极限应力用英语怎么说,极限应力的英文翻译


词语导航

基本信息

词语:极限应力

繁体:極限應力

拼音:jí xiàn yīng lì

英语翻译

【化】 limiting stress; ultimate strength; ultimate stress

分词翻译

极限的英语翻译:

limit; terminal; the maximum; utmost
【化】 limit(ing) point

应力的英语翻译:

stress
【化】 stress
【医】 stress

翻译例句

1. 这是本赛季的极限应力。

It was the season of ultimate stress.

2. 静压头,在整定安全阀时,影响,对极限应力。

Static head, in setting safety valves, effect of on limiting stresses.

3. 根据这种方法推导出简便的无粘结预应力筋极限应力计算公式。

Based on the method, a simple formula calculating, the ultimate strength of unbonded prestress tendons was deduced.

4. 在此基础上给出了便于工程实际应用的锚链极限应力简易计算公式。

Then simple formulas for calculating limit stress used in the engineering design are given and the precision is satisfactory.

5. 第5栏,伸长率在极限应力项,在百分比给出了一个说明"韧性的物质。

Column 5, the elongation at ultimate stress, in percentage gives an indication of the "Toughness of the material.

6. 因此,成形极限应力图作为复杂加载路径的成形极限判据更加方便和实用。

So it "s more convenient and practical to use FLSD as the criterion of forming limit."

7. 提出了根据不同污垢的耐压强度极限应力,设计喷咀直径及射流压力的理论方法。

The theory method of designing the diameter of jet nozzle and the water pressure are advanced in the light of the endurance limit stress on the dirt.

8. 从岩土类材料极限应力状态线所致的各向异性出发,提出了应力空间变换的思想。

Based on the anisotropy induced by the critical stress line, the idea of transformation of stress space is presented.

9. 测定脱细胞血管基质中胶原蛋白含量,检测血管脱细胞血管基质的伸长比、极限应力。

The collagen protein level of acellular vascular matrix was evaluated, the elongation ratio and ultimate stress were assayed as well.

10. 当两者面积不同时,斜筋对水平筋极限应力的影响较大,且斜筋自身的极限应力也会变化。

When the area of the two is different, horizontal strengthened bars are affected by inclined bars and inclined bars also change ultimate stress themselves.

11. 在VII级烈度地震作用过程中输电塔各构件未达到极限应力状态,塔具有较好的抗震性。

Maximum stress of tower is lower than ultimate stress which reveals that the tower has a good resistance in VII magnitude intensity earthquake.

12. 在此基础上给出了无粘结预应力筋极限应力计算公式和UPPC梁正截面抗弯强度计算方法。

The formula for calculating the ultimate stress of unbonded post tensioning tendons and the calculating method of ultimate flexural strength of UPPC beam Bridges are proposed.

13. 在分析国内外大量试验数据和文献研究的基础上,建立了无粘结预应力筋极限应力实用计算方法。

Based on the analysis of the experimental data and the research results reported in references, the practical calculating equation of the ultimate stress in unbonded post tensioning is proposed.

14. 综述了国内外成形极限应力图的研究进展,并指出了目前成形极限应力图研究所面临的主要问题。

The research progresses on FLSD were summarized, and the existing problems of FLSD were also pointed out.

15. 而以极限应力构成的成形极限应力图FLSD由于不依赖加载应变路径,已成为目前研究的热点。

While FLSD, which is stress-based and independent of strain path, has become the hotspot in this field.

16. 计算UPPC梁(板)的抗弯强度,关键是确定构件在极限承裁能力时无粘结预应力筋的极限应力值。

The key of calculating flexure strength of UPPC beam is to determine unbounded prestressed tendons ultimate value when the components are under their ultimate load ability.WWW.WENtIYi.COm

17. 无粘结部分预应力混凝土(UPPC)梁桥抗弯强度计算的关键,是如何确定无粘结预应力筋的极限应力。

The key to calculate the ultimate flexural strength of unbonded partially prestressed concrete (UPPC) beam Bridges is how to determine the ultimate stress of unbonded post tensioning tendons.

18. 利用现有齿根弯曲疲劳极限应力数据及其它齿轮资料,提出了稳定工况下齿轮齿根弯曲强度可靠度计算方法。

Using present bending fatigue limit data of gear tooth and other materials of gears, the calculating method of re liability is proposed for bending strength of gear tooth st steady condition.

19. 结果表明,成形极限应力图不受应变路径影响,对于同一失稳准则,在不同加载应变路径下几乎为同一条曲线。

The result shows that FLSD is independent of strain path, and that the FLSD under different strain paths are almost the same curve according to the same instability theory.

20. 根据现有的国内外公式,在理论分析的基础上对既有的多组体外预应力筋极限应力简化计算公式进行验证分析。

According to the present formula, this article mainly analysis the different simplified formula to the ultimate stress of external prestressing tendon on the base of theoretical analysis.

21. 混凝土矩形柱在FRP侧向强约束作用下,极限应力、极限应变的提高系数与FRP的包裹量及截面形状、特征有关。

For rectangular columns sufficiently confined with external FRP, the improvement of ultimate stress and stain is related to the amount of FRP and the shape and characteristics of the cross-section.

22. 从土体极限应力状态线所致的各向异性出发,结合原状土的力学特性,给出了原状土的应力空间、应力增量变换公式。

Based on the anisotropy induced by the critical state line, the idea of transformation of stress space is presented.

23. 在齿轮设计中,国产材料齿轮的弯曲疲劳极限应力仍然缺乏可靠的试验数据,大多是沿用ISO 6336提供的数据。

Bending fatigue limit stress is still short of reliable data for gear of domestic material in gear design mostly used are the data offered from ISO6336.

24. 并从应用性角度出发,对现场贮存、长期自然贮存试验、极限应力、加速贮存寿命试验等贮存可靠性评价技术进行了对比分析。

Besides, storage reliability evaluation technology such as field storage, long-term storage test, limit stress test and accelerated storage life test are compared in utility.

25. 还根据所得寿命分布作出了D型V带的P-S-N曲线,并据此推断出极限应力的分布规律可以用威布尔分布或正态分布描述。

Furthermore, the P-S-N curves of D type V belt are plotted and the distribution of limit stress are deduced.

26. 本文通过八对圆弧齿线圆柱齿轮的运转接触疲劳试验,得到了45钢正火齿轮的接触疲劳极限应力框图,可供圆弧齿线圆柱齿轮传动的接触强度计算参考使用。

In this paper, contact endurance limit diagram of 45 normalizing gear is obtained from contact fatigue teste on 8 pairs of CATT gears. It is worthy reference for a calculation of gear design.

27. 但是,以最大速率进行适应,要求承受的应力达到您身体的极限。

But adapting at the maximal rate requires that your body be stressed to its limit.

28. 通过计算证明引起断裂的根本原因是动应力超过了梁的许用疲劳极限,另一原因是梁的结构不合理。

The primary cause of breakage is that the dynamic stress exceeded the allowable fatigue limit of the beam, and another cause is that the structure of the beam is unreasonable.

29. 通过计算证明引起断裂的根本原因是动应力超过了梁的许用疲劳极限,另一原因是梁的结构不合理。

The primary cause of breakage is that the dynamic stress exceeded the allowable fatigue limit of the beam, and another cause is that the structure of the beam is unreasonable.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!