
词语导航
基本信息
词语:故障阻抗
繁体:故障阻抗
拼音:gù zhàng zǔ kàng
英语翻译
【电】 fault impedance
分词翻译
故障的英语翻译:
breakdown; fault; hitch; malfunction; stoppage; trouble
【计】 booboo; F; failure; fault; malfunction
【化】 malfunction
【经】 breakdown; trouble
阻抗的英语翻译:
impedance
【计】 Z
【化】 electrical impedance; impedance
【医】 impedance
翻译例句
1. 将起搏系统阻抗和起搏心电图联系起来分析,有助于判断起搏系统故障的原因。
The pacing system malfunction can be detected by analyzing pacing ECG and the pacing system impedance.
2. 认为负载阻抗的变化和干扰信号是造成故障的主要原因。
The main reasons of the breakdowns are the changes of load impedance and disturbance signal.
3. 传统的阻抗法进行故障定位,难以克服过渡电阻等因素的影响。
The traditional fault location method based on impedance can not overcome the effects of transition resistance, etc.
4. 在典型的六相输电系统中,半正序、半零序和半负序故障分量不受系统阻抗变化的影响。
In typical six-phase transmission system, half positive sequence, half zero sequence and half negative sequence fault components are independent of the variance of system impedance.
5. 本文介绍了基于测量电缆阻抗进行电缆故障监测的原理。
A novel principle for communication cable trouble detection with impedance measurement is introduced.
6. 基于交流阻抗和两极电压试验数据的分析,发现发电机转子绕组因存在铜渣而造成匝间短路故障的原因。
Based on the analysis of AC impedance and two poles voltage test data, the reason of turn - to - turn short circuit fault caused by having copper dregs in generator rotor winding was found.
7. 分析表明,线路末端三相故障时,线路首端的测量阻抗不与故障距离成正比。
The analysis shows that the measured impedance at the head of the line is not proportional to the fault distance when a three-phase fault occurs at the end of the line.
8. 从理论上分析了同杆并架双回线跨线不接地故障时距离继电器测量阻抗的变化规律。
This paper analyses the rule of variations measuring impedance of distance relay when phase to phase fault occurs between two lines on double circuit line on the same pole (DLSP).
9. 以前的研究表明,接触故障对信号传输的影响与很多因素有关,如接触阻抗和信号传输频率。
In former research the effects of electric contact on signal transmission have relations with a lot of factors, such as contact impedance and the frequency of transmission signal.
10. 尤其较好地解决了高阻抗非线性故障的识别问题。
Especially it solves the identification problem of high impedance fault well.
11. 本文推导出用结点阻抗矩阵进行中性点不接地系统中任意两点异相接地故障计算公式,并编制程序在IBM机上调试通过,最后进行了算例分析。
This paper has derived calculating formulas of arbitrary two point faults in neutral non-grounded power system by bus impedance matrix. An example of calculation is carried out with IBM computer.
12. 前两种方法因受一些情况例如参数、故障点接地阻抗、运行模式等影响而具有较低的精确度,而行波法具有较高的精确性。
The fir st two methods have low precisions for influence oft these cases : line parameters , fault point grounding impedance , operating mode of power system.
13. 对于后备保护装置防止高阻抗接地故障,将配置一只双极方向过电流继电器,同瞬时跳闸附件的时间成反比。
For backup protection against high resistive ground faults, there will be a dual polarized directional overcurrent relay, inverse time with instantaneous trip attachment.
14. 飞控作动系统通用测试环境是检验飞机作动系统的动静态性能、阻抗特性、舵机故障模拟和试飞技术支持的重要途径。
The general test platform for actuator in flight control system is essential for the design and test of actuator"s static and dynamic performance, impedance characteristic and its failure simulation.
15. 利用功率平衡理论进行故障测距能够在原理上克服传统阻抗法普遍存在的受故障电阻影响的缺陷。
The location results are always affected by fault resistance in almost all conventional impedance methods in fault location, but the application of power balance theory can overcome the shortcoming.
