
词语导航
基本信息
词语:凝固温度
繁体:凝固溫度
拼音:níng gù wēn dù
英语翻译
【医】 solidification temperature
分词翻译
凝固的英语翻译:
be hard set; concreting; curdle; freeze; concretion; solidification【化】 freeze; freezing; setting; solidification
【医】 clotting; coagulate; coagulation; set
温度的英语翻译:
temperature【化】 temperature
【医】 T; temperature
翻译例句
1. 在冰盐混和物的凝固温度下,这微小的温差足够鳕鱼存活了。
That small difference is enough for the fish to live at the freezing temperature of the ice-salt mixture.
2. 结果表明:锰降低液相线温度和共晶温度,缩小凝固温度范围;
The results show that: manganese lowers liquidus and eutectic temperature, and narrows down the temperature range of solidification;
3. 采用有限差分方法,自行开发了连铸过程的凝固温度场模拟软件。
The finite differential method was applied to develop a simulation software for solidification temperature field in continuous casting.
4. 提高凝固温度,可以缩短凝固时间,并可显著增加豆腐凝胶的强度。
Coagulation time could be decreased by increasing coagulation temperature and tofu gel strength increased remarkably.
5. 提高凝固温度,可以缩短凝固时间,并可显著增加豆腐凝胶的强度。
With increasing coagulation temperature, coagulation time could be decreased and tofu-gel strength increased remarkably.
6. 本文以外节点直接差分法,建立了铸件凝固温度场的数值模拟模型。
A model of thermal field of casting is developed by using direct difference (outside node) method.
7. 研究2008奥运工程——鸟巢工程中大体积混凝土的凝固温度应力及其预防技术。
The thermal stress:in consolidation of concrete is analyzed for construction of the National Stadium, the main track and field stadium for Olympics 2008 in Beijing.
8. 通过实验研究了空调蓄冷材料的凝固温度、融解温度、凝固潜热和融解潜热等热学性能。
The thermal properties of cool storage material include freezing and melting point, freezing and melting latent heat during the phase change process were investigated.
9. 从热力学基本原理出发初步分析了强磁场磁化对纯物质吉布斯自由能和平衡凝固温度的影响。
Based on the principles of thermodynamics, the changes of Gibbs free energy and melting equilibrium temperature of pure materials caused by magnetization in a high magnetic field were analyzed.
10. 在此基础上采用有限单元方法数值求解模型,并运用热焓法处理凝固潜热,得到了一定工艺条件下的稳态凝固温度场。
Using enthalpy to deal with latent heat of solidification the numerical model is solved by finite element method, and a steady temperature field can be obtained under a certain condition.
11. 热常温凝固的温度较低。
Hot airset temperature is smaller.
12. “共晶”是指一种元素或者化合物的组合,它可以在比任一成分单独时的凝固点更低的温度下保持液态。
"Eutectic" refers to a mix of elements or compound that remains liquid at lower temperature than either of its components does alone.
13. 熬骨头汤时,中途切莫加生水,以免汤的温度突然下降导致蛋白质和脂肪迅速凝固,影响营养和味道。
Don"t add extra water during stewing bone soup. It will coagulate protein and fat when temperature being suddenly dropped, which damages its nutruition.
14. 晚上,把圆锥容器拿到屋子里,圆锥中的石蜡凝固时放出的温度和人体温度相似。
At night, the container is brought inside, where the heat is released at approximately the temperature of the human body as the wax re-solidifies.
15. 该研究通过试验模型测量局部加压过程中金属型、铸件和加压杆的温度变化曲线,分析了传热与凝固现象。
The heat transfer and solidification change are analyzed by measuring the temperature change curves of metal mold, casting and pressurized bar in experimental model during local pressurization.
16. 孔隙率随着凝固浴温度的上升而上升,而与预蒸发时间的长短没有关系;
Porosity increases along with the increasing of coagulation bath temperature, and doesn"t have relation to pre-evaporation.
17. 对牛血清白蛋白的截留率随着凝固浴温度的上升而下降,随着预蒸发时间的延长先略有下降然后上升。
The retention rates of Albumin bovine decreases when coagulation bath temperature increases, and first decreases, then increases when pre-evaporation time prolongs.
18. 冷冻式空气干燥器通过降低压缩空气的温度至接近水的凝固点,使多余的水蒸气凝结成液体水,从而与气流分离。
Frozen type air dryer by lowering the temperature of compressed air to close to the freezing point of water, that extra water vapor condense into liquid water, thus and flow separation.
19. 湿度和温度增加将使可得的工作时间和凝固时间缩短。
Increased humidity and elevated temperature will reduce available work time and set time.
20. 海卫一温度极低(约为- 235摄氏度,一个大气压下- 210度左右氮气凝固——译者注),以至其大部分的氮气都凝聚到了其表面形成霜,这使海卫一成为太阳系内唯一一颗以“氮冰”为主要地表成分的星球。
Triton is so cold that most of its nitrogen is condensed as frost, making it the only satellite in the solar system known to have a surface made mainly of nitrogen ice.
21. 虽然低温限制未进行测量,我们能适当地推定FOXY传感器在低于水的凝固点的温度下运行也良好。
Though the low temperature limit has not been tested, we can reasonably deduce that the FOXY Sensor operates successfully well below the freezing point of water.
22. 随着凝固浴温度的升高,所成的膜的透水速率上升。
The ultrafiltration rate of pure water with the coagulation bath temperature increased.
23. 凝固浴温度对填充聚合物平板膜有很大影响。
Coagulant bath temperature had a strong influence on PU, PES composite flat membrane.
24. 浇注温度对铸坯的凝固末端位置也有一定影响。
Casting temperature have a little effect on the solidification end location.
25. 凝固点:原油冷却到由液体变为固体时的温度称为凝固点。
Freezing point: the cooling of crude oil into a solid by the liquid temperature at the time known as the freezing point.
26. 讨论了正常熔化时间即断电前炉内状态对断电后钢液凝固和炉内温度变化的影响。
The effect of the initial state on the solidification process of liquid steel and the temperature changing inside furnace were discussed, respectively.
27. 有限差分方法是凝固过程温度场解析的常用数值计算方法。
Finite Difference Method (FDM) is usually used for calculating the temperature field of casting solidification processes.
28. 采用数值模拟的方法,研究了纯铝在静高压作用下凝固过程温度场的变化情况。
Numerical simulation of temperature field during al solidification process under static high pressure has been conducted.
29. 对适当范围的温度梯度,凝固速度较小时通道偏析易于形成。
Within a suitable range of temperature gradient, channel segregation is easy to develop when solidification rate is slow.
30. 并对凝固浴浓度和温度、挤出速率、芯液流量等纺丝工艺条件进行了探讨。wwW.wENTiYI.CoM
Several spinning procedure conditions were discussed, such as coagulation bath concentration, temperature, extruding rate and core layer liquid flow rate etc.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
