
词语导航
基本信息
词语:间隙长度
繁体:間隙長度
拼音:jiān xì cháng dù
英语翻译
【电】 gap length
分词翻译
间隙的英语翻译:
clear; clearance; gap; interval; space
【化】 back lash; clearance; gap; play; slack
【医】 clearance; diastem; diastema; interspace; space; spatia; spatium
长度的英语翻译:
in length; length
【化】 length
【医】 L.; length
翻译例句
1. 结果:腰骶部脊神经根在硬膜外间隙长度短,且显露困难。
Results: The length of lumbosacral nerve roots in epidural space is short and extremely difficult to be exposed.
2. 研究了间隙长度和间隙位置对不同单搭接接头强度的影响。
The influence of length and position of recessing on the strength of adhesively bonded joints with different single-lap length was presented.
3. 合理的间隙长度可以有效地减少胶粘剂的用量,减少率最大可达60%;
The rational gap length reduced the volume of adhesive effectively and the highest reduction ratio was 60%.
4. 结果表明,随着栅长减小、栅间隙长度增加和沟道深度减小,传输栅电荷容量约从6。
It is shown that, as the gate length decreases, the gap width between the gates increases and the depth of the channel becomes shorter, the transmitted charge handling capacity will drop from 6.
5. 间隙中的平均放电量随着空气间隙长度的增加而减小,随着施加电压的升高先增加后近似保持不变。
While, the mean discharge magnitude increase first and after that it has an approximate constant with the increase of applied voltage.
6. 过大的间隙长度以及不当的间隙位置会导致胶层靠近间隙端应力集中明显加剧,成为新的高应力区,可能导致接头破坏模式的改变。
Oversize recessing or improper position results in sharp stress concentration near the recessing to be a new higher stress zone, which may lead to the alternation of failure mode of joints.
7. 结果表明,随着间隙长度的增加,接头的承载能力趋于减小,但接头的实际剪切强度却持续上升;当间隙长度继续增加时,接头的实际强度趋于下降。
Results from the experiment show that the load bearing ability of the single-lap joint decreases as the length of the gap increase but the actual shear strength is increased in same time.
8. 趁着这个间隙,海豚会丢掉嘴中的海绵,浮出海面换气,接着马上潜入水里捕捉这些长度只有12cm的底栖鱼。
That interlude gives the dolphin just enough time to drop its sponge, surface to get a breath, and dive again to snag the fish, most of which are about 12 centimeters in length.
9. 轴承一般设一个小轴向间隙,以弥补轴和轴承座的长度变化。
The bearings are generally installed with a small axial clearance in order to compensate for length variations of shaft and housing.
10. 火花间隙的长度影响火花的能量,而绝缘体的形状则影响工作温度。
Spark-gap length affects the energy of the spark, and the shape of the insulator affects the temperature of operation.
11. 间隙1的长度决不可以变化。
The length of gap 1 may never vary .
12. 研究了覆冰桥接时冰棱的长度对覆冰合成绝缘子电场和电位分布的影响,以及空气间隙在覆冰合成绝缘子外沿所处的位置不同对电场和电位分布的影响。
The author researches the influence of the length of icicle in ice bridge connection and the position of air gap in the composite insulators to the distribution of electrical field and potential.
13. 通过对飞剪剪切长度,精度,剪刃间隙和压板机构等参数的优化,来提高钢板的剪切质量。wWW.wENTiYi.CoM
Optimizing the parameters of shearing lengths, shearing accuracy, blade clearance and pressure plate mechanism, so as to improve the shearing quality of steel plates.
14. 轴向磁力增加与增量磁性环形轴向长度和与轴向间隙,径向偏离中心或磁性环形的相对磁导率的增量减少。
The axial magnetic force increases with the increment of magnetic annular axial length and decreases with the increment of axial gap, radial off-centre or magnetic annular relative permeability.
15. 本发明将普通导磁体的头部设置成锥角形后,可缩短间隙的距离,延长铁芯有效使用的长度。
By arranging the head part of the common magnetizer to be in a taper Angle shape, the clearance distance can be shortened, and the effective use length of the iron core is extended.
16. 缓冲长度对系统动态特性的影响与缓冲间隙有关。
The cushion length"s influence on system"s dynamic characteristic is affected by the cushion clearance.
17. 本文对回热器的长度、水力半径或板叠间隙、回热器在驻波声场中的位置等回热器特性参数对其性能的影响进行了模拟分析,并在此基础上对回热器或板叠特性参数进行了优化。
In this paper we describe simulation analysis and optimization on the characteristic parameters of regenerator, such as the length, the spacing of plates, the position in sound field of regenerator.
18. 分析了铝合金厚壁支座的弯曲工艺,计算了弯曲件的展开长度、落料力、冲孔力及弯曲力,阐述了弯曲件的回弹因素及凸凹模之间的间隙,介绍铝合金厚壁支座弯曲模具的结构设计。
The bending technology of the thick-wall supprt of aluminum alloy was analyzed, and the flattening length of bending, blanking force, piercing force and bending force were calculated.
19. 研究的铁心片设计参数包括数量、长度、厚度、高度、间隙及内径等。
The AMF is studied with various design parameters of iron plates, such as quantities, length, thickness, distance between plates and inner diameters etc.
20. 在实验的基础上,研究了挤压油膜阻尼器的结构参数诸如偏心率、油膜的径向间隙比和承载长度等对气穴现象的影响。
The effects of structural parameters of Squeeze Film Damper (SFD), such as eccentricity, radial clearance and land length etc. on cavitation were investigated experimentally.
21. 以角膜顶点至黄斑中心凹距离作为视轴长度,此连线上测量硅油后间隙的厚度。
The length of the visual axis was the distance from the corneal vertex to the macular fovea, and it was also measured by A-mode ultrasound in sitting position with different ultrasonic velocity.
22. 间隙,表面,安装倒角,表面承受的长度,行程的长度,频率,速度等等。
Tolerances, gaps, surfaces, installation chamfers, length of bearing surface, length of stroke, frequency, speed, etc.
23. 最后,给出了由构件长度误差和转动副间隙引起的前后轮对转角耦合误差的总计算公式。
Finally, the equation calculating the error of the coupling Angle is presented in this paper.
24. 最后,给出了由构件长度误差和转动副间隙引起的前后轮对转角耦合误差的总计算公式。
Finally, the equation calculating the error of the coupling Angle is presented in this paper.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
