高温回火用英语怎么说,高温回火的英文翻译


词语导航

基本信息

词语:高温回火

繁体:高溫回火

拼音:gāo wēn huí huǒ

英语翻译

【化】 high temperature tempering; high tempering

相关词条

1.hightemperaturetempering  2.toughening  

分词翻译

高温的英语翻译:

high temperature
【医】 hyperthermia; hyperthermy

回火的英语翻译:

backfire; temper
【化】 back fire; temper
【医】 temper; tempering

翻译例句

1. 空冷后高温回火产生回火脆性。

However, a temper brittleness has appeared after high temper.

2. 经过对材料的分析试验,发现其具有高温回火脆性。www.WeNtIyi.com

By analytical testing the material discovered that it has high temperature temper embrittlement.

3. 经过对材料的分析试验,发现其具有高温回火脆性。

The results show that ZGMn13 steel has low temperature brittleness.

4. 微量V可提高高温回火后的强度,但降低塑性,应避免加入。

Microalloy element V should be avoided adding , although it improves the strength at elevated tempering temperature , but reduces the ductility .

5. 另外研究发现高温回火并不是引起零件表面脱碳的主要原因。

And the higher temperature tempering is not the main reason for the decarburization.

6. 高温回火后,马氏体的分解软化以及铁素体中位错密度减小是导致双相钢性能恶化的主要原因。

The decomposition of martensite and decrease of dislocation density in ferrite are the main reasons of deteriorating the mechanical properties of dual phase steel.

7. 其高温回火脆性是晶界上m_6c碳化物的析出长大和由此所产生的晶界磷偏聚共同作用的结果。

The tempering embrittlement results from the precipitation and growth of M_6Ccarbides particles and the segregation of phosphorus at prior austenite grain boundaries.

8. 与经普通淬火和高温回火的相比,经磁场淬火和高温回火的T10钢的抗拉强度提高了28%,断后伸长率提高了8。

The tensile strength, elongation and hardness of T10 steel subjected to magnetic field quenching and to high temperature tempering were separately increased by 28%, by 8.

9. 结果表明,采用水基工作液电火花加工,电火花加工后高温回火处理及喷丸强化等措施,都可提高试样的冲击疲劳寿命。

The results show that the impact fatigue life-time of the specimen will increase by means of high-temperature temper and shot-peening after EDM with the water-base working fluid.

10. 将计算得到的残余应力分布与实测的残余应力数据进行比较,两者符合较好,而且高温回火有效的降低了焊接残余应力的峰值。

Compared the welding residual stress with testing data, the both accord each other, and high temperature temper reduce the peak value of welding residual stress effectively.

11. 含氮奥氏体不锈钢的安全角优于硬度为HRC33.7和HRC30.1的高温回火中碳钢,前者具有较高的抗弹丸倾斜入射的能力。

The safe Angle of nitrogen alloyed austenitic stainless steel is better than high tempered middle carbon steel of HRC33.7 and HRC30.1 in hardness.

12. 高温淬火,金属熔化,退火,压力缓解,预热,特殊应用,回火。

High Temperature Hardening, Metal Melting, Annealing, Stress Relieving, Preheating, Special Applications, Tempering.

13. 通过高温抗氧化、盐雾腐蚀和应力腐蚀试验研究了07X16H6沉淀硬化不锈钢在使用状态(回火态)时的耐蚀性能。

The corrosion resistance of 07X16H6 precipitation hardening stainless steel in tempered state was studied using high temperature oxidation, salt-spray test and stress corrosion test.

14. 用基于风险检验评估方法分析了石化装置中运行的高温设备发生脆性断裂失效的可能性,介绍了利用回火脆化损伤因子确定最低升压温度的计算方法,为装置安全生产提供了可靠依据。

The method to determine the minimum upset temperature by means of the damage factor of temper embrittlement was introduced, and the dependable basis for equipment safe operation was offered.

15. 在高温下使用用途有:烧结、焊接、淬火、烧成、回火、徐冷。

At high temperature USES are: sintering, welding, hardening, sintering, tempering, Xu cold.

16. 结果表明:随淬火温度提高,低温回火脆性区向高温区漂移。

The results show with increasing quenching temperature the brittle temperature of the steel tempered at low temperature brittle temperature moves upwards.

17. 更高温度的保温处理使得回火马氏体的晶粒发生偏转,导致许多区域整体的取向关系难以满足K-S关系和N-W关系。

The heat treatment with higher temperature caused the orientation of martensite grains rotated to some extent, which caused most areas in the heated samples do not follow K-S and N-W OR accuratly.

18. 更高温度的保温处理使得回火马氏体的晶粒发生偏转,导致许多区域整体的取向关系难以满足K-S关系和N-W关系。

The heat treatment with higher temperature caused the orientation of martensite grains rotated to some extent, which caused most areas in the heated samples do not follow K-S and N-W OR accuratly.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!