韧性试验用英语怎么说，韧性试验的英文翻译

词语导航

基本信息

词语：韧性试验

繁体：韌性試驗

拼音：rèn xìng shì yàn

英语翻译

【化】 toughness test

分词翻译

试验的英语翻译：

experiment; test; try; try on; try out; examination; experimentation; trial
trial run
【计】 breadboarding
【医】 probation; test; tria
【经】 test; trial

翻译例句

1. 本文介绍了埋弧焊钢管焊缝韧性试验研究的结果及工业生产应用效果。

The experimental results and application effects of weld toughness of spirally submerged arc welded pipe are introduced.

2. 通过焊接热模拟试验和冲击韧性试验，研究了不同预热温度对X80级管线钢组织性能的影响。

Welding thermal simulation technique is adopted to study the influences of twice thermal cycle on the structure and properties of X80 pipeline steel.

3. 通过焊接热模拟试验和冲击韧性试验，研究了不同预热温度对X80级管线钢组织性能的影响。

The effect of hot bending and heat treatment thermal cycles on the mechanical properties of X80 grade steel pipe was evaluated.

4. 对某厂x 80高钢级管线钢母材、焊缝、热影响区进行了夏比冲击韧性试验，对其有效晶粒进行了研究。

The Charpy impact test of base metal, weld and heat affected zone of X80 grade pipeline steel of certain factory was conducted, and its effective grain was researched.

5. 此外，本文还利用不同类型钢纤维进行了钢纤维高强混凝土的抗压强度、抗剪强度、劈拉韧性和弯曲韧性试验。

Meanwhile, shear strength, splitting tensile and flexural toughness experiments have been conducted using four types of steel fiber on steel fiber reinforced high strength concrete (SFRHSC).

6. 该技术采用微合金化，利用正交试验设计方法，对不同成分搭配的试样进行宏观硬度和冲击韧性测试，优化了合金成分。

The composition was optimized by tiny alloying, orthogonal test design and the hardness and impact toughness test for the different samples with different combination of alloy composition.

7. 通过试验研究了力学不均匀性对接头断裂韧性和裂纹开裂角的影响。

Effects of mechanical heterogeneity on fracture toughness and crack deviation Angle of the joints were investigated by experiment.

8. 通过试验结果与应力场分析，讨论了不同应力状态参数下，金属材料韧性断裂形式的变化规律。WWW.WEnTIYi.Com

Through the analysis of test results and stress fields, the change of metal materials" ductile fracture mode with different stress condition parameters are discussed.

9. 研究设计：前瞻性评估一种新的悬吊试验以确定青少年特发性脊柱侧凸(AIS)的脊柱柔韧性，并与直立位侧方推挤试验相比较。

Study Design. Prospective evaluation of a new suspension test to determine curve flexibility in adolescent idiopathic scoliosis (AIS) in comparison with erect side-bending.

10. 本文利用示波冲击试验，对船用921A钢动态断裂韧性的测试方法进行了研究。

In this paper, the dynamic fracture toughness measuring method for 921a shipbuilding steel is studied by instrumented Charpy impact test.

11. 介绍了通过热处理提高白口铸铁硬度和韧性的试验结果。

This paper highlights the experiment results in improving the toughness and hardness of white cast iron by heat treatment.

12. 在试验温度区内，控制韧性的因素是断裂载荷、纤维裂纹长度和单位纤维裂纹扩展能量。

Within the range of test temperature, the factors controlling the toughness are fracture loads, the lengths of fibrous crack, and the energy absorbed by each fibrous crack extension.

13. 模态一的破坏试验可测得有机黏土的比重增加时，复合材料的韧性会有明显的下降。

From the mode I fracture tests it was indicated that with the increase of the organoclay, the corresponding fracture toughness of the composites decreases appreciably.

14. 试验表明，采用合适的冶炼工艺，大型转炉加炉外精炼能够批量生产超低硫低磷钻杆用钢，使钻杆获得高横向冲击韧性。

Test results show that such steel can be mass produced with technology of a large converter plus the secondary refining, which can insure drill pipes for the transverse impact toughness.

