消除信号用英语怎么说,消除信号的英文翻译


词语导航

基本信息

词语:消除信号

繁体:消除信號

拼音:xiāo chú xìn hào

英语翻译

【计】 clear signal

分词翻译

消除的英语翻译:

eliminate; banish; put out; relieve of; remove; resolve; slake; wipe
【计】 blanking; edulcorate
【经】 wipe-out; wipes-out

信号的英语翻译:

semaphore; signal
【计】 semaphore; signal
【化】 sign; signal
【医】 signal
【经】 call letter; signal

翻译例句

1. 从消除信号阻塞到进程执行下一个指令之间,必然会有时钟周期间隙,任何在此时间窗口发生的信号都会丢掉。

There has to be some gap of clock cycles between the unblocking of signals and the next instruction carried by the process, and any occurrence of a signal in this window of time is lost.

2. 在规划和优化通信网络的过程中,需要消除信号盲区,因此研究电波传播损耗就成为一个重要的课题。

In the process of marking out network, it need to avoid the existence of no-signal areas.

3. 作者认为利用程控放大器消除光栅信号缺陷的方法,可有效消除信号的幅值不稳定和直流电平漂移,并对信号的可调节范围及精度作了定量分析。

A method which can be used to eliminate the defects of the grating signal has been discussed. The controllable range and accuracy of the signal has been calculated.

4. 外观的小事情的后果是如此显著,社区团体通过快速消除这些容易被忽视的信号来解决“破窗综合症”将是明智的。

The consequence of small matters of appearance is so pronounced that community groups would be wise to address the "broken window syndrome" by quickly eliminating the signals of neglect.

5. 随后它便产生逆向声波从而消除耳机信号中不需要的噪声。

It produces an inverted sound wave to cancel out unwanted noise in the headphone signal.

6. 对于数以百万计的物种和土著人来说,这将是灭绝的信号,因为它将激励砍伐原始森林,以便为开垦种植园消除障碍。

For millions of species and indigenous peoples, this would signal extinction as it would incentivise deforestation of ancient forests and pave the way for plantations.

7. 作为对该和解姿态的回应,莫斯科发出了消除威胁的信号,取消部署在欧盟范围内加里宁格勒飞地的短程导弹。

Moscow responded to the conciliatory moves by signalling the cancellation of threats to deploy short-range missiles in its Kaliningrad exclave, which sits within the EU.

8. 在检测到待机信号时,单片机控制继电器开关,将电流切断,家电完全断电,消除了待机功耗,达到节能的目的。

When detecting standby signal, microcomputer gives structure to relay switch to cut off the current, then standby power is eliminated so as to realize energy saving.

9. 重复控制的基本思想是控制理论中的内模原理,根据上一周期的控制误差消除后面各周期性的信号误差。

The repetitive controller based on the theory of internal model produces correction signal based on the control error of the last cycle to eliminate the error in the latter cycle.

10. 该方法采用了相对幅值的信号峰提取技术,消除了绝对幅值变化带来的不利影响,准确性高,处理速度快。

The signal peak is searched by the relative amplitude instead of the absolute level, so as to reach high accuracy and speed.

11. 在这些情况下,可向开关加入滤波器来改变信号的频率带宽,或者从发射到DUT的信号中消除有害频率的杂散信号。

In these cases, filters can be added to the switch to modify the signal frequency bandwidth, or spurious signals at unwanted fre quencies can be eliminated from the signal to the DUT.

12. 在分析三角波调制的线性调频信号的基础上,提出了用DDR技术消除速度对测距的影响方法。

On the bases of analyzing triangle wave form modulated LFM, the method of using DDR (Dual Channel Directional Doppler range) technique to eliminate the influence of speed to range is presented.

13. 伪信号将频率有效的引入到你采集的现实信号中不存在数据中(和消除一些数据),从而严重扭曲了原始信号。

Aliasing has the effect of introducing frequencies into your data that didn"t exist in the real-world signal (and removing some that did), thereby severely distorting your signal.

