直流电阻用英语怎么说,直流电阻的英文翻译


词语导航

基本信息

词语:直流电阻

繁体:直流電阻

拼音:zhí liú diàn zǔ

英语翻译

【电】 direct-current resistance

分词翻译

直流电的英语翻译:

dc
【电】 direct current

阻的英语翻译:

block; hinder; obstruct
【医】 lock

翻译例句

1. 测量电机三项绕组直流电阻值。

Measurementformotor three-phase winding DC resistance.

2. 直流电阻较低,小型,可对应大电流用途。

DC low resistance, small, may correspond to current use.

3. 导体的结构及直流电阻。

The structure and D. C. resistance.

4. 对于电感耦合电路,必须考虑电感的直流电阻。

For inductively coupled circuits, you must also consider the winding resistance of the inductor.

5. 本文主要分析电缆质检中导体直流电阻测量的不确定度。

This paper analyses uncertainty degrees of measurement of direct-current resistance in the cable quality inspection.

6. 井下工作面侧帮超前探测技术是矿井直流电阻率探测新技术之一。

The side leading prospecting technique in underground working face is one of new underground galvanic resistivity prospecting techniques.

7. 本文用有限单元法对坑道内的直流电阻率测深进行数值模拟计算。

In this paper, we performed modelling of DC resistivity sounding in tunnel using the finite element method (FEM).

8. 发现直流电阻性本质安全电路在断开过程中低能电弧放电有三种情况。

It was found that there are three types of low-energy arc discharge during the breaking process of resistive intrinsically safe circuits.

9. 给出直流电阻率、激发极化测深法数据的二维有限元反演方法和原理。

The method and principle of 2-d structure finite element inversion for resistivity and IP data is presented.

10. 加上出色的直流电阻稳定,分流可用于直接测量电流通过他们的全部带宽。

Combined with excellent dc resistance stability, the shunts can be used to directly measure current through their full bandwidth.

11. 采用塑性变形理论和刚粘塑性材料模型研究了直流电阻对焊接头的塑性变形。

The joint deformation of DC upset butt welding was studied by using theory of plastic deformation and rigid-viscosity plastic material model.

12. 其电极满足ASTM标准d 257“绝缘材料的直流电阻或电导”的要求。

The electrodes follow the ASTM Standard D257 entitled "DC Resistance or Conductance of Insulating Materials."

13. 在电感设计中,直流电阻愈小愈好,其量测单位为欧姆,通常以其最大值为标注。

The unit of measure is ohms, and it is usually specified as a maximum rating.

14. 通过改变CVT中压变压器绕组的布置方式,可降低其直流电阻,从而改善负载误差特性。

Through a reasonable winding arrangement of CVT, the DC resistance can be reduced largely, hence the on load error characteristic can be improved.

15. 板材直流电阻对焊过程中,对接端面沿板宽方向的温度分布对焊接接头的质量有很大的影响。

In the process of DC upset butt welding, the joint quality was strongly effected by the temperature distribution in the direction of the plate width.

16. 本文从理论和实验上指出:在多纤维复合超导体中,基体铜的直流电阻呈现明显的尺寸效应。

The obvious size effects of electrical resistance of copper in multifilamentary superconducting composites have been pointed out in this paper.

17. 三相变压器直流电阻不平衡对变压器本身,以及与变压器相连的其它设备的正常运行有影响。

The unequal phases resistance of a transformer has effects on the operation of the transformer and the connected equipments.

18. 阐述了有源大功率直流标准电阻器检定直流电阻测试仪的方法,对该检定方法进行了误差分析。

The paper discussed the method of using active large-power DC standard resistor to verify DC resistance tester and analyzed its error.

19. 在进行变压器绕组直流电阻的测量时,变压器绕组可以等效为一个由电阻、电感组成的串联电路。

During the measuring of the DC resistance of a transformer"s winding, the winding is equivalent to a resistance-inductance series circuit.

20. 在采用本发明的线圈部件的线圈天线系统中,不增大直流电阻值而能够将Q值调整为所期望的值。

In a coil antenna system using the coil component, the value of Q can be adjusted to a desired level without an increase in a DC resistance value.wWw.weNtiYi.COm

21. 先从理论上作了分析,然后利用ANSYS软件进行了直流电阻率剖面和电阻率测深法的模拟计算。

Then simulating calculation of profiles and soundings of the DC electro-exploring method are numerically carried out, supported by ANSYS that is a software based on the finite element analysis method.

22. 针对牵引变压器绕组的直流电阻测量中的一些关键技术问题,提出了精确、快速、自动的测量方案。

An accurate, quick and automatic measurement scheme is presented to solve the key problems in measuring DC resistance of main transformer windings.

23. 根据机车主发电机绕组测试检修的技术要求,结合单片机技术,开发出机车主发电机直流电阻测试仪。

The DC resistance tester is designed, by combining the technical requirements of the locomotive power generators winding test and Microcontroller technology.

24. 研究表明,等效串联电阻随着有效介质层厚度的降低而降低,直流电阻随着有效介质层数的增加而降低。

It is found that ESR decreases with decrease of the active dielectric layer thickness, and DC resistance decreases with the increases of active dielectric layer number.

25. 采用位移门槛电压控制焊接过程,对Q 235 - A钢进行了变压式和等压式扁钢带直流电阻对焊试验。

A displacement threshold was used to control DC upset butt welding process, and constant pressure and varied pressure tests were carried out on Q235 a steel strips.

26. 针对变压器绕组直流电阻测试特点,提出了“消磁动态测试法”,将静态测量法与动态测量法有机统一起来。

This paper brings up a method called demagnetization dynamic measurement system for measuring the direct current resistance (DCR) of the transformer due to the characteristics of the windings.

27. 叙述了涂层金属耐腐蚀性的几种电化学测定方法,例如直流电阻法、交流阻抗法、电位时间法、充电曲线法。

Several electrochemical determination methods to test the corrosion resistance of coated metals were described, such as DC resistor, AC resistor, potential time and charging curve.

28. 报告了自1990年以来通过与量子化霍尔电阻比对考核的国家直流电阻(实物)基准的长期漂移率及偏差。

The drifts and deviations of National DC (artifact) Resistance Standards by comparison with Quantum Hall Resistance (QHR) since 1990 is reported.

29. 报告了自1990年以来通过与量子化霍尔电阻比对考核的国家直流电阻(实物)基准的长期漂移率及偏差。

The drifts and deviations of National DC (artifact) Resistance Standards by comparison with Quantum Hall Resistance (QHR) since 1990 is reported.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!