xiàng biàn xíng

英语翻译

【机】 lateral deformation

分词翻译

轴的英语翻译:

axes; axis; shaft; spindle
【医】 ax-; ax.; axes; axio-; axis; core

向的英语翻译:

always; at; be partial to; direction; face; out; to; toward
【医】 ad-; ak-; ob-

变形的英语翻译:

transmute; distort; metamorphose; distortion; metamorphism; transfiguration
transformation; transmutation
【化】 anamorphosis; deformation; distortion; transform
【医】 allaxis; deformation; deformity; distortion; dysmorphia; dysmorphosis
malformation; metallaxis; metamorphosis; transformation

翻译例句

1. 略去轴向变形不计,仅考虑集中质量。

Neglect the axial deformations and consider only the lumped masses.

2. CT数的均值、方差随轴向变形变化关系曲线呈抛物线形式。

The relationship between mean of CT number and variance of CT number to axial deformation are parabolas.

3. 这个模型除考虑竖杆的弯曲和剪切变形外,还考虑了轴向变形。

In this model, besides considering bending and shear deformation, the axial deformation of columns has also been taken into account.

4. 在建立拱的振动传递方程时,考虑了拱内的轴向变形和几何刚度。

The geometric stiffness and the axial deformation of arch are considered in formulating its vibration transfer equation.

5. 气井投产前后温度和压力变化会引起油管应力及轴向变形的改变。

The change of temperature after or before gas well put into production will result in the variation of tubing string stress and axial deformation.wwW.WeNTiyi.cOM

6. 如连续梁上的荷载为竖直荷载,且无轴向变形,则所有反力都是竖直的。

If the loads on a continuous beam are vertical and if there are no axial deformations, then all the reactions will be vertical.

7. 由于自身的受力特点,框架-筒体结构轴向变形差较其他结构型式更突出。

The axial deformation difference between columns and walls in frame-tube is obviouser than other constructions, Because of the constructions stress"character.

8. 算例分析说明,忽略柱轴向变形的影响将会给高层框架侧移计算带来较大误差。

The calculation example showed that the error was greater when ignoring the influence of the axial deformation of the frame column.

9. 在此基础上,分析管柱载荷、应力及轴向变形,为井下管柱的合理设计提供依据。

On this basis, checking to the tubing axial deformation, load and stress calculation method of the former, provide the basis for pipe strings design and a reasonable choice of production parameters.

10. 以某型号滚珠丝杠副为例,分析了相关参数对轴向变形量和丝杠副传动性能的影响。

Based on a given ball screw, the effects of each parameter on the axial deformation and driving performance of single-nut ball screw were analyzed.

11. 混合结构是由两种性能有较大差异的结构组合而成,轴向变形和楼板变形是否考虑值得研究。

The hybrid structure is composite of two different structures, whether the axial deformation and floor distortion of frame column should be considered or not is worthy research.

12. 超静定结构中的这种轴向变形差会引起结构的内力重分布,对结构的受力性能将产生一定的影响。

The internal force redistribution in statically indeterminate structures will be created by axial deformation difference, and the stress performance of structure would be changed.

13. 型煤的渗流速度对轴向压力和轴向变形最敏感,而原煤的渗流速度对体积变形和横向变形比较敏感。

The seepage velocity of briquettes is sensitive to axial pressure and axial strain, but it is sensitive only to transverse strain and volume strain for row coal.

14. 研究了岩样三轴压缩过程中环向变形比轴向变形更早、更快地偏离线弹性状态的原因,给出了确定泊松比的方法。

It is explained clearly that rock sample"s circumferential deformation deviates from the linear elastic law earlier and faster than its axial deformation.

15. 基于现有的单螺母滚珠丝杠副弹性变形理论基础,建立了滚珠丝杠副弹性接触变形的模型并得到改进的轴向变形公式。

Based on the current elastic deformation theory of single-nut ball screw, a model of ball screw was developed and a modified formula of axial deformation of ball screw was derived.

16. 分析表明:强力旋压毛坯件的变形流动主要是轴向变形,影响成形质量的因素主要是成形过程中的径向变形和切向变形。

The results indicate that the deformation flow of power spinning is mainly axial deformation, the radial deformation and circumferential deformation have an impact on the forming quality.

17. 外部钢框架进一步简化为半刚架和相应的弹性阶梯形等效弯曲杆的串联体系,这种简化模型能考虑柱轴向变形对结构动力反应的影响;

The external steel frames are simplified as a series of half frames and the core tube is modeled as a bending and shearing two spring system.

18. 综合考虑了胞体中斜支柱的轴向、弯曲和剪切变形以及水平支柱的轴向变形的影响,利用最小势能原理得到了材料的弹性性能与各向异性比及相对密度的关系。

The influence of inclined struts on the elastic properties under axial, bending, and shear deformations as well as the impact of axial deformation of horizontal struts were considered comprehensively.

19. 研究表明,纤维在轴向对基体的蠕变起到明显阻止作用,而在横向和剪切变形下的作用较小。

It is shown that the fiber can considerably resist the matrix creep along the axial direction, but not so for transversely and shear deformation.

20. 一般情况下,模型栅格的变形是轴向应变和切向应变的组合。

In general, the deformation of the model grille is a combination of axial and shear strains.

21. 通过WVIS -ME45隔振器的轴向弹性变形来传递螺旋桨的推力,有效地控制了船舶推进系统的振动和噪声。

It is efficient to control the vibration and noise of the propulsion system since the thrust is transmitted by axial elastic deformation of WVIS-ME45 vibration isolator.

22. 在比较不同工况轴向相对变形程度的基础上,获得了模具主要工艺参数对轧件轴向延伸产生的影响。

On the base of comparing the relative deformation degree under the different rolling conditions, the influence of process parameters on the axial stretching of workpiece is obtained.

23. 将轨枕视为连续弹性基础上的有限长梁,对轨枕进行了受力分析,建立了钢轨轴向力和轨枕变形曲线的关系。

Sleeper is regarded as a finite long beam on continuous elastics base. The relation between rail forces and sleeper displacement is established by analysis of sleeper forces.

24. 其次,由轴向定位预紧轴承受径向载荷时各滚子的变形,推导出轴承的径向刚度计算公式;

Second, the calculation formula of radial rigidity is deduced according to the deformation of rollers under the radial load with axial position preload.

25. 通过试验得出了钢梁的温度场分布、变形、轴向约束力和连接弯矩的变化规律。

From the test results, the regularities of temperature field, deflection, axial restraining force and connection moment are presented.

26. 提出了单轴压缩的岩样在受到剪切破坏条件下的全部变形特征,即轴向、侧向、环向、体积应变及峰后泊松比的解析式。

Analytical solutions of axial, lateral, circumferential and volumetric strains, and post-peak Poisson"s ratio of rock specimen subjected to shear failure in uniaxial compression are proposed.

27. 管材内压液力成形过程中,管坯在内压与轴向压力的共同作用下发生变形。

In the process of tube hydro forming, the tube changes its shape under combined internal pressure and axial compressive load.

28. 大型电力变压器螺旋线圈的扭转变形主要是由于轴向电流分量和辐向漏磁场共同作用所产生的。

The torsional deflection of spiral winding for the large power transformer is mostly caused by the common effect of the axial current component and the radial leak magnetic field.

29. 大型电力变压器螺旋线圈的扭转变形主要是由于轴向电流分量和辐向漏磁场共同作用所产生的。

The torsional deflection of spiral winding for the large power transformer is mostly caused by the common effect of the axial current component and the radial leak magnetic field.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!