词语导航
基本信息
词语：断裂载荷
繁体：斷裂載荷
拼音：duàn liè zǎi hé
英语翻译
【化】 crippling load
相关词条
1.breakingload 2.fracturingload 3.cripplingload 4.crushingload 5.breakload分词翻译
断裂的英语翻译：
part; rupture【计】 break-away; breakout
【化】 breakage; cracking; failure breaking; fracture
【医】 fragmentation
载荷的英语翻译：
load【化】 load
翻译例句
1. 对失稳断裂载荷进行了塑性极限分析。
The plastic limit analysis is applied to the unstable fracture load.
2. 在试验温度区内，控制韧性的因素是断裂载荷、纤维裂纹长度和单位纤维裂纹扩展能量。
Within the range of test temperature, the factors controlling the toughness are fracture loads, the lengths of fibrous crack, and the energy absorbed by each fibrous crack extension.
3. 尚未发现锶对动物体重、体长、血清AKP活性、尿钙水平以及股骨弯曲断裂载荷的影响。
Effects of Sr 2+ on body weight, body length, AKP activity of serum, calcium content of urine and breaking load of bended femur for rats were not found.
4. 结果：经统计分析，结果显示纤维桩修复组样本断裂载荷显著高于对照组，其断裂模式较对照组更为有利。
Results: Statistical analysis revealed that specimens with fiber posts demonstrated significantly higher failure loads and favorable fracture pattern compared to the controls.
5. 曲线上第一载荷峰值略低于单纯胶接接头的断裂载荷，第二载荷峰值与单纯电阻点焊接头的强度基本一致。
The first peak load is lower slightly than the fracture load of adhesive bonded joints, and the second peak load is almost the same as the fracture load of the spot welded joints.
6. 曲线上第一载荷峰值略低于单纯胶接接头的断裂载荷，第二载荷峰值与单纯电阻点焊接头的强度基本一致。
The first peak load is lower slightly than the fracture load of adhesive bonded joints, and the second peak load is almost the same as the fracture load of the spot we…
7. 在螺纹材料、尺寸、载荷都相同的情况下，三角形螺纹牙所受的剪应力最小，断裂载荷也比梯形螺纹和矩形螺纹高。
In the same material, dimension and load circumstance, the cut stress of the triangle thread is smallest. Its rupture load is higher than the echelon and rectangle.
8. 实质断裂强度性能受到了外加载荷与磨削残余应力的组合应力的制约。
The real fracture strength is restrained by both stresses caused by outside load and residual stresses after grinding.
9. 当外加载荷超过材料强度极限而造成零件断裂称为过载断裂。
When the applied load exceeds the limit strength of the material as a result of parts breaking overload fracture.
10. 应用传统强度理论和细观力学方法对几种韧性材料在复合载荷条件下的断裂机理、启裂位置、开裂方向进行了实验分析和应力场计算。wWW.WentIyi.cOm
In this paper, fracture mechanism, position and direction of crack initiation of mixed mode fracture in several ductile materials are tested, and stress distributions of which are analyzed.
11. 如果都把一个构件的最终断裂作为疲劳破坏的定义，则S - N曲线和裂纹扩展率曲线均是反映金属在疲劳载荷作用下的基本材料特性。
If the failure is defined as the final fracture of a component, then both S-N curves and crack growth rate curves reflect the fundamental material behavior under fatigue loading.
12. 通过室温下的仪器化冲击试验和静态拉伸试验，研究一种低屈服比高强度钢板在冲击载荷下的力学性能和断裂机理。
Mechanical properties and fracture mechanism of high strength steel sheet with low yield ratio under impact loading have been studied through instrumented impact and quasi-static tensile tests.
13. 从揭盖机所承受的载荷及其运行机构浮动轴的结构两方面分析了浮动轴断裂的原因，并找出预防其断裂的措施。
The reasons causing the fracture in view of the load on the manipulator and the structure of the floating axis are analyzed and precautions for preventing fractures are stated out.
14. 在给定裂纹尺寸与载荷条件下，利用断裂评定程序对一裂纹缺陷进行了评定，得到了海底管线失效评定曲线(FAD图)。
Under given crack dimensions and load condition, to appraise to cracks defects with fracture appraisal program and obtained submarine pipeline failure appraisal diagram (FAD).
