减薄的用英语怎么说,减薄的的英文翻译


词语导航

基本信息

词语:减薄的

繁体:減薄的

拼音:jiǎn báo de

英语翻译

【机】 bled

分词翻译

减的英语翻译:

decrease; minus; reduce; subtract
【计】 SB; subtract

薄的英语翻译:

flimsy; slight; tenuity; thin
【医】 lepto-; tenuity; thinness

翻译例句

1. 切割膜框架带、减薄的半导体衬底和C4研磨带的组件。

The assembly of the film frame tape, the thinned semiconductor substrate, and the C4 grind tape is diced.

2. 在综合分析基础上建立了胶东地区岩石圈减薄的动力学模式。

The dynamic model of lithosphere thinning in Jiaodong area is set up on the base of comprehensive analysis.

3. 伸展条件下的地壳拆离作用是岩石圈减薄的重要浅部构造响应。

Extensional crustal detachment is the most important tectonic response of lithosphere thinning.

4. 以及用树脂密封被减薄的所述半导体芯片的侧表面和所述第二主表面。

Side surfaces and the second main surface of the semiconductor chip made thin are sealed with resin.

5. 高度演化的黄山A型花岗岩:对扬子克拉通东南部中生代岩石圈减薄的约束?。

The Huangshan A-type granites with tetrad REE: constraints on Mesozoic lithospheric thinning of the southeastern Yangtze craton?

6. 靠近萨达斯冲断层北端的帕勒芬4铬矿区又表明从铁路段向东超基性岩席减薄的情况。

The Parefin 4 chromite claims near the northern end of the Csardas thrust again indicate the eastward extension of the thinning ultrabasic sheet from Railway Block.

7. 根据本发明制造的半导体工件提供改进的结构,以便在传统自动设备中操纵减薄的晶片。

Semiconductor workpieces made according to the present invention offer an improved structure for handling thinned wafers in conventional automated equipment.

8. 本文从大庆石化公司高密度聚乙烯装置的生产实践出发,对造成母液储罐罐壁减薄的原因进行了分析,并提出了相应的对策。

The reasons and countermeasures for mother liquor holding tank wall thinning down of high density polyethylene device were analyzed in this paper.

9. 退积反射是地层厚度向凹陷中心减薄且其顶部被“削截”的一种反射现象,与一般发生在凹陷边缘地层顶界被削截减薄的情形不同。

Retrogradation reflection is a reflected phenomenon that reflects the thinning strata and truncated its top in toward basin center, which is different from that takes place generally in basin margin.

10. 结果表明,随着充液压力的增大,截面不圆度逐渐减小,管材内侧壁厚增厚趋势减小,外侧减薄趋势增大。

The results show that, with an increasing internal pressure, non-circularity of the tube decreases, and the tendency of thickness thinning on inner and out side of the tube increases.

11. 热轧是控制无取向硅钢成品横截面厚差偏大、尤其是边部减薄显著的关键工序。

Hot rolling is the key factor for controlling transverse thickness difference, especially edge drop, of non - oriented silicon steel.

12. 并应用有限元方法分析了冷弯弯头的应力状况,得出其最大应力发生点随着外拱处壁厚减薄量的增大而向外拱处转移。

The results of FEA method for cold-bending elbow predicted that the point of maximum stress is transferred from intrados to extrados with the increase of the wall thinning.

13. 通过数值模拟与实验结果的比较,得出了获得较理想的成形薄壁筒形件时减薄率的选取范围。

Through the comparison of numerical simulation value and experiment results, the range of reduction ratio was obtained while the tube forming ideality.wWW.wENTIYi.cOM

14. 对内螺纹铜管尺寸优化、铝箔厚度减薄前后的空调热交换器进行了单体性能实验和整机性能实验对比。

The performance experiments on separate heat exchanges and integrated air conditioners before and after optimizing the inner grooved copper tube and reducing the thickness of aluminum foil are made.

15. 通过对芯片进行背面减薄和倒装连接,可以实现有源芯片的埋嵌。

The embedded active chip also can be realized by backside thinning and flip chip bonding.

16. 试验结果表明,气囊充压压力使复合材料承力筒的壁厚减薄,纤维体积含量增加,弯曲性能提高;

The experimental result shows that higher bladder pressure decreases thickness of composite bearing cylinder, increases fiber volume fraction and improves the bending properties.

17. 现今盆地的演化可能处于第二次伸展减薄—热事件的同裂谷相的晚期。

Currently the evolvement of the basin is probably in late syn-rift phase of the second event.

18. 峰值间的距离随厚度的减薄而增大。

The distance between peaks increases as the thickness is reduced.

19. 对焦炭塔上部壳体和球形封头的减薄原因进行了简要分析,提出了临时修复措施。

The reason of thinning out of the upper shell and spherical head for coke tower was analyzed briefly. The temporary repair measure was proposed.

20. 计算结果表明:在转臂上施加一定的反向弯矩,能有效减小弯管的壁厚减薄率。

It shows that pipe bending by using induction heating applied a counter torque can efficiently reduce the thinning ratio of pipe wall thickness.

21. 介绍了近年来不同学者从各个方面研究中国东部岩石圈减薄所取得的进展。

Some advances of many scholars studying on lithosphere thinning in eastern China in recent years are reported.

22. 认为,板料零件数控渐进成形是使板料的厚度减薄,表面积增大,靠逐次的变形累积产生整体的变形。

Sheet thickness is thinned, surface area is increased in the nc incremental sheet metal parts forming process, and sheet forming point by point is to lead to the whole sheet deformation.

23. 多金属成矿作用与岩石圈伸展减薄及地壳拉张的关系。

The relationship between polymetallic mineralization and lithospheric thinning and crustal extension.

24. 一台反应釜两端所采用的椭圆封头因加工工艺不当,封头壁厚在小圆弧的过渡段出现严重减薄。

The thickness of uie elliptical heads at the both ends of the reaction tank was seriously reduced in the transition area of the small arc by improper processing.

25. 局部减薄弯头与直管的极限载荷不同。

The limit load of local thinning elbow is different from the straight pipe.

26. 同向切应力具有减薄液膜厚度和增大传热系数的作用;

The cocurrent shear plays the roles on thinning film thickness and enhancing heat transfer, and the countercurrent shear has inverse effect.

27. 实验结果表明,随着小粒径锌粉的增多,涂层减薄,铬含量提高,耐蚀性增强。

The experimental results showed that the smaller the powder size and higher the chromium content were, the higher corrosion resistance the coating could be.

28. 实验结果表明,随着小粒径锌粉的增多,涂层减薄,铬含量提高,耐蚀性增强。

The experimental results showed that the smaller the powder size and higher the chromium content were, the higher corrosion resistance the coating could be.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!