14. 这种方法可以更好地跟踪信道变化,显著地消除接收到的导频信号中的加性噪声,提高信道估计精度。

Such method could better track channel change and eliminate the noise remarkably in the received pilot signal, and the precision of channel estimation had been improved.

15. 通过预处理滤除工频周期分量,消除了小波变换在信号峰值处的模极大值,从而避免了对故障的误判。

As wavelet module maxima occur at peaks of signal, the pretreatment removes power frequency periodic components from electric signal and thus avoids misjudgments of fault.

16. 实验结果表明,利用该方法可有效消除振动信号采集过程中混入的噪声。

Experimental results show that this method can simply and effectively remove the noise contained in the sampled vibration signals.

17. 当切换低压信号并进行低电阻测量时,可通过偏移补偿的方法消除热电效应偏移电压。

When switching low voltages while making low resistance measurements, the thermoelectric offset voltages may be canceled by using offset compensation.

18. 为此,需要消除PC G信号中的噪声,并用分段算法定位第一心音。

To achieve this, noise in the PCG signal should be removed, and a segmentation method should be used to locate the first heart sound.

19. 当在赛前3 - 4周完成“跑这个距离”,您的自信可以完全消除来自左脑的焦虑信号。

When one has "gone the distance" within 3-4 weeks before the race, your legitimate confidence reduces the anxiety messages from the left brain to almost nothing.

20. 它根据误码率信息有选择地实施干扰消除,先并行消除低误码率用户信号的影响,再检测高误码率用户信号。

It detects signals for users with high BER after canceling detected signals for users with low BER in parallel.

21. 采样保持电路设计采用了电容下极板采样技术,不仅有效地避免了电荷注入效应引起的采样信号失真,而且消除了时钟馈通效应的不良影响。

The sample and hold circuit is employed by the bottom plate sampling technique, which could not only cancel the charge injection error but also eliminate the effect of clock feed-through.

22. 全面分析了雷达信道对遥测信号的影响程度,为消除其影响提供了准确、可靠的理论依据。

The influence of radar channel on telemetering signal is analysed comprehensively in order to provide solid and reliable theoretical basis.

23. 动态范围达到60分贝。 电晕现象将受到抑制,饱和电平寄生信号可得到消除。

The dynamic range reached to 60 dB. The blooming is suppressed completely and the saturation-level shading can be removed.

24. 该方法可以有效的消除因本振信号频率漂移及闸门信号与被测信号的非同步引起的测相误差,同时提高了测量速度。

The phase detecting error caused by local oscillator frequency drift and non-synchronization of measurement signal and gate signal is eliminated and the measurement speed is improved at the same time.

25. 本文主要提出两种消除数字地震信号中长周期随机干扰的方法:窄带低通滤波对消法和自适应高通滤波法。

Two methods with which the long disturbance is removed from the digital are introduced: narrow band low - pass filtering canceling method and adaptive high - pass filtering method.

26. 为了更有效地消除齿轮泵振动信号的噪声,引入匹配追踪消噪方法。

In order to effectively abate the noise of geared pump vibration signal, matching pursuit is introduced for de-noising.WWW.WeNTiYI.Com

27. 仿真结果表明,它可以使信号实现重构,消除码间干扰,提高通信系统的性能。

The simulation result shows that this technology can reconstruct signal and erase intersymbol interference, so that the performance of communication system is improved.

28. 设计了一种能够消除其他雷达信号干扰的参差电路,阐述了参差电路的应用原理、工作原理,介绍了实际电路的工作过程和特点。

The diverse circuit is for eliminating disturbance signal of other radars. This article elaborates the application and work principle of diverse circuit, and the actual work process.

29. 在读取信号之前和之后,你可以提取存在于象素中的噪音信号,然后在后续的过程中通过减去这些噪音信号来达到消除它们的目的。

Before and after reading out the signals, you can extract noise existing within the pixels themselves, and then cancel it out by subtracting it at a later stage.

30. 最终达到消除PWM信号中的开关信号和电磁干扰信号,提高效率和保真度,减小输出滤波器的体积和成本。

Filter may serve the role to eliminate switching and EMI interfere in PWM signal. Thus to improve efficiency and fidelity, lower the filter cost and component sizes.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!