词语导航
基本信息
词语：组合应力
繁体：組合應力
拼音：zǔ hé yīng lì
英语翻译
【机】 compound stress
分词翻译
组合的英语翻译：
constitute; assemble; scheme; weave
【计】 combinatory; combining
【经】 combination
应力的英语翻译：
stress
【化】 stress
【医】 stress
翻译例句
1. 实质断裂强度性能受到了外加载荷与磨削残余应力的组合应力的制约。
The real fracture strength is restrained by both stresses caused by outside load and residual stresses after grinding.
2. 也有一个对最大组合应力的限制，持续负载加上位移应力，以限制渐变。
The maximum operating stress is computed and limited to prevent conditions of ratchet(progressive plastic deformation with cycles), and not to fatigue.
3. 给出高强钢焊趾表面裂纹在压弯组合应力下应力强度因子及其疲劳寿命计算式。
The formulae for calculating SIF and fatigue life of surface crack at weld toe of the high-strength steel under the combination stresses have been presented.
4. 给出了高强钢焊趾表面裂纹在压弯组合应力下应力强度因子及其疲劳寿命计算式。
The formulae for calculating SIF and fatigue life of surface crack at weld toe of the high-strength steel under the combination stresses were given out.
5. 最后，对砂土初步提出了一个能反映转型现象的组合应力-应变关系模型的理论框架。
The factors influencing the phenomenon of pattern transition such as soil types, confining pres…
6. 为了考查砰击的族效应对波浪和砰击诱导组合应力极值的影响，定义了泊松砰击族过程。
In order to examine the cluster effect of slamming on the extreme combined value of the wave and slamming-induced stresses, a Poisson cluster process was defined.
7. 锥齿轮在高转速下，在槽底的离心应力和振动应力的组合应力是引起齿轮破坏的主要原因。
At high gearing speed the combined stresses of centrifugal load and resonance vibration at the notches are the main cause for the catastrophic failure of the bevel gear.
8. 阐述了作用于PC轨道梁桥结构上的荷载，曲线pc轨道梁的内力计算，预应力计算，应力计算及组合。
The article have expounded the load acting on PC single track beam, and the calculation of curved PC single track beam including force, prestress and the stress etc.
9. 设计改进分三个阶段，即局部几何性应力集中改进、提高铸造质量的纯工艺改进和锻焊组合结构抱轴箱体的设计。
Design improvement is in three stages partial, geometrical stress concentration improvement, pure casting technology improvement and a forge-weld box body design.
10. 设计分析：含荷载组合计算、截面配筋设计、承载能力计算、截面应力验算、变形及裂缝宽度验算等。
Design and analysis: loading combinations, section steel area calculating, earring capacity computation, section stress checking, deformation and crack width checking and so on.
11. 组合凹模的应力分析是一个非常复杂的问题，对其进行精确分析是解决模具寿命的关键。
The stress analysis of combined die is a very complicated problem, and the exact analysis on it is a key to solve the mould life.
12. 本合同段控制性关键工程是预应力砼连续组合箱梁的施工。
The controlled crucial works for this contract section is the construction for the prestressed concrete continuous combined box beam.
13. 本文的主要目的是研究非线性波浪载荷作用下多种应力成份组合的船体结构疲劳损伤计算。
The major purpose of this thesis is to do some research work on calculation of fatigue damage of ship hull structures with combined bending stress under nonlinear wave loads.
14. 为了解决带预应力的组合结构拓扑优化问题，提出了组合结构优化算法的基本思想。
In order to deal with the problem of combined structural topology optimization, a basic algorithm idea is proposed.
15. 组合凹模的应力分析是一个非常复杂的问题，对其进行精确分析是解决模具寿命的关键。
It is a very complicated problem to analyze the stress of combined matrix, and the key point related to die life is to do it"s precise analysis.
16. 利用光弹性实验对非等长度组合厚壁筒进行应力分析，验证了有限元计算结果。
The stress of assembled circular tubes with different lengths was analysed with photoelastic test, and the calculated result by finite element method was probed.
17. 同时对比了在四种不同组合时，应力、应变的分布，塑性区范围的大小。
Comparison of four different combinations of the same time, the stress and strain distribution, the size of the plastic zone.
18. 分析了甘蔗种植机机架在弯曲和扭转组合工况下的应力和应变分布。
The stress and strain of the vehicle frame when bearing bending loads and bending-torsion loads are analyzed.
19. 组合凹模的应力分析是一个非常复杂的问题，对其进行精确分析是解决模具寿命的关键。
The stress analysis of compound female die is a very complicated problem. Its accurate analysis is the key to solve die longevity.
20. 用解析方法计算了受静水外压载荷作用的有环壳过渡段的锥—柱组合壳中的应力值，并用瑞利法计算了其失稳临界载荷。
Stresses in cone cylinder shells with toroidal transition inserted are investigated by an analytical method, and buckling pressures for the shells are presented by Rayleigh Ritzs method.
21. 石油钻柱的失效80 %以上都为疲劳破坏，这与钻柱在弯曲和扭转组合下的交变应力有关。
The fatigue rupture made up 80 percent of the total petroleum drillstring failures, which is related to the flexural-torsional alternate stress acted on drillstring.
22. 本文对计算结果进行分析，并按第三强度理论进行应力组合及寿命评估。
Calculation result is analyzed in this paper. Composition of stress and estimation of lifetime are done according to the third strength theory.
23. 本文根据热弹理论，提出了组合厚壁圆筒温度应力的计算公式。www.WENtiyI.CoM
Formulas based on the thermoelastic theory for computing temperature stresses in the composite hollow cylinder are presented in this paper.
24. 为研究组合活塞的变形和应力状态，进行变形设计提供了依据。
Provides a basis for studying the deformation and stresses distribution of composite piston and for the deformation design.
25. 最后基于该方法计算的应力场，应用并行组合模拟退火算法搜索坝基最危险滑动模式及相应的最小安全系数。
Finally, based on the stress fields of FEM analysis, the most dangerous sliding mode and the minimum anti-sliding factor are searched by parallel recombination simulated annealing algorithm.
26. 利用这两种模型分别计算了轴承套圈冷挤压组合凹模的预应力，并同拉美公式的计算结果进行了分析比较。
The prestressing force in combined dies to be used for cold extrusion of bearing outer race by the two mathematical models is calculated and compared with the results obtained by Lame formulae.
27. 运用预应力技术，发挥钢管混凝土的受力特点，提出一种新的组合结构——预应力钢管混凝土组合结构。
On the basis of prestressed steel structure and composite structure, a new composite structure was proposed, which combines properties of steel and concrete with prestress technique.
28. 金刚石异常双折射的不同形式和组合是生长应力和生长期后应力作用的结果。
The different styles and composite of birefringence are caused by growth stress and post growth stress .
29. 金刚石异常双折射的不同形式和组合是生长应力和生长期后应力作用的结果。
The different styles and composite of birefringence are caused by growth stress and post growth stress .
版权声明：问题易所有作品（图文、音视频）均来源网络，版权归原创作者所有，与本站立场无关，如不慎侵犯了你的权益，请联系我们告知，我们将做删除处理！