负端用英语怎么说,负端的英文翻译


词语导航

基本信息

词语:负端

繁体:負端

拼音:fù duān

英语翻译

【计】 negative terminal

分词翻译

负的英语翻译:

bear; tote; shoulder; suffer; minus; negative; owe; rely on; lose
【医】 Lift

端的英语翻译:

carry; end; fringe; point; proper; upright
【计】 end
【医】 extremitas; extremity; telo-; terminal; terminatio; termination; tip

翻译例句

1. 按照惯例,电路中的电流被认为是从正端流向负端,上电子足以反方向流动的。

By convention, current in a circuit is considered to flow from a more positive point to a more negative point, even though the actual electron flow is in the opposite direction.

2. 将寄生电容非灵敏有源开关电容网络(SCN)划分成若干个子网络,对每个子网络定义了运放负端组元割集;

The parasitic-insensitive active switched capacitor network(SCN) is partitioned into several sub-networks. Each subnetwork is defined as the op. amp.

3. 模拟电路实验证明用两个同极性的晶体管以多种电路接法都能获得具有S型负阻特性的两端器件。

The experimental results of analogue circuit show that type-S negative resistance can be obtained by using two like polarity transistors with various circuit connections.

4. 这两种击穿过程均产生较强的辐射,且辐射频谱特征十分相似,表明云内闪电通道两端发生的击穿过程可能均为负击穿过程。

Radiation field spectra of the two concurrent breakdown processes are quite similar, indicating that the processes may be negative breakdown and may be caused by the same mechanisms.

5. 组合框架梁由于梁端存在负弯矩区,其设计及构造较简支组合梁复杂,限制了其在实际工程中的应用。

In negative moment region of composite frame beam, its design and the detail of struction are more complicated than that of simply supported composite beam, so it was seldom adopted in project.

6. 实例分析表明,由于桩侧负摩阻力的影响,单桩承载力大为降低。产生负摩阻力的土层,不宜采用端承型桩基。WWW.WENTiYi.cOM

The greatly reduced capacity of a single pile resulting from the negative friction leaves the end-bearing pile unsuitable in the backfilling soil.

7. 当管道某处突然发生泄漏时,泄漏处将出现瞬态压力突降,形成一个负压波,并以一定的速度向管道上、下游两端传播。

When there is a leak point in the pipeline, the pressure is fallen and the negative pressure wave occurs at once.

8. 主梁后浇结构层与墩顶梁端湿接头浇筑顺序以及墩顶负弯矩预应力筋张拉顺序是简支变连续梁桥施工的关键工序。

The constructing procedure of the monolithic layer and the wet joints of the girders and the orders of straining the pre-stress force are the key orders of the simply supported-continuous system.

9. 最后,对不同结构和工艺参数的三端bnrt进行了模拟,总结出器件结构和工艺参数对负阻特性的影响。

Finally, 3-terminal BNRT with different structure and process parameters is simulated, and the influence of device structure and process parameters upon negative characteristics is summarized.

10. 每一级正相和负 相信号输出端分别与各输出缓冲电路的正相和负相输入端相连。

The input ends of positive phase and negative phase of the first time-delay unit are respectively connected with the output ends of positive phase and negative phase of the last time-delay unit.

11. 在一定长度的管线两端安装传感器 ,测量出由于漏油而产生的负压力波 ,根据负压力波传到两传感器的时间差计算出漏点的位置。

One of the key technologies of the method is to determine the time between suction waves going through the two measuring points of the pipeline.

12. 在此实验基础上研制得到一种双向两端S型负阻器件(TBNRD器件).本文还对该器件产生负阻的原因进行了理论分析。

Based on this, a Two-terminal Bidirectional negative resistance Device (TBNRD) is fabricated and the theory of the negative resistance is studied.

13. 从系统功能设计过程出发,在分析反馈系统工作原理及其功能角色模型构造特点的基础上,认为反馈信号在输入端可等效为正、负、零三种误差信号。

In this paper, based on the functional role model theory, the reasoning rule and the technique of FMEA, which are facing to Built in Test BI.

14. 从系统功能设计过程出发,在分析反馈系统工作原理及其功能角色模型构造特点的基础上,认为反馈信号在输入端可等效为正、负、零三种误差信号。

In this paper, based on the functional role model theory, the reasoning rule and the technique of FMEA, which are facing to Built in Test BI.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!