
词语导航
基本信息
词语:法向压力
繁体:法向壓力
拼音:fǎ xiàng yā lì
英语翻译
【化】 normal pressure
分词翻译
法的英语翻译:
dharma; divisor; follow; law; standard
【医】 method
【经】 law
向的英语翻译:
always; at; be partial to; direction; face; out; to; toward
【医】 ad-; ak-; ob-
压力的英语翻译:
press; tension; compressive stress; pinch; stress; tax
【化】 pressure
【医】 baro-
翻译例句
1. 结果表明拉应力和法向压力均影响微动疲劳寿命。
The test results indicate that both the tensile stress and the contact pressure affect the FFL.
2. 比较了考虑与忽略旋转引起的法向压力梯度对计算结果的影响。
The comparison is made between the numerical results of 3DBLE with and without normal pressure gradient.
3. 研究结果表明,法向压力在模型铲刀表面呈二次曲面分布,在模型铲刀的中部取得最大值。
The experimental result shows that the normal pressure distribution on the surface of the model blade is a conicoid, the maximum of the normal pressure is in the middle of the model blade.
4. 试验结果表明,采用较大的法向压力或适当增大磨削速度等磨削参数,可以高效发挥陶瓷刚玉砂带的磨削性能。
The results indicate that increasing the vertical pressure or grinding speed is beneficial to the grinding process of ceramic corundum abrasive belt.
5. 根据理论计算得到了法向压力分布的简化模型,并结合有限元数值模拟对多点压边圈上的压力传递问题进行了分析。
The simplified theoretical model of normal pressure was derived, and the pressure delivery principle of multi-point blank holder was analyzed with FE simulation.
6. 令板面处的法向诱导速度与滑行板由纵摇和升沉运动所产生的法向速度相等,便得到求解未知压力分布的积分方程序。
By equating the normal induction velocity on the planing plate to its normal velocity of pitching and heaving motions, obtained the integral equations of the unknown pressure distribution.
7. 利用改进的剪切滞后法,研究了组成纤维缠绕压力容器中的环向层的横向开裂而在纵向层中引起的局部应变集中。wWW.WENTiYi.CoM
Local strain concentration in angle-ply lay caused by transverse crack of circular lay in composite pressure vessel was studied by means of advanced shear-lag method.
8. 本文提出和研究了一种可用于兆巴压力冲击压缩下测量金属电导率的新方法——四电极垂向引线法。
In this dissertation, a novel method using four electrodes perpendicular to shock front was proposed to measure the electrical conductivity of metals under shock compression up to megabar pressures.
9. 应用有限元法对由压头向涂层或未涂层铝基体施加正压力的情况进行模拟。
The finite element method was used to model situations where an indenter applies normal forces to a coated or uncoated aluminum substrate.
10. 应用有限元法对由压头向涂层或未涂层铝基体施加正压力的情况进行模拟。
The finite element method was used to model situations where an indenter applies normal forces to a coated or uncoated aluminum substrate.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
