输入管用英语怎么说，输入管的英文翻译

词语导航

基本信息

词语：输入管

繁体：輸入管

拼音：shū rù guǎn

英语翻译

【医】 afferentia; vasa afferentia

分词翻译

输入的英语翻译：

import; input; introduce
【计】 CI; enter; entering; in-fan; input; inputting; load line; typing-in
【化】 input
【医】 importation; infusion; intromission
【经】 import

管的英语翻译：

canal; duct; fistula; guarantee; meatus; pipe; tube; wind instrument
【化】 pipe; tube
【医】 canal; canales; canalis; channel; duct; ductus; salpingo-; salpinx
syringo-; tuba; tube; tubi; tubing; tubo-; tubus; vas; vaso-; vessel

翻译例句

1. 输入管径，壁厚，管道材料，以及PT 500计算出最佳的安装方法，传感器和分离的距离。

Enter the pipe diameter, wall thickness and pipe material, and the PT500 calculates the optimum mounting method and separation distance for the sensors.

2. 新型的FET输入管放大器(如ad820系列放大器)，在设计上做了改善，对于额定电源电压范围之内的信号，能够防止输出电压相位反转。

New FET-input amplifiers, like the AD820 family of amplifiers, incorporate design improvements that prevent output voltage phase reversal for signals within the rated supply voltage range.

3. 在一般的双极晶体管，带有电输入和输出端口，这定律完全适用。

On a basic bipolar transistor, with ports for electrical input and output, the law applies straightforwardly.

4. MOSFET的输入二极管是由一个电场控制在门区，因此总是输入阻抗非常高，因为没有正向偏置二极管，以降低输入阻抗。

The MOSFET input diode is controlled by an electric field in the gate region, thus the input impedance is always extremely high because there is no forward biased diode to lower the input impedance.

5. 改变输入电压能降低屏障并增加晶体管电流，正如加入酶使化学反应加速一样。

Changes in the input voltage lower the barrier and increase current flow in transistors, just as adding an enzyme to a chemical reaction speeds it up.

6. 最简单的例子是开关(输入)和发光二级管(输出)。wWw.WenTiYi.CoM

The simplest examples are switches (inputs) and LEDs (outputs).

7. 通过对电容器充电回路开关管进行控制，实现交流输入端的高功率因数。

High power factor at ac input can be achieved by controlling the switch of capacitor charge circuit.

8. 不同偏置电压的输入缓冲晶体管。

Different bias voltage for the input buffer transistor.

9. 放大器输入为电压信号，与光敏二极管产生的光电流信号成比例。调制光柱以断路器同样的频率照射光敏二极管。

The amplifier input is a voltage proportional to the photocurrent signal produced by a photodiode, which is irradiated by a modulated light beam at the same chopper frequency.

10. 用一对二级管以反向偏执于正常方向的形式连接至电源端，来保护过高的输入电压。

Protecting against excessive input voltages using a pair of diodes to power supply reversibly biased in normal direction.

11. 其主开关管的电压应力均为输入电压的一半。

The voltage stress of each main switch is only half of the input voltage.

12. 本方法研究轧管变形，具有计算费用低，输入数据简单的特点。

It has the advantages of Iow computing cost and simple input data when using this method to study the tube plastic deformation.

13. R2和R4用来降低因输入失调电流产生的误差，其原理与前文光电二极管放大器所述一致。

R2 and R4 are chosen to minimize errors due to input offset current as outlined in the section describing the photocell amplifier.

14. 本文所设计的正弦信号发生器主要由DDS波形产生模块、单片机控制模块、键盘输入模块和数码管显示模块组成。

This system consists of DDS signal generator module, MCU control module, keyboard input module and nixie tube display module.

15. 本文提出了一种新型的零电压零电流开关pwm推挽三电平直流变换器，其中开关管的电压应力为输入电压。

This paper presents a novel zero voltage and zero current switching (ZCS) PWM push pull three level converter in which the voltage stress of switches is input voltage.