15. 通过开疲劳裂纹和线切割裂纹的对比试验，研究裂纹尖端的尖锐程度对球墨铸铁断裂韧性的影响；

By comparing fatigue crack with electrosparking crack, the effects of crack tip on fracture toughness of ductile iron have been studied.

16. 试验结果表明，低温淬火工艺可使外套圈获得优良强韧性与耐磨性。

Test showed that the low temperature quenching process may cause the outer rings to have excellent and stable strength, toughness and wear-resistance.

17. 通过调整合金成份和改变热处理制度试验，有效地提高了低温钢的低温韧性。

The low temperature toughness of low temperature steel can be improved effectively by means of adjusting alloy ingredients and modifying heat-treatment regime.

18. 试验表明，在T（10）钢中添加稀土元素对硬度没有明显的影响，但能显著改善该钢的冲击韧性。

The results show that RE additive may improve considerably the impact toughness and has little effect on hardness of steel T10.

19. 具有超高强、高韧性、高性能的水泥基复合材料必将获得更为广泛的应用，超高强水泥基新型材料的试验研究代表着水泥材料科学的研究方向。

The cement-based compound material with ultrahigh strength, high tenacity, and high performance will be used more widely, and this is the research direction of cement science.

20. 根据试验测定的焊缝各区冲击韧性、断裂韧性、疲劳裂纹扩展速率和疲劳裂纹扩展门槛值，对焊缝力学性能作出综合评价。

The mechanical properties of the butt welded joints have been evaluated according to the impulsive and fracture toughness as well as the rate and threshold values of fatigue crack propagation.

21. 试验结果表明：减小浆网速比，增强了纤维定向作用，裂缝纵向分布增加，导致纸张中纵横向断裂韧性差异增加。

The results indicate that the difference of fracture toughness between MD and CD increases with a decrease in jet_wire speed ratio, and the main reason is stronger fibre orientation.

22. 试验结果表明，在混凝土中掺入聚丙烯纤维可以提高混凝土的韧性，抑制混凝土的开裂过程，从而有效达到防裂的目的。

The experiment result shows that adding polypropylene fiber into concrete can improve its ductility and inhibit its cracking process and ultimately achieve the cracking-control aim.

23. 通过硬度试验、冲击试验、断口扫描和金相组织观察，研究了T92钢焊接接头的韧性与组织的关系。

Through hardness test, impacting test, SEM of failure surface and microstructure observation, the relationship between the toughness and its microstructure of welding joint of T92 steel was studied.

24. 通过冲击试验，研究了水韧处理质量对高锰钢低温韧性的影响。

The effects of water toughening quality on the toughness at low temperature of high-manganese steel was studied using impact -tests.

25. 扫描电镜下的原位准静态拉伸试验表明，合金的断裂行为是穿晶韧性断裂。

The result of insitu-tensile test shows that the behavior of fracture is transcrystalline rupture.

26. 试验表明：该钢空冷条件下即可获得准贝氏体、板条马氏体及孪晶马氏体的复合组织，且具有较好的强韧性配合。

The results indicated that the steel is composed of quasi bainite, lath martensite and twin martensite under air cooling condition, and also has better combination of strength and toughness.

27. 试验结果表明：带状组织的分布对焊缝强韧性影响较大。

The test results show the band structure distribution has great influence upon the strong toughness of welded pipe seam.

28. 针对不同种类异形钢纤维进行了弯曲韧性、断裂韧性、立方体抗压强度等试验。

Experiments on bending toughness, breaking toughness and cube strength test results are carried out in connection with various kind of deformed steel fiber.

29. 对刮痕强度试验机进行适当的改进，就可测量芯砂的冲击韧性，并使一机两用。

The scratch strength tester has been improved in the paper, which can measure the impact toughness and has two uses.

30. 对层板复合材料试验结果的分析表明，设计的测试装置有效，建立的测试方法是对层板复合材料断裂韧性测试的有益尝试，有较大的参考价值。

The representative testing results of laminates show that the equipment is effective and the testing method is a promising attempt, which can be used for reference.