扩散层用英语怎么说,扩散层的英文翻译


词语导航

基本信息

词语:扩散层

繁体:擴散層

拼音:kuò sàn céng

英语翻译

【化】 diffusion layer

相关词条

1.diffusedlayer  

分词翻译

扩的英语翻译:

enlarge; expand; extend; spread

散的英语翻译:

come loose; dispel; disperse; disseminate; fall apart; give out; scatter

层的英语翻译:

layer; region; stage; story; stratum; tier
【计】 layer
【医】 coat; lamella; lamellae; lamina; laminae; layer; strata; stratum

翻译例句

1. 基体与熔凝层之间存在梯度扩散层。

A gradient diffusion layer exists between the layer and the matrix.

2. 纯铁渗氮层则由化合物层和扩散层组成。

The nitrided layer of pure iron consists of compound layer and diffusion layer.

3. 同时,对扩散层的组织和性能进行了研究。

The microstructure and the properties of nickel diffusion layer were also investigated.

4. 结果表明,异质界面之间存在明显的扩散层。

The experimental results indicate that evident diffusion layers exist at the interfaces of different phases.

5. 在受主缺陷扩散层中费未能级的变化是线性的。

The level changes linearly in the acceptor defect layers.

6. 第三层为扩散层。

The third layer is diffused layer.

7. 影响扩散层的主要因素是基体材料的成分和沉积温度;

It is the compostiton of bulk material and deposition temperature that mainly affects the diffusion layer.

8. 研究了几个常用的环境温度下扩散层对点火性能的影响。

The effect of ignition property on diffusion layer in normal ambient temperature was examined.

9. 本文讨论了微带电极的计时电流、扩散层与时间的关系;

The relationships of chronoamperometric current and diffusion layer with electrolysis time are discussed at microband electrode.

10. 控制好扩散层是实现高速钢与球墨铸铁良好结合的关键。

Better control of different layer may be essential to good combination of high-speed steel with nodular graphite cast iron.

11. 研究表明,扩散层具有随机性、无序性和自相似性等分形特性。

Research indicates that GDL have characteristics of randomness, irregularity and self - similarity.WWw.WENTIyi.CoM

12. 研究的区域包括阴极和阳极的流道、扩散层、催化层和质子交换膜。

The studied domain consists of fluid channels, diffusion layers and catalyst layers of anode and cathode, and membrane.

13. 通过成分分析(EPMA)和硬度测试, 分析了硅扩散层的特征。

The characteristics of so-called silicon diffusion layer were analyzed through EPMA and hardness test.

14. 通过计算接头处扩散层的激活能可知纳米镍的扩散性能比镍箔的好。

The calculating results of activation energy show that the diffusibility of nanometer Ni is better than Ni foil in diffusion layer at joints.

15. 渗氮件的性能与渗氮层的化合物相组成和扩散层的微观结构密切相关。

Properties of nitrided parts have close relation to phase composition of their compound layer and microstructure of their diffusion layer.

16. 结果表明,扩散层的厚度随烧结温度的提高和保温时间的延长而增厚。

The results show that the thickness of the diffusion layer increases obviously with the increase of temperature and holding time.

17. 而在高温低周疲劳条件下裂纹是在粘结层与高温合金基体的扩散层处。

However, cracks initialized in the diffusion layer between substrate and bond coat when TBCs were tested with low cycle fatigue at high temperature.

18. 通过在与浮栅电容耦合的第二杂质扩散层上施加高电压对浮栅注入电子。

Electrons are injected into the floating gate by applying a high voltage to the second impurity diffusion layer in capacitive coupling with the floating gate.

19. 本文从稳态扩散方程推导出产生浓差极化的扩散层厚度与实验数据相符。

The thickness of the diffusion layer reckoned by computation of steady-state diffusion equation has been found in agreement with the results obtained through laboratory experiment.

20. 研究了热浸渗铝钢扩散层空洞对循环氧化和剥落性能的影响规律及其机理。

The effects of the voids in the diffusion layer on cyclic oxidation and spalling resistance of aluminized steel was investigated.

21. 实验结果表明,铌能增加扩散层深度、硬度及耐磨性,提高渗层的强韧性。

The results of experiments showed that the Nb can raise the depth of diffusion zone, hardness, wear resistance, strength and toughness of the nitriding layer of the matrix steel.

22. 而增大炭材料的孔径或电解液浓度,可明显减弱甚至消除扩散层对电容的影响。

But, the effect of diffusible double-layer on double layer capacitance is re-duced and even eliminated through increasing pore sizes of carbon electrodes or electrolyte concentration.

23. 复合材料界面结构由芯材扩散层、激冷凝固层、方向性生长层和胞状晶粒层组成。

The interface structure of composite consists of core material diffusion layer, chilling solidified layer, directional growth layer, and cellular granular layer.

24. 氮化扩散层和氧化层:可以提高模具耐溶损性、耐过烧性、耐粘着性和耐热裂性。

Nitriding and oxidation: diffusion layer and oxidation layer improve soldering resistance, adhesion resistance and crack resistance.

25. 对恒定容量模式、扩散层模式和三层模式在天然水体沉积物中的应用进行了比较。

The applicability of the constant capacitance model, the diffuse layer model and the triple lay er model to the natural sediments were compared.

26. 通过诸工艺参数的优选,扩散层性能的多方面考核和生产实践,确定了LT新工艺。

A new LT process was established after the preferred Selection of technology parameters, various examinations of properties of the diffusion layer and production practices.

27. 应用元胞自动机模型对合金钢表面氮化及扩散层中氮化物沉淀过程进行了计算机模拟。

Simulations of surface nitridation and nitride precipitation in alloy steels have beeb carried out with cellular automaton modeling.

28. 研究的区域包括阳极和阴极的流道、扩散层和催化层以及质子交换膜在内的整个单电池。

The studied domain consists of flow channels, diffusion layers and catalyst layers of both the anode and cathode, and the membrane.

29. 热浸镀铝-镧钢的扩散层中存在非晶态相,且稀土镧的添加可使扩散层中的非晶含量增加。

There is amorphous phase in diffusion layer of the hot-dip La-aluminizing and the content of the amorphous phase increases due to the addition of rare earths la.

30. 热浸镀铝-镧钢的扩散层中存在非晶态相,且稀土镧的添加可使扩散层中的非晶含量增加。

There is amorphous phase in diffusion layer of the hot-dip La-aluminizing and the content of the amorphous phase increases due to the addition of rare earths la.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!