危险应力用英语怎么说,危险应力的英文翻译


词语导航

基本信息

词语:危险应力

繁体:危險應力

拼音:wēi xiǎn yīng lì

英语翻译

【化】 severe stress

分词翻译

危险的英语翻译:

at stake; danger; hazard; jeopardy; peril; risk
【医】 risk
【经】 risk

应力的英语翻译:

stress
【化】 stress
【医】 stress

翻译例句

1. 在对“中油海5”钻井平台悬臂梁实地勘测的基础上,确定危险应力区。

Based on the field surveys about the cantilever beams of the "CPOE5" oil-drilling platform, dangerous stress areas are determined.

2. 对于敏感性材料,在低应力水平下也会发生断裂,危险性很大,容易引发承压管道和设备的爆破,造成重大事故。

Sensitive materials under low stress will suffer breakage which brings about large risk explosion of pressure bearing pipe and equipment is easily to be triggered causing major accident.

3. 本文分析推导了应力分界圆与临界起皱压应力、危险断面径向拉应力之间的关系,以及对临界起皱的影响。

This paper makes an analysis on the relation of the stress boundary with the critical tangential compressive stress as well as on its influence on critical internal wrinkling.

4. 这种容器的最大优点是在绕制过程中获得高预压缩应力,显著减少疲劳失效的危险性。

A tremendous advantage of these vessels is that high compressive stresses are induced during winding. This Prestressing greatly reduces the risk of fatigue failure.

5. 焊接裂纹产生的应力集中区是焊接构件在服役过程中最为危险的一个薄弱环节,对这个环节进行有效的安全评估,具有重要意义。

Stress concentration zones caused by welding cracks are the most dangerous weak-links in service processes of welding works, so an effective safety evaluation of the links is of great importance.

6. 该方法不仅能够考虑土的应力应变性质,而且能够在任意时刻确定最危险滑动面的位置及安全系数。

The method not only can consider behavior of stress strain of soil, but also can determine the most dangerous slip surface and its factor of safety at any time.

7. 结果表明,采用局部加热冷却的方法可以有效地减小叶片危险区域的残余拉应力峰值。

The result shows that the method of local heating-cooling can decrease the residual tensile stress peak in dangerous area of the blade.

8. 结果表明,开裂点、开裂角、最大切向拉应力和临界载荷随椭圆的纵横轴比和倾角的不同而变化,由此可得到最危险的倾角。

The results show that opening point, opening angle, maximal tangential stress and critical load vary with aspect ratio and inclined angle. The most dangerous inclined angle is obtained accordingly.

9. 对于承受内压的异径弯管,经向应力的危险截面是异径弯管的小端口横截面,符合直管的特征。

The dangerous section of meridian membrane stress of bend reducer under internal pressure is the section at large end, with the character of tube.

10. 采用有限元法对加氢反应器裙座支撑区进行有限元分析及优化设计,并对其危险截面作应力评定和强度校核。

The finite element method is applied to analysis and optimize the design of the hydrogenation reactor skirt support area, and stress of the risk section is assessed and strength is checked.

11. 因此,计算筒体尤其是其危险部位的应力,预测其裂纹扩展速度或其使用寿命,具有非常重要的实际意义。

Accordingly, it is very important and significant to calculate the stress of the cylinder especially in the dangerous position, and to predict its crackle expanding speed and its surplus life.

12. 木材抓具的抓爪,在不利工况下的危险截面是位于撑杆与抓爪联结爪耳处的内缘,该处所受应力最大。

Under unfavourable work conditions a dangerous section forms on the inner wing of the joint between sprag and grip, where the stresses are concentrated.

13. 最危险点在接头的第一啮合齿的齿根处,最大应力应变值一般均超过屈服极限。

The most dangerous point is at the root of the first engaged tooth of a joint. Generally, the biggest values of stress and strain may exceed the yield limit.

14. 由于隧道的形状、岩性及其初始应力状态的不同,结构不同部位的动态响应有较大的差别,应分别评价其危险性。

Because the structural response differs with differing tunnel shape, wall rock properties, and initial stress state, the safety of the tunnel in different location should be estimated respectively.

15. 研究发现X70钢的焊接残余应力相当高,这对管线在腐蚀环境运行是相当危险的,需要消除。

The welding residual stress is very high in X70 steel, it is dangerous for the pipeline performance under corrosion condition, and necessary to be eliminated.

16. 结论低血管壁面剪切应力,是动脉粥样硬化的危险性血流动力学因素。

Conclusion Low wall shear stress is a risk hemodynamic factor in the development of atherosclerotic plaque.

17. 在这种情况下,壹个人的体温可能攀升到危险的临界点,身体遭受热应力,可能进而导致轻度中暑或中暑。WWw.WEnTiYI.com

Under these conditions, a person"s body temperature may climb dangerously, subjecting the body to heat stress that may progress to heat exhaustion or heat stroke.

18. 最后基于该方法计算的应力场,应用并行组合模拟退火算法搜索坝基最危险滑动模式及相应的最小安全系数。

Finally, based on the stress fields of FEM analysis, the most dangerous sliding mode and the minimum anti-sliding factor are searched by parallel recombination simulated annealing algorithm.

19. 应力性骨折的危险因素为吸烟和入伍后跟不上行军速度,OR值分别为1.67和1.70 ;

Smoking and drop behind during marching were risk factors with OR 1.67 and 1.70 respectively.

20. 然后将模型在危险载荷作用下,进行应力冻结、切片及应力分析。

The stress freezing under a uniform pressure, slicing and stress analysis are performed on the model.

21. 合理的开采设计应尽量避免和解除应力的高度集中和发生因应力升高而引起的危险。

The reasonable mining design should avoid and relieve the stress as far as possible the high degree of concentration.

22. 合理的开采设计应尽量避免和解除应力的高度集中和发生因应力升高而引起的危险。

The reasonable mining design should avoid and relieve the stress as far as possible the high degree of concentration and has because the stress to elevate the danger which causes.

23. 分析了影响热锻模热负荷与危险点处热应力的因素。

The factors of influencing the thermal load and thermal stress at the peril point of hot forging die were analyzed.

24. 得出了内压和外载下三通应力的分布规律、危险点的位置及其应力集中系数。

The distribution pattern, critical location and concentration factor of the stress on equal diameter tees under both internal and external loadings are obtained.

25. 通过应力修正系数对危险点最大应力进行修正,将应力集中和应力梯度效应引入到寿命的估算中,因而扩大了传统的应力寿命法可适用的寿命范围。

Then the effect of Stress Concentration and the Stress Gradient were introduced into the prediction of fatigue life through Correction Coefficient of Stress with the wider suitable life scope.

26. 通过应力修正系数对危险点最大应力进行修正,将应力集中和应力梯度效应引入到寿命的估算中,因而扩大了传统的应力寿命法可适用的寿命范围。

Then the effect of Stress Concentration and the Stress Gradient were introduced into the prediction of fatigue life through Correction Coefficient of Stress with the wider suitable life scope.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!