
词语导航
基本信息
词语:保持电压
繁体:保持電壓
拼音:bǎo chí diàn yā
英语翻译
【计】 keeper voltage
分词翻译
保持的英语翻译:
keep; hold; maintain; maintenance; preserve; remain; retain
【计】 retention
【医】 retention
【经】 hold; keep; keep up
电压的英语翻译:
tension; voltage
【化】 voltage
【医】 electric tension; voltage
翻译例句
1. 因此,该电容放电回线在努力保持电压下降值。
Therefore, the capacitor discharges back into the line in an effort to keep the voltage from decreasing in value.wWW.wENTIYI.cOm
2. 因此,电容器放电回线,以努力保持电压的降低中的值。
Therefore, the capacitor discharges back into the line in an effort to keep the voltage from decreasing in value.
3. 用调相设备调整无功功率,保持电压偏移在规定的范围内。
Applying the diagram, it is convenient to compute the reactive power necessary for keeping the voltage value constant.
4. 既要保持电压而在限制范围内的频率,需要良好的功率控制和负载调节。
To maintain both the voltage and the frequency within limits requires fine power control and load regulation.
5. 无功电压优化控制是减少电网损耗、保持电压稳定性、提高电力系统安全性和经济性的有效措施。
This dissertation discusses the voltage and reactive power optimization algorithm, the power network partitioning and its practicability and application scheme.
6. 无功电压优化控制是减少电网损耗、保持电压稳定性、提高电力系统安全性和经济性的有效措施。
Optimizing reactive power and voltage control in power system is an important and efficient method to improve the voltage quality and ensure the voltage stability.
7. 如今,有源滤波器,如并联、串联和串并联组合有源滤波器,被广泛研究,以保持电压和电流的平衡。
Nowadays, the active filters such as shunt, series and combined shunt-series are studied as a flexible solution to compensate all current and voltage perturbations.
8. 而使用电压脉冲来控制两个量位保持互扰和叠加状态的时间。
A voltage pulse is then applied to control how long the two qubits remain entangled and in their superpositional state.
9. 在汽车内部,电流激发一个感应线圈,感应线圈连接在一堆电容上面,电容可以保持流过的电流和电压稳定在适当的水平上。
Inside the car, electricity energizes an inductive coil attached to a bunch of capacitors that help keep the currents and voltages at the right levels.
10. 而高于114伏特的额外电压将保持在电线上面。
Any additional power above 114 volts stays on the electric line, he said.
11. 所以将器件的加热效应降到最低的一种方法是使用尽可能低的电流,而在被测器件上仍然保持希望的电压。
Thus, one way to minimize the effects of device heating is to use the lowest current possible while still maintaining the desired voltage across the device being tested.
12. 电化学测量的两个芯片的目的是,当第三保持恒定的电化学潜力时,能够确保年稳定的电压。
Two serve the purpose of electrochemical measurement while the third keeps the electrochemical potential constant end thus ensures a stable voltage.
13. 调节器的作用就是保证发电机在输出电能的电压能够保持恒定,保护设备安全运行。
The role of the regulator is to ensure that the generator output voltage to maintain a constant energy, protect the safe operation of equipment.
14. 电容器从放电电路断开以后,电容器中保持剩余的电荷,从而在电容器的端子之间重新建立起电压。
After a capacitor is disconnected from a discharge circuit, a residual charge remains on the capacitor, so a voltage is re-established across the capacitor terminals.
15. 而保护意味着使用保持在与高阻抗电路相同电位的附加的低阻抗导体来阻止可能的干扰电压或电流。
Guarding implies the use of an added low impedance conductor, maintained at the same potential as the high impedance circuit, which will intercept any interfering voltage or current.
16. 电源电压波动必须在允许范围内,并且保持相对稳定。
Power supply voltage fluctuations must be within the allowable range, and remain relatively stable.
17. 保持随动系统以最低电压转动,在000 ~ 360度范围内找出不灵点。
Keep follow system with minimum voltage rotation from 000 degree to 360 degrees. Find the insensitive point.
18. 再者,所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
19. 它是特别设计,在电压下降到0V时整个开关元件,同时保持良好的速度和导通电阻特性。
It is specifically designed to operate at voltages down to 0v across the switch elements while maintaining good speed and on-resistance characteristics.
20. 然而,这确实提供了保持每步电压变化在允许范围内的方法。
It does, however, provide a means of keeping the voltage change per step within per miscible limits.
21. 领先桥臂中点电压变换期间,变压器初级电流基本保持最大值,使得领先桥臂容易实现软开关;
In the midpoint voltage of leading leg transition, its soft switching is easily realized because of the primary current of transformer keeping the maximum.
22. 它进行,只要在交流电压保持在正方向和电流高于其保持电流电平。
It conducts as long as the AC voltage remains in positive direction and the current is above its holding current level.
23. 采样保持电路、电压源电路设计。
Sample and Hold, Voltage Reference Circuit design.
24. 为了确保磁保持继电器可靠动作,施加到线圈上的激励电压须达到额定值,且脉冲宽度设置须达到动作时间的3倍以上。
Ln order to ensure the reliability of relay coil voltage, must reaeh value, the pulse width must be 3 times more time.
25. 有源滤波器能否按其工作原理实现预期的谐波抑制效果,除了主电路设计合理之外,在很大程度上还依赖于保持直流侧电压的恒定。
Whether the hybrid active power filter could get desirable effects of harmonic suppression depends on the constancy of DC-side voltage besides the correct design of the main circuit.
26. 当轨道一段没被占据时,连接两个轨道的电源保持两边电压正常。
A power source connected to the two rails normally maintains a voltage between them while they are unoccupied.
27. 当轨道一段没被占据时,连接两个轨道的电源保持两边电压正常。
A power source connected to the two rails normally maintains a voltage between them while they are unoccupied.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
