
词语导航
基本信息
词语:最大偏差
繁体:最大偏差
拼音:zuì dà piān chà
英语翻译
【化】 maximum deviation; maximum offsetwww.WentIYi.cOM
分词翻译
最大的英语翻译:
furthest; most【计】 MAX
【医】 max.; maxima; maximum
【经】 maximum
偏差的英语翻译:
deviation; error; warp; windage【化】 deviation
【医】 declination; deviation
【经】 bias; deviation
翻译例句
1. 二者的结果在最大偏差11%范围内符合。
The results of two methods coincide within the maximum difference of 11 %.
2. 窗口是在客户端时钟和服务器时钟之间所允许的最大偏差。
The window is the maximum allowable drift between the client clock and the server clock.
3. 抖动(匮称延迟抖动)指的是数据到达目的地所需时间的最大偏差。
The jitter (or delay jitter) determines the maximum allowed variance in the arrival of data at the destination.
4. 验证实验表明模型计算值和实验数据吻合较好,最大偏差在30%以内。
The experiment shows that the calculator values from the model agrees well with the experiment data and the maximum deviation is within 30%.
5. 最大偏差主要发生在近地面大气层、对流层顶附近和地形复杂的陆地区域。
The largest differences are near the ground and in tropopause region, particularly over the land with complicated topography.
6. 结果表明,对比实验法的实验数据更接近理论值,最大偏差不超过1.5%。
Experiments show that the results of correlation method agree with those from Hay with a deviation of 1.5%.
7. 模型检验结果表明,预测残差基本小于模型的最大偏差,模型可用于直馏柴油的组成预测。
The results of the test showed that the prediction residual were less than the maximum deviation, so the models were suitable for the hydrocarbon composition prediction of straight-run diesel frac...
8. 提出一个求点集最佳直线的新方法,它能保证所有实验点相对于最佳直线的最大偏差为最小。
A new method for the calculation of the best-fit line is presented. It can guarantee that the greatest vertical difference between experimental points and the best-fit line is a minimum.
9. 对结构墙体,用两米靠尺检查,最大偏差不得超过五毫米,超差部分应剔凿或用一比三水泥砂浆修补平整。
With two meters by ruler of wall structure, inspection, shall not exceed 5 mm maximum deviation, cut or out-of-tolerance part should be picked with a than three repair cement mortar leveling.
10. 函数发生机构中输出角度与期望值之间的最大偏差为最小的问题机构综合中一个典型而又较难处理的问题。
It is the typical and troublesome problem that the synthesis of function generator approaches minimization of the maxiumun deviation between the output and the expected value.
11. 除了用单行数值比较法外,还计算了重组和数学模型之间的归一化均方根偏差、归一化平均偏差和最大偏差。
Besides a comparison of the characteristic line, the normalized mean square root error, the normalized mean error, and the maximum deviation are calculated and discussed.
12. 结果表明:在接近饱和的状态下,实际混合气体效应不可忽略,在HAT循环饱和过程参数范围内两者的最大偏差接近7%。
It shows that the maximum deviation between the two calculation models is near to 7%, the influence of the real gas can not be neglected.
13. 该模型学习速率快,训练步骤少,逼近程度高,最大偏差不大于5%,为三相循环流化床蒸发器的传热计算提供了可靠的方法和理论基础;
Rapid learning speed, few training steps and high fidelity are advantages of the model. The maximal deviation is no more than 5%.
14. 对不同未知样本进行了预测,结果表明,所建模型具有一定的稳定性,对未知样品蛋白质浓度的测量偏差较小,其最大偏差不超过1.0。
The model is good by predicting protein concentration of wheat flour with different unknown sample groups. Its error is less than 1 0.
15. 对不同未知样本进行了预测,结果表明,所建模型具有一定的稳定性,对未知样品蛋白质浓度的测量偏差较小,其最大偏差不超过1.0。
The model is good by predicting protein concentration of wheat flour with different unknown sample groups. Its error is less than 1 0.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
