
词语导航
基本信息
词语:弹管
繁体:彈管
拼音:dàn guǎn
英语翻译
【机】 bomb tube
分词翻译
弹的英语翻译:
ball; bomb; flip; pellet; play; shoot; spring
【医】 bomb; bullet
管的英语翻译:
canal; duct; fistula; guarantee; meatus; pipe; tube; wind instrument
【化】 pipe; tube
【医】 canal; canales; canalis; channel; duct; ductus; salpingo-; salpinx
syringo-; tuba; tube; tubi; tubing; tubo-; tubus; vas; vaso-; vessel
翻译例句
1. 目的在于全面翔实地阐述垂直管弹状流的研究结果,以期有效地指导实验研究及生产实际工作。
The purpose of this paper is to illustrate the result of the research on the slug flow in vertical tubes and to effectively guide experimental investigation and production practices in future.
2. 在分析挤胀波纹管受力的基础上,采用大变形弹塑有限元分析方法,结合实际数据进行计算。
On the basis of analyzing the force exerted on corrugated pipe, by means of the deforming finite element method, this paper conducts calculation by use of actual data.
3. 最后以弹底压力为弹引系统振动模型的输入,求解出系统引信内传爆管装置处的加速度响应。
The acceleration response in the place of booster device of projectile-fuze system under the projectile base pressure was calculated using the modified system Vibration model.
4. 在对X60管钢弹塑性断裂分析中,采用J - A2双参数方法来预测带表面裂纹管道的破坏压力。
In the elastoplastic fracture analysis for pipelines steel X60, J-A2 two parameter approach was adopted to predict the failure pressures of pipelines with surface cracks.
5. 最后以弹底压力为弹引系统振动模型的输入,求解引信内传爆管装置处的加速度响应。
The acceleration response at the location of the booster device of the system under the projectile base pressure is finally calculated using the modified system vibration model.
6. 采用水平—下降管组合法测量了垂直下降管内油气两相流动在泡状和弹状流下截面含气率的值。
The void fraction in downward gas oil two phase flow in vertical tube is measured with the combined method of horizontal downward vertical tube for the two flow regimes(bubbly and slug flow).
7. 对上升管中气弹运动对传热传质的影响提出了假设。
The influence of Taylor bubble movement on heat mass transfer was assumed based on the above analyses.
8. 其主要影响因素有管的材料性质、径厚比、长径比以及子弹和管的弹径比。
The main influent factors include material properties, the proportion of diameter to thickness and diameter to length, and the proportion of diameter of missile to that of tube.
9. 本文采用参数泵分步结晶新工艺和开发的直立弹状气泡管结晶器提纯制取精萘,则克服了通常方法的缺点。
In this paper a technology of parametric pumping fractional crystallization and a crystallizer with a slug flow vertical bubble tube are presented.
10. 目前末敏弹母弹测高机构主要装配了空压管、毫米波雷达、定时器、激光测距系统等装置。
At present, the ranging system of the carrier shell equipped the air pressure tube, the millimeter radar, the timer and laser ranging system.
11. 根据垂直管固液两相流的特征 ,考虑固液两相流密度、浓度、弹模、阻力等特点 ,对粗颗粒水力提升不稳定流进行数值模拟。
On the basis of previous researches, the concentration characteristics of large size particles in vertical pipes by hydraulic lifting were studied through experiments and theoretical analyses.
12. 采用三维热弹塑性有限元法对管板接头的焊接变形进行数值模拟。
Welding deformations of a pipe-plate joint with holes after multi-pass welding are simulated using the thermal-elastic-plastic finite element method.WwW.weNtIyI.cOM
13. 阐述冷弯方管采用有限元弹塑性非线性分析理论及应用ANSYS软件的非线性分析方法;
The elastic-plastic non-linear behavior of the cold-formed square hollow section columns analyzed by ANSYS is presented;
14. 阐述冷弯方管采用有限元弹塑性非线性分析理论及应用ANSYS软件的非线性分析方法;
The elastic-plastic non-linear behavior of the cold-formed square hollow section columns analyzed by ANSYS is presented;
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
