
词语导航
基本信息
词语:接触面积
繁体:接觸面積
拼音:jiē chù miàn jī
英语翻译
【计】 contact areaWww.WEnTiyi.coM
相关词条
1.apparentarea分词翻译
接触的英语翻译:
contact; contiguity; get in touch with; meet; osculate; osculation; tangencytouch
【医】 c.; contact; contiguity; hapt-; hapto-; per contiguum; taction; tactus
touch
面积的英语翻译:
acreage; area; proportion【计】 A
翻译例句
1. 接触面积小时用硬的结合度。
Hard grade for the smaller contact area.
2. 接触面积大时用粗的粒度。
Coarse grain size for the larger contact area.
3. 对于干式开关,接触电阻与接触面积成反比关系。
For dry switches, the contact resistance is inversely related to the contact area.
4. 目的探讨青少年咀嚼效能与牙合接触面积之间的关系。
Objective to study the relationship between the masticatory efficiency and the occlusal contact area of adolescents.
5. 此外还分析了磨砂玻璃板接触面积与摩擦系数的关系。
Besides, the relationship between the contacting area and the glide friction was analyzed and discussed.
6. 一个固体作用在地面的压强等于它的重量除以接触面积。
A solid object exerts pressure on a floor equal to its weight divided by the area of contact.
7. 目的分析骶髂关节在不同脱位情况下耳状关节面接触面积的变化。
Objective To determine the average articular contact area between the sacrum and ilium at the sacroiliac joint using computer analysis.
8. 型曲线鞋底拉拽设计,增加鞋子与地面接触面积,最大程度防滑。
S-Curve Outsole: S-shaped lug design allows for maximum ground contact for slip resistance.
9. 为了增加接触面积并承受较大载荷,滚珠在内外环的曲线槽内滚动。
To increase the contact area and permit larger loads to be carried, the balls run in curvilinear grooves in the rings.
10. 当其余各影响参数保持一定值时,磨损率随接触面积的增大而增大。
While giving other parameters, wear rate increases along with the increase of contact area.
11. 与质量无关,还与面积无关,与接触面积无关这一点,也很不可思议。
It"s also independent of the surface area that is in contact with this incline which is equally nonintuitive.
12. 试验结果表明渗透速度受竹片厚度影响最大,并与接触面积成正比。
Experiment results indicates that the penetration rate is greatly influenced by bamboo chip thickness and directly proportional to the contacting area.
13. 若摩擦系数真的,与接触面积没有关系,那么两者下滑时的角度,应该基本相当。
If indeed the friction coefficient is independent of surface area, then when I tilt them they should start to slide roughly at the same Angle.
14. 无论采用哪种方法,最后必须使制动鼓与制动蹄的接触面积达到70%以上。
Whichever method is used, and finally the need to brake drum brake shoe and the contact area for more than 70%.
15. 对研究花键冷滚压成形过程中的接触面积和有限元模型的简化具有重要的意义。
It is significant to study the contact area in rolling process and simplify model of finite element.
16. 那就是它可以提高穿入头发中的纤维尖头的灵敏度,从而增加尖头与头皮的直接接触面积。
It"s designed to provide increased sensitivity with fiber tips that thread through hair to increase direct scalp contact.
17. 有时把蜗杆齿制成包裹在蜗轮,这就提供了更大的接触面积,但安装精度要求更高了。
Sometimes the worm is modified to envelop the gear. This gives a greater area of contact, but requires extremely precise mounting.
18. 降低粘性土壤对刀齿表面接触面积可以减小土壤对刀齿的粘附和降低刀齿切削土壤的阻力。
Reduction of contact area between cohesive soil and the surface of dredging tools is able to decrease soil adhesion and cutting resistance.
19. 由于超声波处理可增加农杆菌与外植体之间的接触面积,提高农杆菌对外植体的转化频率。
Sonication assisted Agrobacterium mediated transformation(SAAT)tremendously improves the efficiency of Agrobacterium infection by introducing large numbers of microwounds into the target plant tissue.
20. 考察了催化剂与反应物的接触面积,催化剂用量和苯的初始浓度对苯光催化氧化反应的影响。
The influences of contact area of catalyst with reactant catalyst area, catalyst dosage and initial concentration of benzene on the benzene photocatalytic oxidation reaction were investigated.
21. 目的了解不同类型的髋关节假体柄与骨的接触面积,并探讨接触面积的大小与假体松动的关系。
Objective to elucidate the contact areas of stem-bone of the different type prostheses and probe into the relation between the contact areas and prosthesis loosening.
22. 通过对摆辗加工中摆头与圆柱实心工件接触面积的分析,给出了计算其接触面积率的近似公式。
By analyzing the contact area between the Upper Die and cylindrical solid workpiece during Orbital Forming process, an approximate formula for calculating the contact area rate is proposed.
23. 待连接表面间的紧密接触是实现阳极连接的必要条件,因此分析紧密接触面积演化特点非常重要。
The intimate contact of two surfaces to be bonded is a prerequisite for the anodic bonding, therefore, it is very important to analyze evolution characters of the intimate contact area.
24. 光全反射法是测量真实接触面积的常用手段,然而用其测得的接触图像小,接触斑点的边界模糊。
Total reflection method has been commonly used to detect real contact area, however the boundary of the contact spots in the contact image obtained was vague.
25. 计算结果表明,过大的艉轴转角会导致艉轴承接触面积减小,接触压力分布不均,峰值压力增大。
The numerical results indicated that the large misalignment Angle will cause the contacting area of the stern bearing decreased, pressure distribution uneven, and the peak pressure increased.
26. 计算结果表明,过大的艉轴转角会导致艉轴承接触面积减小,接触压力分布不均,峰值压力增大。
The numerical results indicated that the large misalignment Angle will cause the contacting area of the stern bearing decreased, pressure distribution uneven, and the peak pressure increased.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
