
词语导航
基本信息
词语:工作应力
繁体:工作應力
拼音:gōng zuò yīng lì
英语翻译
【化】 operating stress; working stress
相关词条
1.operatingstress分词翻译
工作的英语翻译:
job; work; employment; labour; pursuit; task【医】 ergo-
【经】 job; operations; task
应力的英语翻译:
stress【化】 stress
【医】 stress
翻译例句
1. 实测工作应力与实际结构强度一致;
The measured working stress is consistent with the actual strength of the structure.
2. 给出了求正常工作应力下参数点估计的方法。
Derive a way to get the point estimations of parameters under normal working condition stress.
3. 试验还证明,工作应力对粗晶区回火脆性的影响不大。
The tests prove that the working stress has little effect on the temper embrittlement of the coarse grained region.
4. 工作应力测试就是检测结构构件在使用时的实际应力。
The measurement of working stress is to measure the actual stress in a working structure component.
5. 在土木工程中,工作应力测试主要还是在钢结构检测中应用。
In civil engineering, the measurement of working stress is mainly applied in the steel structure.
6. 在工作应力作用下,裂纹不断扩展,最后导致拨叉完全开裂失效。
The fatigue crack extended under the applied stress and led to clutch fork crack and failure.
7. 认为,该曲轴材料的冶金缺陷是导致疲劳裂纹在正常工作应力下过早形成的原因。
The results show that metallurgical defect is the main reason leading to early formation of fatigue crack under normal working stress.
8. 然后确定了加速应力为影响气缸寿命的工作应力:流体温度、使用压力及气缸动作频率;
Then the determined accelerate stress is the stresses that affect the cylinder life as fluid temperature, working pressure and moving frequency.
9. 该条件表示转鼓在工作时弹性工作范围最大,它是最大合成工作应力最小原则的一个推广。
This principle, which is an extension of the principle that the maximum synthetic working stress is minimum, shows that the elastic working range of the bowl is maximum.
10. 焊点所承受的各种环境应力和工作应力的时间历程(时间应力)是其疲劳失效的直接外因。
The main external factor of solder joints degradation or deviation from an expected normal condition is the time stress such as work and environment stresses.
11. 滚子活齿传动设计中,在工作应力、许用应力的设计参数和影响因素中存在着许多不确定性。
The many indefinite exists in the design parameters and influence factors of the working stress and allowable stress of the roller movable teeth drive.
12. 此值被用来比较材料的强度,但是当设计计算时,要用一个安全系数,使工作应力低于比例限制。
This value is used to compare the strength of materials, but a safety factor is applied when making design calculations, to bring the working stress well below the limit of proportionality.
13. 本文是在有限元模拟分析基础上,制作5根混凝土柱,进行环孔法测试混凝土工作应力的试验研究。
On the basis of finite element analysis, 5 concrete columns were made to carry on the experimental study about the measurement of working stress of concrete by the ring-hole method.
14. 而混凝土结构的实际工作应力又是反映其状况的重要的指标之一,是建筑物改造加固的重要参数之一。
The actual working stress of the concrete structure is one of the important indexes which reflect structure state, and it is one of the important parameters for building alteration and strengthened.
15. 在上下级墙面后不同排数土钉的不同位置上埋设了钢弦式钢筋计,进行了其工作应力状态的性能测试。
We test the nail force of different station on different row soil-nailed wall with steel-string transducer in the upper and bottom wall are tested.
16. 该电路具有结构简单,实现软开关效果好、开关管和整流二极管工作应力小、效率高和工作可靠等优点。
The converter is characterized by simple structure, ZVS, low switch voltage stress, high efficiency and high reliability.
17. 结果表明,预扭后扭力轴弹性工作应力范围得到极大扩展,其主要原因在于预扭塑变形成的表面残馀应力。
The results indicate that the elastic operating stress range of a torsional axis is extended greatly by pre-twist process and the main reason lies on surface residual stress.
18. 表面裂纹萌生原因是拉杆在腐蚀性高炉煤气粉尘和轴向拉伸等工作应力的综合作用下,形成的应力腐蚀裂纹。
The initiation of the cracks was caused by stress corrosion resulting from the co-effect of the corrosive gas dust and the axial tensile stress.
19. 为确保钢结构工程的可靠性和安全性,必须严格控制连接螺栓的预紧力,必要时还要在线监测螺栓工作应力。
To guarantee the reliability and security of the steel construction, the clamp load of the joint bolt should be under strict control, sometimes even the tension of the bolt should be measured on-line.
20. 水轮机叶片有较大的工作应力、热影响区的晶粒粗大以及水介质的腐蚀性是产生机械腐蚀疲劳汽蚀的重要原因。WwW.WEntiyi.COM
The larger tension stress in the hydraulic turbine blades, grain coarsening in the heat-affected zone and the causticity of fluid medium are the major causes of cavitation erosion.
21. 最后,根据起重机车轮的工作应力和疲劳强度的概率分布,采用疲劳可靠性设计方法,对车轮进行了分析计算。
Lastly, using fatigue reliability design method, this paper analyses the crane wheel according to the probability distribution of its working stress and fatigue strength.
22. 结果表明,应力腐蚀是该膨胀节失效的主要原因,而局部的点蚀和残余应力、工作应力是应力腐蚀的必要条件。
The results show that the stress corrosion is the main failure causing of the bellows expansion joint, while the local pit corrosion, residual stress and the working stress is the necessary condition.
23. 通过对推土机平衡梁和车架纵梁的工作应力测定与分析,掌握了推土机的强度设计方法,为编制载荷谱打下基础。
Through test and analysis of working stress on balance beam and lengthwise beam of dozer frame, a strength design method and the basis for compiling load spectrum are given in the paper.
24. 通常情况下,我们可以将工程结构或构件的工作应力和应变状态看为相对含静态初应力的参考位形作附加的变形运动。
As a rule, the state of working stress and strain of engineering structures and components can thought of as making additional deformation movement on referenced configuration with static pre-stress.
25. 结果表明,该轴热处理上存在的不合理之处,导致轴在服役早期出现微裂纹,部分微裂纹在工作应力的作用下疲劳扩展,最终产生疲劳断裂。
The results show that the axle has defects in heat treatment, which leads to micro crack in early stage of service life and the extended crack finally causes fatigue fracture.
26. 零件的应力状况能够反映机械构件的工作状态,对它的有效检测和评估为提高产品的安全性、可靠性和稳定性提供了保障。
The working condition of mechanical components can be indicated by their stress states, whose measurement and evaluation can also improve the security, reliability and stability of the products.
27. 避免在工作辊辊端部位应力过于集中。确保弯辊得到很好的控制。
Avoid high stress concentrations at the ends of the work roll barrel. Ensure good control of roll bending.
28. 计算结果表明,分离器内部工作压力对分离器应力的贡献远大于风载荷和地震载荷。
The results show that the contribution of working pressure to stress of the Venturi separator is far greater than that of wind loads and seismic loads.
29. 曾在eBay担任高级行政官的Webb先生说道,“但是5年之后这个行业就会飞速发展”,他解释说,原因之一就是年轻员工将希望尝试各式各样的工作并且对远距离工作科技适应力更强。
One reason for this, he explains, is that younger workers will want many jobs during their careers and will be more comfortable with the technology that makes remote working possible.
30. 所有这些都是合理的统治强加过分参与工作(不仅在管理)和紧急情况下工作或高应力条件下的技术。
All of these are techniques of rational domination that impose over-involvement in work (and not only among management) and work under emergency or high-stress conditions.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