16. 高压电缆的金属护套交叉互联导致行波在多个波阻抗不连续点产生了复杂的折反射行为,这对高压电缆线路的行波故障测距产生很大的影响。
The reflection and refraction of traveling wave are quite complicated at the sheath-crossing point of high voltage power cable, due to its remarkably noncontinuous surge impedance.
17. 该方式广泛适用于线路的阻抗测试,能迅速测量出电缆的断线、混线、浸水等各种故障的具体地点。
It is popular used in impedance test of line that will detect and find the exact location of faults i. e. of broken, mixture and soakage of wires.
18. 算法无需故障类型判别,不受系统阻抗、故障电阻、负荷电流以及分布电容的影响。
The algorithm does not need fault type identification, and its accuracy is not affected by fault resistance, system impedance, pre-fault load current and shunt capacitance.
19. 文章以网络支路阻抗方程作为电网数学模型,系统地研究了配电网故障计算的通用方法。
In this paper, based on network branch equation, a canonical method for calculating faults in a distribution network is systematically studied.
20. 以阻抗轨迹为例给出了三维矢量数据的生成算法及其他多种电力故障分析算法的三维分析模块图例。
By taking impedance locus as an example, an algorithm of generating 3-d vector data and other graphs of 3-d analysis modules for fault analysis in power system are given.
21. 通过对比电缆整定的单位千米阻抗值和电压电流值,来确定线路上的故障点。
Power lines have set impedance per kilometre and using this value and comparing voltage and current the distance to a fault can be determined.
22. 算法不受故障类型、故障电阻、系统阻抗、负荷电流的影响。
The algorithm does not need fault type identification, and is not affected by the fault resistance and pre-fault load.
23. 对于全并联直接供电牵引网短路故障,采用两相对称分量法,分析电路特征,得到短路阻抗表达式。
For the direct power traction systems with full parallel connection, the characteristics of short-circuit impedance is analyzed with method of two symmetrical phases, and the expression is acquired.
24. 精确故障定位的传输线是非常重要的电力系统。 故障定位有三个方法:阻抗法、故障分析法和行波法。
There existed three met hods for fault location : impedance method, fault analysis method and traveling wavemet hod .
25. 结果表明,SSSC在故障范围之内时对阻抗继电器的测量阻抗产生了很大的影响,应该采取措施减小SSSC对阻抗继电器的影响;
The result shows the measured impedance is greatly influenced when SSSC is present in the fault loop, therefore measures should be taken to reduce the impacts of SSSC on the impedance relay.
26. EMTDC仿真试验结果表明该方法可以准确地实现单相故障选线,并验证了文章对输电线路零序输入阻抗相频特性分析的正确性。
The EMTDC simulations indicate that the method can find out the faulty line correctly and prove that the analysis of the angle-frequency characteristic of zero impedance of the line is correct.
27. 实例计算入端阻抗与实测的结果吻合得很好,表明该模型可以用于变压器冲击试验的故障仿真分析。
The comparison between the calculated impedance and the measured impedance has shown that the proposed model can be used to simulate the impulse voltage test with sufficient precision.WwW.wENTIYi.cOM
28. 首先通过测量阻抗轨迹法对异相短路故障的测量阻抗的进行分析,得出牵引网发生异相高阻电弧短路故障时,常规原理的阻抗保护将拒动的结论。
Conventional impedance relay will refuse to trip according to an analysis of measuring impedance by means of impedance locus method when wrong-phase-coupling of traction power supply system occurs.
29. 首先通过测量阻抗轨迹法对异相短路故障的测量阻抗的进行分析,得出牵引网发生异相高阻电弧短路故障时,常规原理的阻抗保护将拒动的结论。
Conventional impedance relay will refuse to trip according to an analysis of measuring impedance by means of impedance locus method when wrong-phase-coupling of traction power supply system occurs.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