15. 随着最大载荷保持时间的增加，塑木复合材料进入延迟弹性变形阶段越晚，弯曲挠度增加越快，断裂寿命降低。
The delayed elastic deformation stage came later, the bend deflection increased more quickly, and breaking life shortened with the increase of the prolongation of the maximum load hold time.
16. 回转窑运行中由于轴线偏移，支承载荷分配不均导致托轮轴疲劳断裂。
Axis line deflection and asymmetric load distribution of the rotary kiln induce the cracking of supporting shaft frequently.
17. 采用恒载荷和慢应变速率动态拉伸实验方法，测定了X80管道钢在不同充氢条件下的氢致开裂门槛应力和断裂应力。
The threshold stress and fracture stress of hydrogen-induced cracking of X80 pipeline steel are studied by constant load test and slow stain rate test.
18. 还结合壳体材料性质及载荷强度，对破片的断裂特征及尺度分布进行了讨论。
The relations between material characters combining with loading-strength and fragment mass distribution are also discussed.
19. 本文研究在随机载荷作用下，管状杆件焊接部位裂纹的扩展及断裂问题。
This paper is devoted to the problems concerning the propagation and fracture of the cracks on the welds of the tubes under the random load conditions.
20. 骨盆目的是加强而不是弯曲载荷下断裂，从而保持持续的负荷曲线。
The pelvic bolster is designed to bend but not fracture under load, thus maintaining a continuous loading curve.
21. 这些接头和接箍在长期承受交变、冲击和振动载荷的工作条件下经常发生脱扣，甚至断裂。
Those tie-in and adaptor regularly drop out on secular cyclical loading, impulsion and vibration force, even breaking.
22. 文章介绍了一种利用恒载荷速率加载测试金刚石膜断裂性能的试验方法，并建立了国内第一台金刚石膜断裂性能测试的专用装置。
New Experimental methods for measuring the fracture properties of CVD diamond films are discussed. A special computerized testing rig has been invented which can operate at constant loading rate.
23. 点焊试样剪切试验中存在脱壳式、剪断式和压断式三种断裂模式，所对应的熔核尺寸和剪切载荷依次增加。
There are three fracture modes in shearing tests, i. e. , exuviation, shear and crush fractures, with nugget dimensions and shearing loads increasing in turn.
24. 探讨各向异性功能梯度材料裂纹板受纯弯、纯扭、弯扭载荷作用下的弯曲断裂问题。
The bending fracture problems of cracked plate for anisotropic functionally graded materials under loads of pure bending, pure twisting or bending and twisting are discussed.
25. 针对含缺陷压力管系断裂失效分析模式，结合实际操作工况，考虑多种载荷因素及材料性能参数，提出了管系断裂失效风险分析方法。
Considering the multiple loads and material performance parameters, the analysis method has been put forward based on it model and the practice.
26. 回转窑由于其支承载荷分配不均，托轮轴疲劳断裂现象频繁，这就严重影响了生产的正常进行，造成重大的经济损失。
Due to asymmetric load distribution of the rotary kiln, the cracking of support shaft occurs frequently, which will seriously impact the operation of the equipment and result in large economic losses.
27. 从载荷-COD曲线图中分析了无烟煤断裂时，载荷出现跳动的原因，根据载荷跳动情况可以确定三角形韧带开始起裂时间。
The reason for load jump when specimen is fractured has been analyzed on the basis of P-COD curves, and the time when the triangular ligament starts fracturing can be known according to load jump.
28. 试验结果表明，可以从一次有效的载荷-位移记录中同时确定脆性岩石的弹性模量、拉伸强度和断裂韧度。
The experimental results show that the elastic modulus, tensile strength and fracture toughness of brittle rocks can be determined from a valid load-displacement record.
29. 试验结果表明，可以从一次有效的载荷-位移记录中同时确定脆性岩石的弹性模量、拉伸强度和断裂韧度。
The experimental results show that the elastic modulus, tensile strength and fracture toughness of brittle rocks can be determined from a valid load-displacement record.
版权声明：问题易所有作品（图文、音视频）均来源网络，版权归原创作者所有，与本站立场无关，如不慎侵犯了你的权益，请联系我们告知，我们将做删除处理！