
词语导航
基本信息
词语:试验值
繁体:試驗值
拼音:shì yàn zhí
英语翻译
【计】 trial value
分词翻译
试验的英语翻译:
experiment; test; try; try on; try out; examination; experimentation; trial
trial run
【计】 breadboarding
【医】 probation; test; tria
【经】 test; trial
值的英语翻译:
cost; value; happen to; on duty
【医】 number; titer; titre; value
翻译例句
1. 计算结果与试验值相差较大。
There is a significant difference between the calculation results and the test results.
2. 其结果与试验值基本吻合。
The analytical predictions are in fair agreement with experimental results.
3. 结果发现曲线模型均与试验值吻合基本较好。
The results show that modeled curve corresponds with the test curve greatly.
4. 用本文推荐的方法所得到的计算结果接近于试验值。
It is shown calculation result are comparable to the measured are from model tests.
5. 在最佳试验条件下,试验值与方差分析预测值一致。
The experimental values agreed with the predicted ones by analysis of variance (AVOVA).
6. 试验表明,模型的计算值和试验值具有很好的一致性。
It is indicated through experiment that the result of this model and test are consistent.
7. 由于试样的不均匀性等原因,理论值一般高于试验值。
The theoretical result is generally higher than the experimental result, due to unevenness of nonwoven geotextile and other reasons.
8. 本文探讨了四点弯曲COD试验值在评定结构安全上的应用。
This paper describes the use of the four-point bending COD test in estimating tne safety of structures.
9. 应用该方法计算所得梁的受弯承载力比试验值平均小26%。
The ultimate flexural strength of SRC beam calculated by using this method is averagely 26 percent smaller than that of test.
10. 同时分析了实船计算结果与振动平台试验值之间存在差别的原因。
The reason of the difference between fullscale ship calculation result and readout of vibration platform test has also been analyzed.
11. 最后利用关联到的二元交互作用系数对计算值与试验值进行了比较。
Finally, the tested value is compared with the calculated value by use of incidenced binary interaction coefficient.
12. 从层间剪力包络图来看,试验值与有限元计算值都呈现近似直线分布。
For the inter story shear force, the distribution curves of calculation ones and test ones are approximately linear.
13. 本文计算公式物理概念明确,使用方便,其计算结果与试验值吻合较好。
The formula has a clear physical concept and is quite convenient, and its results have a better approach to the test values.
14. 在不同的转速和不同的体积比下,计算得到了与试验值较符合的离集指数。
Segregation index of calculation is consistent with experimental data under different volumetric ratio and rotating speed.
15. 算例针对国内某飞机液冷系统进行了性能分析,计算值与试验值吻合良好。
An example analyses the performance of LCS of a certain fighter in our country, and the calculated values are in consistent with the test results.
16. 实验室模型井架预测结果与试验值相差仅为5%,从而验证这一做法的可行性。
The relative error is only 5% between the forecasting result of Lab model and the result of collapsing test, which also proved that it is a feasible.
17. 得到了合理的速度场分布和温度场分布数值模拟结果,并与试验值进行了对比。
The prediction gives rational velocity and temperature distributions, which have been compared with the measured values of velocity and temperature.
18. 运用本文公式对试验梁计算结果较试验值约偏小10%,可以满足设计精度要求。
The results computed were 10% smaller than the test ones, which can satisfy the request designing accuracy.
19. 同时将试验值与理论值作出了比较,并且根据试验中的损耗对试验值进行了完善。
Meanwhile, the development between the experiment and theory are carried out through the measure experiment of fiber loss.
20. 预测了壁面压强和轴心速度分布,并与实验数据进行比较,计算值与试验值吻合很好。
Predictions have been made and compared with experimental data pertaining to the centerline velocity decay and wall static-state pressure variation.
21. 该公式计算简便,与试验值吻合较好,并与普通受弯构件受剪承载力计算公式相衔接。
These formulas are easy to use, similar to test results. and join to general members in bending.
22. 用幂函数模型描述的回归曲线以及根据试验参数得到模拟曲线与试验值比较误差均较小。
The errors of the data obtained using the power function model are very small from the test data.
23. 并按线性小振幅波理论,导出了改进的透射系数计算式,其计算结果与试验值符合良好。
A modified transmission coefficient formula is derived based on the linear small amplitude wave theory, and calculation results are in good agreement with the test results.
24. 用幂函数模型描述的回归曲线以及根据试验参数得到模拟曲线与试验值比较误差均较小。
The errors are less as comparing the test data with regressive curve and simulative curve from test parameters using the power function model.
25. 本文根据容器的压力试验目的,刘压力试验值、温度修正及其相应的限制条件进行讨论。
On the Basis of the purpose of the pressure test, the pressure test value, temperature, modification and the condition limitations were discussed in this paper.WwW.wEnTIYI.cOM
26. 利用有限元法对飞机闭合薄壁剖面杆结构进行刚度计算,其结果与全尺寸试验值吻合较好。
The rigidity calculation of the closed thin - walled section rod structure of aircraft is carried out by using finite element method and the result tallies with the full - scale test value well.
27. 计算结果表明:跨中截面上下缘应力计算值与试验值误差在5%左右,跨中挠度误差在1%左右。
The result indicated that, the section upper and lower reason stress error is about 5% while stepping, the deflection error, about 1%.
28. 用弹塑性截面分析法、非线性有限元法计算了梁的承载力与挠度,理论计算值与试验值吻合良好。
A nonlinear finite element method analysis is conducted that corroborates the results from the experimental study and inelastic section analysis.
29. 用弹塑性截面分析法、非线性有限元法计算了梁的承载力与挠度,理论计算值与试验值吻合良好。
A nonlinear finite element method analysis is conducted that corroborates the results from the experimental study and inelastic section analysis.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
