法向应力用英语怎么说，法向应力的英文翻译

词语导航

基本信息

词语：法向应力

繁体：法向應力

拼音：fǎ xiàng yīng lì

英语翻译

【化】 normal stress

相关词条

1.directstress  

分词翻译

法的英语翻译：

dharma; divisor; follow; law; standard
【医】 method
【经】 law

向的英语翻译：

always; at; be partial to; direction; face; out; to; toward
【医】 ad-; ak-; ob-

应力的英语翻译：

stress
【化】 stress
【医】 stress

翻译例句

1. 界面处残余法向应力较高，可能造成界面脱粘。

The normal residual stress at interface is great, which can result in the interface de-bounding.

2. 一方面保证了法向应力的降低，提高非密实件的可焊性能；

On the one hand guaranteeing reducing normal stress depression, enhancing the non-dense weld ability;

3. 同样的法向应力及高度处，切向位移随水泥含量的提高而增大。

The shear displacement increases with increasing normal stress and cement content at the same height in shear failure state.

4. 说明节理的抗剪强度与法向应力和节理表面形貌特征参数有关。

It is shown that the shear strength of joint is concerned with normal stress and weighted average of mean profile angles of joint surface.

5. 建立了考虑节理粗糙度与法向应力的节理峰值剪切位移计算新公式。

The results show that there is a negative relationship between peak shear displacement and joint roughness but a positive relationship between peak shear displacement and normal stress.

6. 抗拔强度的大小取决于拔出过程中作用于土钉表面的法向应力的大小。

The variation of normal stress in soil surrounding a drill-and-grout soil nail during drilling, grouting and pull-out is studied through both laboratory pull-out tests and numerical simulation.

7. 进而给出了求解机构杆件截面上任一点法向应力和横向剪应力以及各构件最大动应力的矩阵计算式。

The matrix calculating formulae are proposed for solving the normal stress and transverse shearing stress as well as the maximum dynamic stress, in each link of a planar linkage.

8. 不同方位的裂缝所处的地应力状态不同，本文建立了不同方位裂缝所受的法向应力和有效应力的模型。

Because the different orientation fractures endures different in-situ stress, several models have been obtained to estimate normal stress and efficient stress.

9. 本文用直接外加法向应力和用力矩板手加应力两种方法测量在不同压力下压电换能器材料的应力与应变关系。

In this work, the direct normal stress and the stress produced with torque wrench were applied on such transducers.

10. 在砂土密实度及法向应力较低情况下，筋土界面厚度随法向应力的增大而减小，两者呈一负相关的线性关系。wWw.weNtIYI.COM

Under the condition of low compactness of sand as well as low normal stress, the thickness of geogrid-soil interface decreases with increase of normal stress, exhibiting negative linear relationship.

11. 在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。

However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.

12. 在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。

However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.