极电路用英语怎么说,极电路的英文翻译


词语导航

基本信息

词语:极电路

繁体:極電路

拼音:jí diàn lù

英语翻译

【电】 polar circuit

分词翻译

极的英语翻译:

bally; cruelly; extreme; fearfully; mighty; pole
【医】 per-; pole; polus

电路的英语翻译:

circuit; circuitry
【计】 electrocircuit
【化】 circuit; electric circuit
【医】 circuit

翻译例句

1. 特点:低功率控制极电路。

Features: Low power gate trigger circuits.

2. 该工艺与已有的双层多晶硅自对准NPN晶体管工艺相兼容,可用于制造高性能的互补双极电路。

The process is compatible to the existing double poly-silicon self-aligned NPN transistor process, which can be used to fabricate high-performance complementary bipolar circuits.

3. 如果你实现了上述两点,你还需要一个控制每个二极管的驱动,这意味着需要更多的电路和固件。

Once you"ve got that, you also need a driver to control the individual diodes, which means additional circuitry and firmware.

4. 我触碰了错误的管脚,从而导致了电流的反转,结果那块电路板上的所有二极管都被烧坏了。

I touched the wrong pins causing a current reversal and all of the diodes on the circuit board exploded.

5. 而且,既然运行有机发光两极管屏幕所必需的电路现在被开发出来,那么它理应能简单地用量子点去代替有机发光两极管。

And, since the circuitry needed to run OLED screens has now been developed, it should be reasonably simple to substitute OLEDs with quantum dots.

6. Acme代表了零件方面的主要制造商,例如电子和硬件、电桥和二极管、电容器、连接器、感应器、LED显示器、集成电路和电阻器。

Acme represents major manufacturers in parts, such as batteries and hardware, Bridges and diodes, capacitors, connectors, inductors, LED displays, integrated circuits, and resistors.

7. 方形光二极管阵列包括四个集成在通用磷化铟(InP)衬底上的光二极管单片集成电路,采用低制造、集成与测试率的铟镓砷化物/磷化铟半导体工艺制造。

The Quad PD Arrays consist of four photodiodes monolithically integrated on a common indium phosphide (InP) substrate, and are fabricated using a low FIT rate InGaAs/InP semiconductor process.

8. 开关磁阻电机是由功率开关电路、双凸极磁阻电机及控制器构成的新型调速电动机系统。

The switched reluctance drive is a new variable-speed motor system which consists of power electronically-switched circuits, doubly salient reluctance motor and controller.

9. 由于两个二极管反向并联,所以此电路能够对任何极性的信号进行保护。

With two diodes in parallel back to back, the circuit will provide protection regardless of the signal polarity.

10. 为明确起见,图中省略了过压二极管和保护电路。

For clarity, the figure omits overvoltage diodes and protection circuits.

11. 该文系统地讨论二极管工作在开关特性下所组成电路的频率变换的工作原理。

This paper tries to discuss the work principle of frequency transformation on the circuit where diodes work on on-off speciality.

12. 图2 - 24示出静电计或皮安计的过载保护电路,其中包括一个电阻器和两个二极管(1n3595)。

Figure 2-24 shows a protection circuit for an electrometer ammeter or picoammeter, consisting of a resistor and two diodes (1n3595).

13. 主要生产销售变容二极管和集成电路ic。

The main production and sales varactor diode and integrated circuit IC.

14. 二极管早已作为常规器件应用于多种电路中。

The diode is used routinely in many kinds of electronic circuits.

15. 二极管早已作为常规器件应用于多种电路中。

The diode is used routinely in many kinds of electronic circuits .

16. 研究人员通过使用热电阻和热电容对集成电路中异质连接双极型晶体管的热效应进行建模分析。

The researchers modelled the thermal effects of a heterojunction bipolar transistor in an integrated circuit using thermal resistors and thermal capacitors.

17. 有两台电视在这个电路板二极管为5V和12v的保护。

There are two TVS diodes on this PCB for 5v and 12v protection.

18. 以ewb电路分析方法中的极零点为分析工具,分析复杂电路或系统的传递函数,来达到取代枯燥繁琐的手工计算的目的。WwW.WEnTIYI.Com

By using the Pole-Zero as the analytical means in EWB circuit analysis, the transfer function was analysed in complicated circuit or system to replace the dull and onerous manual computation.

19. 分压接法:将变阻器的两个固定端分别与电源的两极相连,由滑动端和任一固定端连接到电路。

Partial Pressure Connection: the varistor of the two fixed end of the bipolar power supply, respectively connected by a sliding side and either a fixed terminal connected to the circuit.

20. 直流电压通过对工频电压整流和滤波得到。通常是使用二极管整流电路。

The dc voltage is obtained by rectifying and filtering the line voltage, most often by the diode-rectifier circuit.

21. 结合共射极单级放大电路的分析过程,说明了EW B软件的使用方法及对实际电子线路进行仿真的基本步骤。

Combining the analyzing process of oneway amplifying circuit, it illustrates the usage of EWB software and the basic steps of emulating the actual electron magnitudes of way.

22. 介绍一种从光电倍增管倍增极引出快信号的电路。

A circuit for taking out timing signal from one dynode of photomultiplier is described.

23. 只要按图28那样在阈值检测器中使用性能匹配的稳压二极管,那么这个信号发生器电路就可以做到与温度变化和电源电压变化无关。

The generator may be made independent of temperature and supply voltage if the detector is clamped with matched zener diodes as shown in Figure 28.

24. 介绍了基于模拟电路极零点灵敏度的分析方法,给出了极零点灵敏度的计算公式。

This paper introduces an analysis method of analog circuits based on the pole-zero sensitivity, and gives formulae of the sensitivity.

25. 应该正确连接两极,正确的连接电路。

The polarity of connections should be correct and each circuit must be correctly fused.

26. 应该正确连接两极,正确的连接电路。

The polarity of connections should be correct and each circuit must be correctly fused.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!