极限深度用英语怎么说,极限深度的英文翻译


词语导航

基本信息

词语:极限深度

繁体:極限深度

拼音:jí xiàn shēn dù

英语翻译

【计】 limit depth

分词翻译

极限的英语翻译:

limit; terminal; the maximum; utmost
【化】 limit(ing) point

深度的英语翻译:

deepness; depth; profundity
【计】 depth
【医】 depth

翻译例句

1. 在此基础上,比较了真空提水的极限深度和真空预压有效加固深度的不同,分析了真空预压有效加固深度大于真空提水极限深度的原因。

On this basis, the difference between the limited lift by vacuum pumping and the effective depth of vacuum preloading is analyzed and the reason of the latter may greater than the former is analyzed.

2. 根据桩的极限承载力来计算桩的入土深度。

The ultimate bearing load of the pile is used to calculate its buried depth.

3. 研究表明,拖曳锚嵌入运动中拖缆存在反悬链效应、锚板存在极限嵌入深度。

Research shows that, in the embedded movement of drag anchors, the embedded anchor chain will display a profile with reverse curvature and the anchor will reach an ultimate embedded depth.

4. 由于高强度钢材的屈服极限不断地增大,下潜深度的不断增加,弯曲微分方程解的形式将不仅限于复数解。

Increasing the yield limit of high strength steel, and increasing the depth of submergence, the form of the differential equation"s result will not only be limited with the complex number.

5. 只有与幽默感相通的忧郁体验,才能凭藉其生命深度达到审美意识的极限。

With its depth of life, only a melancholy experience interlinked with a sense of humour can reach the ultimate of aesthetic consciousness.

6. 对优控主轴转速系统的极限切削深度进行了试验考证。

The limit cutting depth of the machining system with optimal controlling spindle speed is studied by experiments.

7. 提出了确定膨胀土大气影响深度的极限平衡法;

The limiting equilibrium method that determines the influence depth of the expansive soils by the air is presented.

8. 丁坝冲深极限值是确定建筑物基础埋设深度的一个主要因素,丁坝设计和施工中的关键问题在于确定坝头最大冲深。

The scour limit depth around spur dikes is very important for calculating the base depth of objects and it is a key factor in designing and working.WWW.wenTIYI.COM

9. 极限嵌入深度的成功求解为确定拖曳所需最短缆长提供了基础。

Successfully getting the solution of the ultimate embedded depth provides a foundation for determining the shortest length of the drag line.

10. 试验结果表明,在极度潮湿环境下混凝土碳化进展缓慢,且碳化区域以未完全碳化区为主导,混凝土碳化的深度最终趋于一个极限值。

The test results show that the carbonation rate is slow in extremely humid environment, and the incomplete carbonation zone is dominant in carbonation zone, the depth of carbonation tends to a limit.

11. 对材料硬度、硬化层深度、晶粒大小、极限强度等主要采用电磁检测和超声检测。

Electromagnetic testing and ultrasonic testing are the main points for materials hardness, hardness depth, crystallite size, limiting intensity etc.

12. 大量数值计算表明:主动极限位移随土层深度增加而增加,但到一定深度后其增量为零。

Large scale numeric calculation shows that the active limiting displacement is increasing with the depth of retained soil, and that the increment is zero when the soil depth reach some degree.

13. 结果表明:和楔形凹陷损伤立管一样,随着凹陷深度的加大,立管的极限强度明显减小;

The results showed that: similar to the wedge dented riser, ultimate strength reduced significantly as the maximum depth of the spherical dent increased;

14. 最后通过GA - BP神经网络与拉丁超立方抽样法相结合构建了可控拉深筋主要影响因子h1和H2与极限拉深深度之间的响应面。

Eventually, the response surfaces composed of the CD main influence factor H1, H2 and limit drawing depth are established by the combination of GA-BP neural network and Latin Hypercube.

15. 恢复是一种缓慢的,深度的放电过程,它放电使电芯达到一个电压极限,一个电芯一定要由一伏的电压至少放电至0.6伏以下,才能溶散更多的抗性晶体。

Recondition is a slow, deep discharge that drains the cell to a voltage threshold below one volt must be discharged to at least 0.6 volts per cell to dissolve the more resistive crystalline build-up.

16. 分析了凹陷深度、初弯曲、长细比和截面径厚比等参数对杆件极限承载力的影响,讨论了上述参数对荷载-轴向缩短关系的单独影响和综合影响。

The following parameters, dent-depth, initial crook, slenderness ratio and diameter-thickness ratio, are considered and their influence on ultimate bearing capacity is analyzed.

17. 因为坡在创作原则上遵循一种极限性,所以他在探索小说题材领域的深度和广度上较之于同时期的作家呈现出了一种超前性。

Because of the slope in the creation principle, follow a blame, so his novels in exploring the width and depth of the field in the same period than a writer presents new.

18. 坑底以下有效桩长相同时,开挖深度越大,开挖后桩周土体超固结比越大,抗拔桩极限承载力也越大。

When the length of the pile under the bottom of the pit is the same, the deeper the excavation is, the larger the ultimate uplift capacity of pile is.

19. 从理论上分析导出了极限泵径和极限沉没度,并引用小泵深抽技术采用试算法确定了合理的沉没度和泵挂深度。

Limit pump diameter and percentage of submergence are derived theoretically. Trial and error method is used to calculate the rational percentage of submergence and pump setting depth.

20. 探究了腐蚀深度、腐蚀宽度和腐蚀形状等参数对极限弯矩荷载的影响。

Parameter study conducted indicates that the shape of the corrosion defect has significant influence on the bending capacity of the corroded pipes.

21. 探究了腐蚀深度、腐蚀宽度和腐蚀形状等参数对极限弯矩荷载的影响。

Parameter study conducted indicates that the shape of the corrosion defect has significant influence on the bending capacity of the corroded pipes.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!