词语导航
基本信息
词语：射流泵
繁体：射流泵
拼音：shè liú bèng
英语翻译
【化】 injection pump; jet pump
相关词条
1.jetpump分词翻译
射流的英语翻译：
【化】 jet flow【医】 efflux
泵的英语翻译：
pump【化】 pump
【医】 pump
翻译例句
1. 为设计水电站供、排水射流泵提供一定参数。
It can be for reference in which design a supply jet-pump in hydroelectric station and a discharge jee-pump.
2. 本文提出了环形双侧吸气新型高效液气射流泵。
A new type of high efficient liquid-gas jet pump with ring-shape noozle and two-side suction gas is presented.
3. 本文介绍了某种射流泵泵体加工的系列专用夹具。
This article introduces a series of special clamps for machining pump body of a Shoot Liquid pump.
4. 第二章系统分析了液气两相流传质理论和液气射流泵性能理论。
In chapter 2, the theory of liquid gas flow and liquid-gas jet pump has been analyzed systematically.
5. 介绍了有杆射流泵组合分采的工作原理、参数优选及现场应用情况。
This paper introduces the operating principle of the combinatorial layering oil production of the rod jet pump, and the parameter optimization as well as field application.
6. 在此基础上对射流泵内非定常流动进行了数值模拟，得到了合理的计算结果。
The unsteady flow in a jet pump is calculated and the reasonable calculation result was gotten based on above research.
7. 用射流泵代替空压机或鼓风机进行滤池气水反冲洗、能大大降低设备和运行费用。
In the air-water back washing filter, application of jet pump instead of air compressor or blower can considerably save both the installation cost and the running cost.
8. 可逆流体换向装置是决定气动式脉冲液体射流泵的流体输送效率的关键组成部件。
The Reverse Flow Diverter (RFD) is one of the key components affecting the liquid - delivered efficiency.
9. 并为砖瓦行业提出了确定液气射流真空泵的最优参数及设计高效液气射流泵的方法。
It also provides the brick-tile industry the optimum parameters for atomized jet vacuum pump and the method of designing efficient jet vacuum pump.
10. 在分析液气射流泵的试验报告基础上，给出每一确定面积比的最优工作压力的经验表达式。
On the basis of analysing the experiments of atomized jet vacuum pump. it puts forward an empirical optimized working pressure formular for a definite area ratio in.
11. 射流泵运行周期长、检泵作业量少、生产效率高、耗电量小，动力液用量少，可使采油成本降低。
The hydraulic jet pump can reduce the producing cost due to its long run-life, few inspection operation, high production efficiency, less power consumption and less usage of power liquid.
12. 该方程还能够描述液-液和液-气两种射流泵的基本性能，适用范围广泛，可作为工程设计的参考。
This equation can be applied to the liquid-liquid or liquid-gas jet pump. The fields it is fit in are extensive and it can be used as the reference for engineering design.
13. 文中对射流泵在埕北油田成功应用的经验进行了总结，并提出了完善埕北油田射流泵采油工艺的建议。
The paper summarizes the experience in successful application of hydraulic jet pump in Chengbei oilfield and put forward the Suggestions for improving the producing techniques.
14. 将连续气举工艺设计与射流泵工艺设计结合起来，并应用节点分析方法建立了一种新组合工艺设计方法。
Combine technics approach of continuous gas lift and jet pump, and what"s more, apply node analysis to establish new processing approach.
15. 给出两个计算实例，计算结果与实测资料基本吻合，从而为射流泵内部流场的数值模拟研究提供了一种新方法。
Numerical results of two examples given in this paper agree with the experimental data, and thus, a new numerical method for studying flow in jet pumps is proposed.
16. 概述了变频调速泵节能原理，针对高层建筑供水设施改造的实际情况，设计开发了一套射流泵辅助变频调速恒压供水系统。
A building water supply system in which jet-pump-aided and the inverter and PLC is used to realize the constant pressure of the water is inroduced.
17. 结合射流泵的设计理论和离心泵的汽蚀理论，确定了引射装置的引射回路和环形均布喷嘴轴向斜引射的引射装置基本设计方案。
Base on the theory of suction performance of centrifugal pump and design of jetting pump, the design of jetting loop and jetting device are given.
18. 针对液体射流泵的空化噪声与振动进行了试验研究；运用B&K加速度仪和水听器对射流泵各部位在不同工况下的空化噪声与振动进行了测量。
The B&K accelerometer and hydrophone were used for the measurement of the cavitation noise and vibration at different part of jet pump under different operating modes.
19. 本文提出了射流泥浆泵装置的设计理论和方法。
The theory and design method of liquid-solid jet pump device are proposed in this paper.
20. 该系列射流式自吸离心泵的研究是成功的。
The research of this series of pump is successful.
21. 实验采用SD150测试系统主要研究了泵压和自激振荡腔长对射流频率的影响。
The effects of pump pressure and the length of the oscillation cavity on the jet oscillating frequency are studied using SD150 test system.
22. 泵运转时，不仅可以完成自吸过程，而且可以将自循环射流器上的阀门关闭，射流器同时停止工作。wwW.WEnTiyI.CoM
When the pump starts working, the self-priming process can be achieved, and the valve of water-ejecting will be shut off automatically to stop the working of jet flow system simultaneously.
23. 讨论了小型射流吸石泵系统的设计计算方法。
The design and calculation method of small jet stone pump system were discussed in this paper.
24. 在对建筑施工中泵送与非泵送混凝土法进行对比后，提出了采用射流技术改进泵送混凝土工艺的新方法，并简要叙述了这种方法的施工程序和注意事项。
Comparing the pumping concrete method with the non pumping concrete method, this paper presents the new method which use the jet technique, and the construction procedure is discussed briefly.
25. jet型泵是由离心泵和喷嘴组成的射流式全扬程自吸泵。
JETS Series pump is a jet pump or a full lift self-priming pump which is consisted of centrifugal pump and jet nozzle.
26. 对柱塞泵设计过程中的空蚀特性，提出一种通过分析减压槽出口处的射流方向来评价高压轴向柱塞空蚀特性的方法；
The method to estimate cavitation characteristic by analyzing impingement angle at the groove on porting plate of an axial plunger pump is put forward during design process period.
27. 对柱塞泵设计过程中的空蚀特性，提出一种通过分析减压槽出口处的射流方向来评价高压轴向柱塞空蚀特性的方法；
The method to estimate cavitation characteristic by analyzing impingement angle at the groove on porting plate of an axial plunger pump is put forward during design process period.
版权声明：问题易所有作品（图文、音视频）均来源网络，版权归原创作者所有，与本站立场无关，如不慎侵犯了你的权益，请联系我们告知，我们将做删除处理！