
词语导航
基本信息
词语:桥电路
繁体:橋電路
拼音:qiáo diàn lù
英语翻译
【电】 bridge circuit
分词翻译
桥的英语翻译:wwW.WEnTiYI.COM
bridge【医】 bridge; pons
电路的英语翻译:
circuit; circuitry【计】 electrocircuit
【化】 circuit; electric circuit
【医】 circuit
翻译例句
1. 文中介绍了采用单相半桥电路实现可逆整流的方法。
A method is introduced that reversible rectification can be realized with single-phase half-bridge circuit in this paper.
2. 提出用三相逆变桥电路实现单相电容电机变频调速的方案。
The paper proposes a scheme of using three phase inverter bridge to realize VVVF of single phase capacitor motor.
3. 一种新颖的具有故障隔离特性的半桥电路结构六相永磁容错电机控制系统。
The invention relates to a novel six-phase permanent magnet fault-tolerant motor control system in a half-bridge circuit structure, which has the characteristic of failure isolation.
4. 本文对四段全控桥电路在整流、逆变工况的微机实时控制进行了理论阐述和物理模拟试验。
This paper concerns the microcomputer-based real-time control of four-step controlled bridge which works both in the mode of rectifier and inverter.
5. 系统主回路含三相全波整流桥电路,三对IGBT功率管组成的逆变器电路,制动电路及保护电路等。
The main loop includes a three-phase bridge, an inverter module with three IGBT power tubes, a braking circuit and protecting circuits, etc.
6. 逆变桥电路开关过程中出现的电压尖峰和大的开关损耗是导致主开关器件igbt损坏的主要原因之一。
The voltage peak and switching loss during switching of inverter is the main cause that due to the damage of IGBT.
7. 结果表明:采用智能功率开关的H桥电路具有工作可靠、控制策略简单、可靠,电路制造成本低等优点。
The results showed that the new H-bridge has more strong points in the aspects of reliability, convenience to control, low cost and so on.
8. 对智能功率开关的功能特性和采用智能功率开关组成的H桥电路的控制方法与工作原理进行了系统研究,并在试验台上对新的H桥驱动电路进行了试验验证。
Also it introduced the features of the smart power switches and the way to control the new H-bridge, which had been tested in test-bed and compared to traditional H-bridge.
9. 在设计方案中,采用第四代IPM作半桥主电路,以性能好、功能强的数字信号处理器TMS320 LF 240 X DSP为控制器。
In the plan of design, the fourth generation of IPM is used as the main half-bridge circuit and TMS320LF240X DSP with good performance and strong function is used as a controller.
10. 在设计中,以TL 494作为PWM产生电路输出控制信号,控制开关管的导通状况,在半桥反激式输出的基础上实现了电源的多路输出。
In the design, to produce circuit TL494 as a PWM output control signals, control of the on-switch situation, the half-bridge flyback output on the basis of the power of multi-output.
11. 系统以SPMC75 F 2413 A作为主控芯片来控制单相桥式逆变主电路。
The SPMC75F2413A chip is used as main control chip to control single-phase bridge inverter main circuit.
12. 还设有4个支路并联运行的全控桥式整流电路。
This system also has a 4-branch parallel fully-controlled rectification circuit.
13. 依据一个半桥逆变电路的实例详细介绍了高频变压器设计的一般方法和步骤,并讨论变压器损耗和温升问题。
The method of design high frequency transformer in half bridge inverter circuit is introduced exampled in detail, besides temperature rise and power loss are discussed.
14. 针对这些电路的优缺点及存在的问题,提出新的二极管全桥整流配合单开关PF C电路方案。
To overcome disadvantages of the circuits, an improved one is proposed, which consisted of diode full-rectifying-bridge and single-switch PFC circuit.
15. 文中针对船用恒电位仪单相可控桥式整流电路,推导了负载电压表达式,分析了负载电压的谐波组成;
To single phase SCR bridge rectification circuit of constant potential instrument, the expression of load voltage is derived and harmonic component of load voltage is analyzed in detail.
16. 检测电路分为全桥平衡模块、电荷放大器模块、信号放大模块、相关双采样模块、采样保持模块、闭环反馈模块、低通滤波模块和数字时序控制模块。
The circuit is divided into full bridge module, charge sense amplifier module, correlated double sampling and holding module, closed-loop feedback module, low-pass filter and time controlling module.
17. 介绍了以半桥串联逆变谐振电路P。
On the basis of halt-bridge, series, converting-resonant circuit P.
18. 论文选取全桥变换器作为主电路拓扑。
Full-Bridge converter is the main circuit topology of the inverter.
19. 介绍由MOSFET管构成的全桥开关电路在感性负载下大电流工作时两种吸收回路的实验研究结果。
This paper introduces the experimental results of two snubber circuits for the full bridge switch circuit constituted by MOSFETs in case of the inductive load and large current operation.
20. 文中介绍了L 297芯片与双极性桥式电路的设计原理。
In this article, the design principle of L297 chip and dual bridge driving circuit is stated.
21. 桥式限幅器用桥式电路作为限幅电路。
A bridge limiter is a bridge circuit used as a limiter circuit.
22. 论文选取全桥变换器作为主电路拓扑。
Full-Bridge converter is selected as the main circuit topology in this paper.
23. 提出一种适用于逆变桥臂模块的吸收电路。
This paper presents a novel passive snubber circuit suitable for inverter bridge leg modules.
24. 双回转机构的步进电机控制电路由TDA1521音频集成功率放大器组成平衡桥式功率驱动电路,由计算机并行口经过锁存器构成脉冲分配器。
To control stepping motors, the balance bridge power drive circuit is made up by TDA1521 integrated audio power amplifier, the pulse allotter is made up by the parallel ports of computer and latches.
25. 由于该电路能较好地实现多桥交替工作,降低开关器件频率,提高系统效率,因此,本文所做研究取得了良好的实验效果。
As the circuit can achieved Bridges" alternate work, and reduce the IGBT"s switching frequency, and increase system"s efficiency, therefore, good results of this paper is acquired.
26. MW直流电弧的电流控制采用2台整流变压器控制,通过调节晶闸管桥触发角构成24脉波整流电路。
MW DC arc furnace uses the current 2-transformer rectifier bridge thyristor controlled by adjusting the angle trigger to compose 24 pulse wave rectifier circuit.
27. 有关电子元件包括霍尔元件传感器、电动机控制电路及全桥式输出。
This includes the Hall element sensor, the motor control circuitry, and the full output bridge.
28. 现代高功率因数电子镇流器结构中普遍采用功率因数校正(PFC)和半桥逆变谐振电路拓扑。
The power factor correction (PFC) and half-bridge inverter circuit topology are commonly used in modern high power factor electronic ballasts.
29. 提出了一种由斩波电路与全桥逆变电路构成的电压型大功率晶闸管全桥逆变主电路。
A voltage type high power invert circuit which is composed of chopper and thyristor full bridge invertor is proposed.
30. 提出了一种由斩波电路与全桥逆变电路构成的电压型大功率晶闸管全桥逆变主电路。
A voltage type high power invert circuit which is composed of chopper and thyristor full bridge invertor is proposed.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
