三相流化床用英语怎么说,三相流化床的英文翻译


词语导航

基本信息

词语:三相流化床

繁体:三相流化床

拼音:sān xiāng liú huà chuáng

英语翻译

【化】 three phase fluidized bed

分词翻译

三相的英语翻译:

【电】 three phase

流化床的英语翻译:

【化】 ebullated bed; fluidized bed; fluidized layer

翻译例句

1. 介绍了三相流化床烟气脱硫系统。

This paper introduces a system of flue gas desulfurization with the three-phase fluidized bed.

2. 相含率是三相流化床重要的设计参数。wwW.wENTIYI.cOm

Phase holdup is an important design Parameter.

3. 提出了在三相流化床内用钡渣进行烟气脱硫的方法。

The process using barium residue in three - phrase fluidized bed reactor was developed to remove sulfur dioxide from flue gas.

4. 应用三相流化床电极反应器(新型电化学反应器)处理制浆废水。

Treatment of pulping wastewater by using a novel electrochemical reactor, i. e. the three phase fluidized bed electrode, reactor were invesigated.

5. 研究了气速、液速、液相粘度和表面张力对三相流化床平均压降的影响。

The effects of liquid and gas velocity, liquid viscosity and surface tension on average pressure drop in three phase Fluidized beds were determined.

6. 根据压强脉动信号波形和频域的分析结果,研究了三相流化床不同空间位置压强的脉动特征。

Accordimg to the results of wave form and frequency domain analyses of pressure fluctuation signals, characteristics of pressure fluctuation at different space locations were discussed.

7. 利用三相流化床进行固定化细胞降解废水中的表面活性剂十二烷基苯磺酸钠(LAS)的动力学研究实验。

A study is made of linear alkylbenzene sulfonate (LAS) degradation in waste water bybacteria immobilized onto particles of Sodium alginate in a three phase fluidized-bed reactor.

8. 研究建立了描写三相生物流化床床层膨胀特性的经验关联式。

The formula of expansion characteristic in the three phase biological fluidized bed has been founded in this study.

9. 本文研究了以高分子(聚丙烯酸酯类)载体为固相的三相循环流化床的部分流动特性;

Some flow characteristics of the fluid in the three-phase circulating fluidized bed with polymer porous carriers are studied in this thesis.

10. 本文针对汽-液-固三相循环流化床蒸发器的特点,把该种蒸发设备应用于中药大黄浸提液的蒸发浓缩。

In this paper, the vapor-liquid-solid three-phase circulating fluidized bed evaporator was applied to concentrate rhubarb liquid extract of Chinese traditional medicine considering its advantage.

11. 提出了一种新型蒸发沸腾传热方式,即汽液固三相循环流化床沸腾传热。

A vapor - liquid - solid three - phase circulating fluidized bed, which is a new type of evaporation boiling means, has been studied.

12. 工艺流程多采用三相生物流化床技术,除酚效率可达90%以上,但目前尚未工业化应用。

The three phase biological fluidized bed technology was commonly used, removing phenol efficiency can reach above 90%, but this technology has not been industrialized to date.

13. 建立了适用于烧碱法麦草浆黑液系统的三相循环流化床传热模型。

Flow boiling heat transfer mechanism in a three-phase circulating fluidized bed evaporator is analyzed, and then the heat transfer model used for wheat straw black liquor is proposed correspondingly.

14. 以多孔丸模型为基础,建立了三相生物流化床有机物降解的动力学模型。

The article has established the kinetic model of organic matter degradation in fluidised bed bio-reactor based on the porous pellet model.

15. 实验结果表明,汽-液-固三相循环流化床蒸发器具有良好的传热性能,其传热系数是汽液两相流蒸发器传热系数的1.5倍左右;

The results show that the heat transfer coefficient of vapor-liquid-solid three-phase circulating fluidized bed evaporator is 1.5 times of the vapor-liquid two-phase evaporator"s.

16. 用脉冲示踪法对二维三相循环流化床液体停留时间分布(rtd)进行了测定。

Pulse tracer method was used to measure the residence time distribution (RTD) in Two-dimensional Three-phase circulating fluidized bed.

17. 用光纤探头技术对三相循环流化床中的气泡大小及其分布进行了系统研究,实验测定了操作条件对气泡大小及其分布的影响规律。

The bubble size and its distribution has been studied in three-phase circulating fluidized beds by using the newly developed fiber optic probe system systematically.

18. 通过三相生物流化床处理炼油废水实验,提出了同时硝化反硝化反应。

The simultaneous nitrification and denitrification reaction is presented based on the experiments of treating refinery waste water on 3-phase fluidized-bed bioreactor.

19. 对气液固三相循环流化床中气固相含率沿轴径向的分布进行了实验研究和模拟。

Distributions of gas and solid holdup along radial and axial directions are investigated and simulated.

20. 该模型学习速率快,训练步骤少,逼近程度高,最大偏差不大于5%,为三相循环流化床蒸发器的传热计算提供了可靠的方法和理论基础;

Rapid learning speed, few training steps and high fidelity are advantages of the model. The maximal deviation is no more than 5%.

21. 该模型学习速率快,训练步骤少,逼近程度高,最大偏差不大于5%,为三相循环流化床蒸发器的传热计算提供了可靠的方法和理论基础;

Rapid learning speed, few training steps and high fidelity are advantages of the model. The maximal deviation is no more than 5%.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!