
词语导航
基本信息
词语:冲击值
繁体:沖擊值
拼音:chōng jī zhí
英语翻译
【机】 impact value; izod impact value izod
分词翻译
冲击的英语翻译:WWW.WEnTiyI.Com
impact; strike; buffet; lash; pound; shock
【计】 impact area
【医】 ictus; impact; stoss
值的英语翻译:
cost; value; happen to; on duty
【医】 number; titer; titre; value
翻译例句
1. 冲击值是评价材料韧性的指标之一。
Impact value is one of the criteria to evaluate material toughness.
2. 产品性能:不破碎,耐研磨,硬度均匀,冲击值高,磨机综合效率高。
Performance: hardness uniform, not broken, ground resistance, the impact of high value, high efficiency integrated mill.
3. 而粗大的晶粒及连续的晶界容易产生应力集中,因此合金经固溶时效后具有较低的塑性和冲击值。
However, large grain size and continuous grain boundaries combine to produce stress concentrations, thus lowering the plasticity and impact value of alloy after solution and aging treatment.
4. 针对精炼与非精炼船钢低温冲击值的差异,分析了两种钢的化学成分、夹杂物和显微组织等对冲击值的影响。
For the difference of ship steel low temperature impact value, the effects of chemical composition, inclusion and microstructure of the refined and unrefined steel are analyzed.
5. 结果:生物力学试验数据表明,接骨灵颗粒对兔桡骨骨折拉伸极限荷载、弯曲最大荷载、冲击值均显著高于对照组。
Result:the biomechanical test indicates that Jieguling granules" maximum loading of elongationmaximum loading of bend and data of impact supass control group.
6. 公司的业绩受到了英镑高值的冲击。
The company"s performance was impacted by the high value of the pound.
7. 对夏比摆锤式冲击试验,一组三个试样的试验结果不符合要求,仅一个较低值低于70%,应取三个试样进行附加试验。
For Charpy impacts tests, where the results from a set of three specimens do not comply with the requirements, with only one lower value below 70 %, three additional specimens shall be taken.
8. 讨论了脉冲激励幅值以及系统阻尼等对冲击谱的影响规律。
The regular pattern of influence on impact spectra by amplitude of pulse excitation and system damping was discussed.
9. 作为冲击豁免的考虑是根据文件和材料规范的要求,而不是根据材料分析的实际值。
As documented and permissible in the specification and not on the values of the actual deliveries.
10. 因此在通常材料中所存在的各向异性完全消失,特别是缺口冲击韧性横向性能值提高了2~3倍。
The anisotropic characteristic which usually exists in materials disappeared completely especially the notch - impact toughness at the transverse direction was increased by 2-3 times.
11. 结果发现,失效件的硅含量偏高、硬度值很不均匀,冲击韧度和伸长率远低于材质要求,因而导致脆断。
The results shows that the failure parts has high silicon content and uneven hardness , the impact toughness and elongation is far below the specification of the material.
12. 同时用涂料标准方法测定了这些样品的漆膜的表干时间、光泽值、冲击强度、附着力、柔韧性等。
Film properties including surface drying time, luster value, shock strength, adhesion and flexibility were tested according to standard methods for coating.
13. 本文还给出了最大冲击压力值的分布规律。
In addition, a distribution regularity of the maximal impact pressure is also given.
14. 扑灭冲击到底产生多少威胁值?
How much threat does Devastate generate?
15. 本文以炮口冲击波场测试系统的测试试验为背景,主要进行了炮口冲击波场压力曲面的插值研究。
Against the background of pressure measurement of the muzzle shock wave, the main work of the article is to study the interpolation methods to describe the pressure surface of the muzzle shock wave.
16. 其在承受冲击载荷时,在冲击载荷脉宽不变的情况下,随着冲击载荷幅值的增加,隔振器吸收的能量增大。
The energy absorbed by the vibration isolator increases with the increase of the shock load value when its impulse width is invariable.
17. 在TCS不锈钢前期焊接试验中发现其焊接接头热影响区的冲击吸收功值在熔合线附近较低,原因是接头热影响区晶粒粗大所致。
In welding test of TCS stainless steel, it was found that impact absorbing energy of heat-affected zone (HAZ) near bond line in welded joint was low.
18. 冲击响应幅值还与冲击方向有关,当冲击位移向下时,控制棒的响应位移相对比较大。
The response amplitude also relates to the impact direction. When the reactor moved down rapidly, the response displacement of the control rod is larger.
19. 而本体法复合材料的拉伸强度、拉伸模量及冲击强度值最大分别提高了32.2%、60.3%和68.6%,而透光性能基本未受影响。
In the bulk system, tensile strength, tensile modulus and impact strength are improved by 32.2%, 60.3% and 68.6%, respectively, without the loss of light transmittance.
20. 发现随着冲击位移的增加,冲击速度几乎呈线性下降,冲击加速度很快减少到一个极小值,而能量吸收阶段中前阶段的吸收速度比后阶段快。
The results indicate that, with the increase of the impact displacement, the impact velocity decreases almost linearly, and the impact acceleration quickly declines to a minimum.
21. 根据试验测定的焊缝各区冲击韧性、断裂韧性、疲劳裂纹扩展速率和疲劳裂纹扩展门槛值,对焊缝力学性能作出综合评价。
The mechanical properties of the butt welded joints have been evaluated according to the impulsive and fracture toughness as well as the rate and threshold values of fatigue crack propagation.
22. 一位35额定值。肖尔研发,含有非脱色剂,注射成型和挤出树脂增塑剂自由;具有低温耐冲击性以及优良的力学性能。
A 35 nom. Shore d, containing non-discoloring stabilizer, plasticiser free resin for injection molding and extrusion; with low temperature impact resistance as well as excellent mechanical properties.
23. 基于FPGA的数据回收系统可以对高冲击过程中的加速度值进行实时采集回收。
The system based on FPGA fits in with the real time measure of the acceleration in the process of high impulsion.
24. 为了反映冲击载荷下岩石材料的应变率敏感性,对损伤的门槛值进行粘性调整。
The damage threshold is regularized in order to reflect strain-rate sensitivity of rock materials under impact load.
25. 当复合冲击改性剂用量为12份时,材料的冲击强度达到最大值,其它力学和热性能降低不大。
The results showed that the impact strength(notched) of the composite was maximum and the mechanical and thermal properties were less decreased, when the dosage of modifier was 12 PHR.
26. 结果表明:硬度预测值与实验值相对误差的绝对值的平均值为5.90%,附着力预测准确率为100%,耐冲击性预测准确率为100%。
The results show that the average absolute value of relative errors between predictive and measured values of hardness is 5.90%, the prediction accuracies of adhesion and impact resistance are 100%.
27. 讨论了设计值与许用值的关系,并指出复合材料结构压缩设计值主要取决于冲击损伤容限许用值。
The relationship between design values and allowables was discussed. The determination of compressive design values for composite structures was based mainly on impact damage tolerance allowables.
28. 讨论了设计值与许用值的关系,并指出复合材料结构压缩设计值主要取决于冲击损伤容限许用值。
The relationship between design values and allowables was discussed. The determination of compressive design values for composite structures was based mainly on impact damage tolerance allowables.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