16. 要着重讲授或改善每个划臂阶段的水感- -讲授象划水掌、脚蹼和外科医用胶管等训练辅助物的使用，将会有助于提高感官知觉的输入。

Emphasize the feel of each stroke phase being taught or improved - teaching aids such as paddles , fins , and surgical tubing may help to improve sensory input.

17. 压力控制管控制着输入到生产过程或应用的气体压力。

A pressure control manifold then controls the gas pressure that is fed to the process or application.

18. 螺纹铣床供给系统可将管从料斗移动至螺纹铣床输入点。

Threader feed systems move tubes from the hoppers to the input point of threaders.

19. 在版图的设计上，对输入级采用交叉耦合结构，减小由于工艺原理引起的MOS管匹配，从而减小电路的失调电压；

In layout design, the cross-couple structure is adopted in the input stage to minimize the MOSFET mismatch due to process, and consequently to lower the offset voltage in the circuits.

20. 实现产出和消耗蒸汽的连续平衡。主压力控制方法控制着输入锅炉的总热量以及流入每个锅炉联管箱的蒸汽量。

Achieve continuous balance between produced and consumed steam. This master pressure control approach controls total heat input into boilers, as well as total steam flow into each header.

21. 利用ANSYS57软件，输入建模方式及设计参数可对弹簧管的载荷与位移间的关系进行定量分析。

By using ANSYS5 7 software, the relationship between load and displacement of Bourdon tube can be analyzed quantitatively by entering modeling pattern and design parameters.

22. 系统硬件包括按钮开关输入电路、七段数码管输出电路、加热电路、升压电路以及波形控制产生电路。

The system hardware includes switch input circuit, seven segments LED output circuit, heating circuit and boost circuit.

23. 该拓扑具有所有功率开关均为软开关，输出二极管电压应力低和输入输出滤波器小的特点。

There are soft switching conditions of all switches, low voltage stresses on the output diodes, and smaller input and output filters in this topology.

24. 简述了FC- 308电子管发射腔体的调试过程，包括中和电路的调整、输入回路的调节以及输出回路的调试。

This paper briefly introduces the adjusting process of the emission cavity of FC-308 electronic tube including adjustments of neutralizing circuit, input circuit and output circuit.

25. 该混频器主要由波导-微带过渡，输入、输出滤波器以及匹配网络和反向并联混频二极管对组成。

The mixer mainly consists of a waveguide-to-microstrip transition, input and output filters, matching networks and an antiparallel diode pair.

26. 本文提出了以声脉冲管测量辐射头为方形的一种阵元(纵向振动换能器)的输入力阻抗的方法。

In this paper, a method of measuring the input mechanical impedance of the array element (longitudinal vibrating transducer) with square radiation head by using impulse sound tube is proposed.

27. 该混频器主要由波导一微带过渡，输入、输出滤波器以及匹配网络和三组反向并联混频二极管对组成。

The mixer mainly consists of a waveguide-to-microstrip transition, input and output filters, matching networks and an antiparallel Sckottky-barrier diode pair.

28. 晶体三极管的输入、出特性曲线测试，是模拟电子技术最基本的实验之一。

The test of characteristic curve for input and output of crystal triode is one of the most basic experiments in simulating electronic technology.

29. 本文研究了氖气压、输入电压、管壁温度和放电管气氛对铜蒸气激光器振荡—放大链最佳延时的影响。

Influence of Ne pressure, input voltage, wall temperature and discharge tube atmosphere on optimal delay of the CVL oscillator - amplifier chain is studied.

30. 本文研究了氖气压、输入电压、管壁温度和放电管气氛对铜蒸气激光器振荡—放大链最佳延时的影响。

Influence of Ne pressure, input voltage, wall temperature and discharge tube atmosphere on optimal delay of the CVL oscillator - amplifier chain is studied.